A Systematic Electromagnetic-Circuit Method for EMI Analysis of Coupled Interconnects on Dispersive Dielectrics

published_or_final_versio

Treatment of DomesticWastewaterwith Simultaneous Electricity Generation in Microbial Fuel Cell under Continuous Operation

In order to apply microbial fuel cell (MFC) process more practically in wastewater treatment, both power generation and removal of chemical oxygen demand (COD) were examined in an air-cathode MFC fed with domestic wastewater under continuous operation. At a hydraulic retention time (HRT) of 2.0 h, the air-cathode MFC was able to generate electricity from domestic wastewater with a maximum power density of P = 103 2 mWm–2 (5772 mW m–3) and an average Coulomb efficiency (CE) of 18.4%; meanwhile, to achieve an average COD removal up to 71 %. Increasing HRT from 2h to 10–30 h was found to be more effective for COD removal, however, instability in voltage output was also observed. An increased power generation of 1734mW m–2 (9648 mW m–3) was obtained with the aid of NaCl addition at a mass fraction of w = 2.4 %, because of an elevated conductivity of the solution with accord internal resistance of 227 0

Coupled Effects of Strain Rate and Temperature on Deformation Twinning in Cu-Zn Alloy

Cu-Zn alloy is an advanced material, but its deformation twinning mechanism still keeps unknown so far, especially the couple effects of temperature and strain rate. In this paper, a theoretical model of Cu-Zn alloy is proposed by considering the coupled effects of strain rate and temperature. The model can predict the experimentally observed tendency of the spacing evolution of twin boundary (TB) accurately, and it is known that low temperature and high strain rate will promote deformation twinning. Moreover, deformation twining is more susceptible to low temperature than to high strain rate, and TB spacing and twin layer thickness will decrease with high strain rate and low temperature

Comparison of urinary aflatoxin M1 and aflatoxin albumin adducts as biomarkers for assessing aflatoxin exposure in Tanzanian children

Purpose: To determine levels of urinary aflatoxin M1 (AFM1) in children and correlate the concentrations with previously reported aflatoxin albumin adduct (AF-alb) levels in these children. Materials and methods: Matched urine and blood samples were collected from 84 Tanzanian children aged 6–14 months old. From 31 children in one village (Kigwa), samples were collected at three time points six months apart. Samples were collected from 31 and 22 children from two different regions at the second time point only. Urinary AFM1 was measured using a commercial enzyme-linked immunosorbent assay (ELISA) kit with a modified protocol to improve sensitivity. AF-alb was measured using an established ELISA method. Results: The relative ranking of the three villages for exposure to aflatoxin based on either AFM1 or AF-alb biomarker measurements was the same. In Kigwa village, both AFM1 and AF-alb levels were higher at six months post-harvest compared to baseline. However, at the next visit, the AFM1 levels dropped from a GM (interquartile range) of 71.0 (44.7, 112.6) at visit two to 49.3 (31.5, 77.3) pg/ml urine, whereas AF-alb levels increased from 47.3 (29.7, 75.2) to 52.7 (35.4, 78.3) pg/mg albumin between these two visits, reflecting the fact that AFM1 measures short-term exposure, whereas AF-alb measures longer term exposure. There was a correlation between AFB1 intake and AFM1 excretion (r= 0.442, p ≤ 0.001). Conclusions: Urinary AFM1 is a good biomarker for AFB1 exposure in Tanzanian children, reflecting geographical and temporal variations in exposure to this foodborne toxin

Dipolar interactions and anisotropic magnetoresistance in metallic granular systems

We revisit the theory of magnetoresistance for a system of nanoscopic magnetic granules in metallic matrix. Using a simple model for the spin dependent perturbation potential of the granules, we solve Boltzmann equation for the spin dependent components of the non equilibrium electronic distribution function. For typical values of the geometric parameters in granular systems, we find a peculiar structure of the distribution function of conduction electrons, which is at variance with the two-current model of conduction in inhomogeneous systems. Our treatment explicitly includes the effects of dipolar correlations yielding a magnetoresistance ratio which contains, in addition to the term proportional to the square of uniform magnetization (), a weak anisotropic contribution depending on the angle between electric and magnetic fields, and arising from the anisotropic character of dipolar interactions.Comment: 9 pages, 2 figures, accepted in PR

Existence and uniqueness of solutions for systems of fractional differential equations with Riemann–Stieltjes integral boundary condition

In this article, we first establish an existence and uniqueness result for a class of systems of nonlinear operator equations under more general conditions by means of the cone theory and monotone iterative technique. Furthermore, the iterative sequence of the solution and the error estimation of the system are given. Then we use this new result to study the existence and uniqueness of the solution for boundary value problems of systems of fractional differential equations with a Riemann–Stieltjes integral boundary condition in real Banach spaces. The results obtained in this paper are more general than many previous results and complement them