Comment on "Far-field microscopy with a nanometer-scale resolution based on the in-plane image magnification by surface plasmon polaritons"

This is a small comment concerning the work by Smolyaninov et al. in Phys. Rev. Lett.94, 057401 (2005)

Бромирование высоко-деактивированных ароматических систем с применением тетрафторобромата бария

It has been shown that Ba(BrF[4])[2] acted as a highly-active brominating agent. In case of interaction with nitrobenzene, the pure 3-bromo-nitrobenzene is formed. It has been shown that typical electrophilic bromination of the aromatic compound with electron donating and electron-accepting substituents occurred without any catalysts or hard conditions

Non-adiabatic dynamics of two strongly coupled nanomechanical resonator modes

The Landau-Zener transition is a fundamental concept for dynamical quantum systems and has been studied in numerous fields of physics. Here we present a classical mechanical model system exhibiting analogous behaviour using two inversely tuneable, strongly coupled modes of the same nanomechanical beam resonator. In the adiabatic limit, the anticrossing between the two modes is observed and the coupling strength extracted. Sweeping an initialized mode across the coupling region allows mapping of the progression from diabatic to adiabatic transitions as a function of the sweep rate

Scattering of surface plasmon polaritons by one-dimensional inhomogeneities

The scattering of surface plasmons polaritons by a one-dimensional defect of the surface is theoretically studied, by means of both Rayleigh and modal expansions. The considered defects are either relief perturbations or variations in the permittivity of the metal. The dependence of transmission, reflection and out-of-plane scattering on parameters defining the defect is presented. We find that the radiated energy is forwardly directed (with respect to the surface plasmon propagation) in the case of an impedance defect. However, for relief defects, the radiated energy may be directed into backward or forward (or both) directions, depending on the defect width.Comment: 10 pages, 5 figures, corrected typos, some minor modifications in figures. Accepted in Phys. Rev.

Effect of anisotropy and destructuration on behavior of Haarajoki test embankment

This paper investigates the influence of anisotropy and destructuration on the behavior of Haarajoki test embankment, which was built by the Finnish National Road Administration as a noise barrier in 1997 on a soft clay deposit. Half of the embankment is constructed on an area improved with prefabricated vertical drains, while the other half is constructed on the natural deposit without any ground improvement. The construction and consolidation of the embankment is analyzed with the finite-element method using three different constitutive models to represent the soft clay. Two recently proposed constitutive models, namely S-CLAY1 which accounts for initial and plastic strain induced anisotropy, and its extension, called S-CLAY1S which accounts, additionally, for interparticle bonding and degradation of bonds, were used in the analysis. For comparison, the problem is also analyzed with the isotropic modified cam clay model. The results of the numerical analyses are compared with the field measurements. The simulations reveal the influence that anisotropy and destructuration have on the behavior of an embankment on soft clay

The Safe Removal of Frozen Air from the Annulus of an LH2 Storage Tank

Large Liquid Hydrogen (LH2) storage tanks are vital infrastructure for NASA. Eventually, air may leak into the evacuated and perlite filled annular region of these tanks. Although the vacuum level is monitored in this region, the extremely cold temperature causes all but the helium and neon constituents of air to freeze. A small, often unnoticeable pressure rise is the result. As the leak persists, the quantity of frozen air increases, as does the thermal conductivity of the insulation system. Consequently, a notable increase in commodity boil-off is often the first indicator of an air leak. Severe damage can result from normal draining of the tank. The warming air will sublimate which will cause a pressure rise in the annulus. When the pressure increases above the triple point, the frozen air will begin to melt and migrate downward. Collection of liquid air on the carbon steel outer shell may chill it below its ductility range, resulting in fracture. In order to avoid a structural failure, as described above, a method for the safe removal of frozen air is needed. A thermal model of the storage tank has been created using SINDA/FLUINT modeling software. Experimental work is progressing in an attempt to characterize the thermal conductivity of a perlite/frozen nitrogen mixture. A statistical mechanics model is being developed in parallel for comparison to experimental work. The thermal model will be updated using the experimental/statistical mechanical data, and used to simulate potential removal scenarios. This paper will address methodologies and analysis techniques for evaluation of two proposed air removal methods

Generating multimedia presentations: from plain text to screenplay

In many Natural Language Generation (NLG) applications, the output is limited to plain text – i.e., a string of words with punctuation and paragraph breaks, but no indications for layout, or pictures, or dialogue. In several projects, we have begun to explore NLG applications in which these extra media are brought into play. This paper gives an informal account of what we have learned. For coherence, we focus on the domain of patient information leaflets, and follow an example in which the same content is expressed first in plain text, then in formatted text, then in text with pictures, and finally in a dialogue script that can be performed by two animated agents. We show how the same meaning can be mapped to realisation patterns in different media, and how the expanded options for expressing meaning are related to the perceived style and tone of the presentation. Throughout, we stress that the extra media are not simple added to plain text, but integrated with it: thus the use of formatting, or pictures, or dialogue, may require radical rewording of the text itself