Plasma-Enhanced ALD of TiO2 Thin Films on SUS 304 Stainless Steel for Photocatalytic Application

Plasma-enhanced atomic layer deposition (PE-ALD) of TiO2 thin films using Ti(NMe2)(4) [tetrakis(dimethylamido) Ti] and O-2 plasma were prepared on stainless steel to show the self-cleaning effect. The TiO2 thin films deposited on stainless steel have high growth rate, large surface roughness, and low impurities. The film deposited below 200 degrees C was amorphous, while the films deposited at 300 and 400 degrees C showed anatase and rutile phases, respectively. The contact angle measurements on crystalline PE-ALD TiO2 thin films exhibited superhydrophilicity after UV irradiation. The TiO2 thin film with anatase phase deposited at 300 degrees C showed the highest photocatalytic efficiency, which is higher than on Activ glass or thermal ALD TiO2 films. We suggest that anatase structure and large surface area of TiO2 thin film on stainless steel are the main factors for the high photocatalytic efficiency. (C) 2009 The Electrochemical Society. [DOI: 10.1149/1.3095515] All rights reserved.X117sciescopu

Effects of phosphate and hydrogen peroxide on the performance of a biological activated carbon filter for enhanced biofiltration

Biofilm formation on biofilters can influence their hydraulic performance, thereby leading to head loss and an increase in energy use and costs for water utilities. The effects of a range of factors, including hydrogen peroxide and phosphate, on the performance of biological activated carbon (BAC) and biofilm formation were investigated using laboratory-scale columns. Head loss, total carbohydrates, and proteins were reduced in the nutrient-enhanced, oxidant-enhanced, and nutrient + oxidant-enhanced BAC filters. However, there were no changes in the removal of dissolved organic matter, trihalomethane formation potential, or selected trace organic contaminants. The biofilm formation on polyvinyl chloride and stainless steel coupons using the laboratory biofilm reactor system was lower when the effluent from a nutrient-enhanced column was used, which indicated that there was less biofilm formation in the distribution systems. This may have been because the effluent from the nutrient-enhanced column was more biologically stable. Therefore, enhanced biofiltration could be used not only to reduce head loss in biofilters, but also to delay biofilm formation in distribution systems

Coronary Atherosclerosis Phenotypes in Focal and Diffuse Disease.

The interplay between coronary hemodynamics and plaque characteristics remains poorly understood. The aim of this study was to compare atherosclerotic plaque phenotypes between focal and diffuse coronary artery disease (CAD) defined by coronary hemodynamics. This multicenter, prospective, single-arm study was conducted in 5 countries. Patients with functionally significant lesions based on an invasive fractional flow reserve ≤0.80 were included. Plaque analysis was performed by using coronary computed tomography angiography and optical coherence tomography. CAD patterns were assessed using motorized fractional flow reserve pullbacks and quantified by pullback pressure gradient (PPG). Focal and diffuse CAD was defined according to the median PPG value. A total of 117 patients (120 vessels) were included. The median PPG was 0.66 (IQR: 0.54-0.75). According to coronary computed tomography angiography analysis, plaque burden was higher in patients with focal CAD (87% ± 8% focal vs 82% ± 10% diffuse; P = 0.003). Calcifications were significantly more prevalent in patients with diffuse CAD (Agatston score per vessel: 51 [IQR: 11-204] focal vs 158 [IQR: 52-341] diffuse; P = 0.024). According to optical coherence tomography analysis, patients with focal CAD had a significantly higher prevalence of circumferential lipid-rich plaque (37% focal vs 4% diffuse; P = 0.001) and thin-cap fibroatheroma (TCFA) (47% focal vs 10% diffuse; P = 0.002). Focal disease defined by PPG predicted the presence of TCFA with an area under the curve of 0.73 (95% CI: 0.58-0.87). Atherosclerotic plaque phenotypes associate with intracoronary hemodynamics. Focal CAD had a higher plaque burden and was predominantly lipid-rich with a high prevalence of TCFA, whereas calcifications were more prevalent in diffuse CAD. (Precise Percutaneous Coronary Intervention Plan [P3]; NCT03782688)

Layered Fibrotic Plaques Are the Predominant Component in Cardiac Allograft Vasculopathy Systematic Findings and Risk Stratification by OCT

Cardiovascular Aspects of Radiolog

Observation of Mott Transition in VO_2 Based Transistors

An abrupt Mott metal-insulator transition (MIT) rather than the continuous Hubbard MIT near a critical on-site Coulomb energy U/U_c=1 is observed for the first time in VO_2, a strongly correlated material, by inducing holes of about 0.018% into the conduction band. As a result, a discontinuous jump of the density of states on the Fermi surface is observed and inhomogeneity inevitably occurs. The gate effect in fabricated transistors is clear evidence that the abrupt MIT is induced by the excitation of holes.Comment: 4 pages, 4 figure

Pharmacokinetic study of meropenem in healthy beagle dogs receiving intermittent hemodialysis

Meropenem, a second carbapenem antimicrobial agent with a broad spectrum of activity, is used to treat sepsis and resistant-bacterial infections in veterinary medicine. The objective of this study was to identify the pharmacokinetics of meropenem in dogs receiving intermittent hemodialysis (IHD) and to determine the proper dosing in renal failure patients receiving IHD. Five healthy beagle dogs were given a single i.v. dose of 24 mg/kg of meropenem and received IHD. The blood flow rate, dialysate flow, and ultrafiltration rate were maintained at 40 mL/min, 300 mL/min, and 40 mL/h, respectively. Blood samples were collected for 24 h from the jugular vein and from the extracorporeal arterial and venous line. Urine samples and dialysate were also collected. The concentrations of meropenem were assayed using HPLC/MS/MS determination. The peak plasma concentration was 116 +/- 37 mu g/mL at 15 min. The systemic clearance was 347 +/- 117 mL/h/kg, and the steady-state volume of distribution was 223 +/- 67 mL/kg. Dialysis clearance was 71.1 +/- 34.3 mL/h/kg, and the extraction ratio by hemodialysis was 0.455 +/- 0.150. The half-life (T-1/2) in dogs with IHD decreased compared with those without IHD, and the reduction in T1/2 was greater in renal failure patients than in normal patients. Sixty-nine percent and 21% of the administered drug were recovered by urine and dialysate in the unchanged form, respectively. In conclusion, additional dosing of 24 mg/kg of meropenem after dialysis could be necessary according to the residual renal function of the patient based on the simulated data.OAIID:RECH_ACHV_DSTSH_NO:T201621129RECH_ACHV_FG:RR00200001ADJUST_YN:EMP_ID:A003050CITE_RATE:1.279FILENAME:Byun_et_al-2016-Journal_of_Veterinary_Pharmacology_and_Therapeutics.pdfDEPT_NM:수의학과EMAIL:[email protected]_YN:YFILEURL:https://srnd.snu.ac.kr/eXrepEIR/fws/file/eb2b2d93-6cb2-4420-a374-90eb43215957/linkCONFIRM:

Impact of acute coronary syndrome on clinical outcomes after revascularization with the dual-therapy CD34 antibody-covered sirolimus-eluting Combo stent and the sirolimus-eluting Orsiro stent

OBJECTIVES: To compare the efficacy and safety of the dual-therapy CD34 antibody-covered sirolimus-eluting Combo stent (DTS) and the sirolimus-eluting Orsiro stent (O-SES) in patients with and without acute coronary syndrome (ACS) included in the SORT OUT X study.BACKGROUND: The incidence of target lesion failure (TLF) after treatment with modern drug-eluting stents has been reported to be significantly higher in patients with ACS when compared to patients without ACS. Whether the results from the SORT OUT X study apply to patients with and without ACS remains unknown.METHODS: In total, 3146 patients were randomized to stent implantation with DTS (n = 1578; ACS: n = 856) or O-SES (n = 1568; ACS: n = 854). The primary end point, TLF, was a composite of cardiac death, target-lesion myocardial infarction (MI), or target lesion revascularization (TLR) within 1 year.RESULTS: At 1 year, the rate of TLF was higher in the DTS group compared to the O-SES group, both among patients with ACS (6.7% vs. 4.1%; incidence rate ratio: 1.65 [95% confidence interval, CI: 1.08-2.52]) and without ACS (6.0% vs. 3.2%; incidence rate ratio: 1.88 [95% CI: 1.13-3.14]). The differences were mainly explained by higher rates of TLR, whereas rates of cardiac death and target lesion MI did not differ significantly between the two stent groups in patients with or without ACS CONCLUSION: Compared to the O-SES, the DTS was associated with a higher risk of TLF at 12 months in patients with and without ACS. The differences were mainly explained by higher rates of TLR.</p

Laser treatment of Ag@ZnO nanorods as long-life-span SERS surfaces.

This is the accepted manuscript. The final version is available from ACS at http://pubs.acs.org/doi/abs/10.1021/am506622x.UV nanosecond laser pulses have been used to produce a unique surface nanostructuration of Ag@ZnO supported nanorods (NRs). The NRs were fabricated by plasma enhanced chemical vapor deposition (PECVD) at low temperature applying a silver layer as promoter. The irradiation of these structures with single nanosecond pulses of an ArF laser produces the melting and reshaping of the end of the NRs that aggregate in the form of bundles terminated by melted ZnO spherical particles. Well-defined silver nanoparticles (NPs), formed by phase separation at the surface of these melted ZnO particles, give rise to a broad plasmonic response consistent with their anisotropic shape. Surface enhanced Raman scattering (SERS) in the as-prepared Ag@ZnO NRs arrays was proved by using a Rhodamine 6G (Rh6G) chromophore as standard analyte. The surface modifications induced by laser treatment improve the stability of this system as SERS substrate while preserving its activity.We thank the Junta de Andalucía (TEP8067, FQM-6900 and P12-FQM-2265) and the Spanish Ministry of Economy and Competitiveness (Projects CONSOLIDER-CSD 2008-00023, MAT2011-28345-C02-02, MAT2013-40852-R, MAT2013-42900-P and RECUPERA 2020) for financial support. The authors also thank the European Union Seventh Framework Programme under Grant Agreements 312483-ESTEEM2 (Integrated Infrastructure Initiative-I3) and REGPOT-CT-2011-285895-Al-NANOFUNC, and the European Research Council under the European Union’s Seventh Framework Programme (FP/2007-2013)/ERC grant agreement 291522 - 3DIMAGE. R. J. Peláez acknowledges the grant JCI-2012_13034 from the Juan de la Cierva program