17,997 research outputs found
QCD Sum Rule for S_{11}(1535)
We propose a new interpolating field for S(1535) to determine its mass
from QCD sum rules. In the nonrelativistic limit, this interpolating field
dominantly reduces to two quarks in the s-wave state and one quark in the
p-wave state. An optimization procedure, which makes use of a duality relation,
yields the interpolating field which overlaps strongly with the negative-parity
baryon and at the same time does not couple at all to the low lying
positive-parity baryon. Using this interpolating field and applying the
conventional QCD sum rule analysis, we find that the mass of S is
reasonably close to the experimentally known value, even though the precise
determination depends on the poorly known quark-gluon condensate. Hence our
interpolating field can be used to investigate the spectral properties of
S(1535).Comment: 12 pages, Revtex, 1 ps figure available from author
QCD sum rules for the anti-charmed pentaquark
We present a QCD sum rule analysis for the anti-charmed pentaquark state with
and without strangeness. While the sum rules for most of the currents are
either non-convergent or dominated by the continuum, the one for the
non-strange pentaquark current composed of two diquarks and an antiquark, is
convergent and has a structure consistent with a positive parity pentaquark
state after subtracting out the continuum contribution. Arguments are
presented on the similarity between the result of the present analysis and that
based on the constituent quark models, which predict a more stable pentaquark
states when the antiquark is heavy.Comment: 19 pages, 8 figures, REVTex, revised version,new figures added and
references update
Direct observation of the spin polarization in Au atomic wires on Si(553)
The spin-resolved electronic band structure of Au-induced metallic atomic wires on a vicinal silicon surface, Si(553), was investigated using spin-and angle-resolved photoelectron spectroscopy. We directly measured the spin polarization of three partially filled one-dimensional metallic bands, a one-third-filled band, and the doublet of nearly half-filled bands. For the half-filled doublet, the strong apparent spin polarization was observed near the Fermi energy with a minor out-of-plane spin component. This observation is consistent with the Rashba-type spin-orbit splitting and with a recent experiment on a similar doublet of Si(557)-Au. In contrast, the one-third-filled band does not show a substantial spin polarization within the experimental accuracy, indicating a much smaller spin splitting, if any. These results are discussed for the origin of the partially filled bands and for the intriguing broken-symmetry ground state observed at low temperature.X11116sciescopu
Molecular characterization of the Tobacco rattle virus RNA2 genome isolated from Gladiolus
Tobacco rattle virus (TRV-K) was first identified in a symptomatic Gladiolus plant cultivated in Korea. We analyzed the TRV-K genome and compared its phylogeny with other TRV isolates. After constructing of a full-length genomic RNA2 strand clone, a complete sequence was generated from several overlapping clones. The cloned genome was 3261 bases in length, identical to TRV-K, and had three open reading frames. TRV-K had the highest sequence identity with the American isolate TRV-ORY. Sequence analysis of the RNA2 genome showed that TRV-K contains an intact 2a, 2b, and 2c coding sequence and an RNA1-related 3′ terminus, which is typical of TRV RNA2. Phylogenetic analysis revealed that TRV-K is in the same cluster as the American isolates and another Korean isolate, TRV-SK; however, it was in a different cluster than the European isolates
Nearly Massless Electrons in the Silicon Interface with a Metal Film
We demonstrate the realization of nearly massless electrons in the most
widely used device material, silicon, at the interface with a metal film. Using
angle-resolved photoemission, we found that the surface band of a monolayer
lead film drives a hole band of the Si inversion layer formed at the interface
with the film to have nearly linear dispersion with an effective mass about 20
times lighter than bulk Si and comparable to graphene. The reduction of mass
can be accounted for by repulsive interaction between neighboring bands of the
metal film and Si substrate. Our result suggests a promising way to take
advantage of massless carriers in silicon-based thin-film devices, which can
also be applied for various other semiconductor devices.Comment: 4 pages, 4 figures, accepted for publication in Physical Review
Letter
Forty-Four Pass Fibre Optic Loop for Improving the Sensitivity of Surface Plasmon Resonance Sensors
A forty-four pass fibre optic surface plasmon resonance sensor that enhances
detection sensitivity according to the number of passes is demonstrated for the
first time. The technique employs a fibre optic recirculation loop that passes
the detection spot forty- four times, thus enhancing sensitivity by a factor of
forty-four. Presently, the total number of passes is limited by the onset of
lasing action of the recirculation loop. This technique offers a significant
sensitivity improvement for various types of plasmon resonance sensors that may
be used in chemical and biomolecule detections.Comment: Submitted for publication; patent disclosure submitte
Quantum linear amplifier enhanced by photon subtraction and addition
A deterministic quantum amplifier inevitably adds noise to an amplified
signal due to the uncertainty principle in quantum physics. We here investigate
how a quantum-noise-limited amplifier can be improved by additionally employing
the photon subtraction, the photon addition, and a coherent superposition of
the two, thereby making a probabilistic, heralded, quantum amplifier. We show
that these operations can enhance the performance in amplifying a coherent
state in terms of intensity gain, fidelity, and phase uncertainty. In
particular, the photon subtraction turns out to be optimal for the fidelity and
the phase concentration among these elementary operations, while the photon
addition also provides a significant reduction in the phase uncertainty with
the largest gain effect.Comment: published version, 7 pages, 9 figure
Post-Stenotic Recirculating Flow May Cause Hemodynamic Perforator Infarction
Background and Purpose The primary mechanism underlying paramedian pontine infarction (PPI) is atheroma obliterating the perforators. Here, we encountered a patient with PPI in the post-stenotic area of basilar artery (BA) without a plaque, shown, by high-resolution magnetic resonance imaging (HR-MRI). We performed an experiment using a 3D-printed BA model and a particle image velocimetry (PIV) to explore the hemodynamic property of the post-stenotic area and the mechanism of PPI. Methods 3D-model of a BA stenosis was reconstructed with silicone compound using a 3D printer based on the source image of HR-MRI. Working fluid seeded with fluorescence particles was used and the velocity of those particles was measured horizontally and vertically. Furthermore, microtubules were inserted into the posterior aspect of the model to measure the flow rates of perforators (pre- and post-stenotic areas). The flow rates were compared between the microtubules. Results A recirculating flow was observed from the post-stenotic area in both directions forming a spiral shape. The velocity of the flow in these regions of recirculation was about one-tenth that of the flow in other regions. The location of recirculating flow well corresponded with the area with low-signal intensity at the time-of-flight magnetic resonance angiography and the location of PPI. Finally, the flow rate through the microtubule inserted into the post-stenotic area was significantly decreased comparing to others (P<0.001). Conclusions Perforator infarction may be caused by a hemodynamic mechanism altered by stenosis that induces a recirculation flow. 3D-printed modeling and PIV are helpful understanding the hemodynamics of intracranial stenosis.114Ysciescopu
Observation of room-temperature ferroelectricity in tetragonal strontium titanate thin films on SrTiO3 (001) substrates
We investigated the ferroelectric properties of strontium titanate (STO) thin
films deposited on SrTiO3 (001) substrate with SrRuO3 electrodes. The STO layer
was grown coherently on the SrTiO3 substrate without in-plane lattice
relaxation, but its out-of-plane lattice constant increased with a decrease in
the oxygen pressure during deposition. Using piezoresponse force microscopy and
P-V measurements, we showed that our tetragonal STO films possess
room-temperature ferroelectricity. We discuss the possible origins of the
observed ferroelectricity
Method of fabricating multiwavelength infrared focal plane array detector
A multiwavelength local plane array infrared detector is included on a common substrate having formed on its top face a plurality of In.sub.x Ga.sub.1-x As (x.ltoreq.0.53) absorption layers, between each pair of which a plurality of InAs.sub.y P.sub.1-y (y.ltoreq.1) buffer layers are formed having substantially increasing lattice parameters, respectively, relative to said substrate, for preventing lattice mismatch dislocations from propagating through successive ones of the absorption layers of decreasing bandgap relative to said substrate, whereby a plurality of detectors for detecting different wavelengths of light for a given pixel are provided by removing material above given areas of successive ones of the absorption layers, which areas are doped to form a pn junction with the surrounding unexposed portions of associated absorption layers, respectively, with metal contacts being formed on a portion of each of the exposed areas, and on the bottom of the substrate for facilitating electrical connections thereto
- …