Radiographic detectability limits for seeded voids in sintered silicon carbide and silicon nitride

Conventional and microfocus X-radiographic techniques were compared to determine relative detectability limits for voids in green and sintered SiC and Si3N4. The relative sensitivity of the techniques was evaluated by comparing their ability to detect voids that were artificially introduced by a seeding process. For projection microfocus radiography the sensitivity of void detection at a 90/95 probability of detection/confidence level is 1.5% of specimen thickness in sintered SiC and Si3N4. For conventional contact radiography the sensitivity is 2.5% of specimen thickness. It appears that microfocus projection radiography is preferable to conventional contact radiography in cases where increased sensitivity is required and where the additional complexity of the technique can be tolerated

Particle size reduction of Si3N4 with Si3N4 milling hardware

The grinding of Si3N4 powder using reaction bonded Si3N4 attrition, vibratory, and ball mills with Si3N4 media was examined. The rate of particle size reduction and the change in the chemical composition of the powder were determined in order to compare the grinding efficiency and the increase in impurity content resulting from mill and media wear for each technique. Attrition and vibratory milling exhibited rates of specific surface area increase that were approximately eight times that observed in ball milling. Vibratory milling introduced the greatest impurity pickup

Parametric evaluation of ball milling of SiC in water

A statistically designed experiment was conducted to determine optimum conditions for ball milling alpha-SiC in water. The influence of pH adjustment, volume percent solids loading, and mill rotational speed on grinding effectiveness was examined. An equation defining the effect of those milling variables on specific surface area was obtained. The volume percent solids loading of the slurry had the greatest influence on the grinding effectiveness in terms of increase in specific surface area. As grinding effectiveness improved, mill and media wear also increased. Contamination was minimized by use of sintered alpha-SiC milling hardware

Reliability of void detection in structural ceramics using scanning laser acoustic microscopy

The reliability of scanning laser acoustic microscopy (SLAM) for detecting surface voids in structural ceramic test specimens was statistically evaluated. Specimens of sintered silicon nitride and sintered silicon carbide, seeded with surface voids, were examined by SLAM at an ultrasonic frequency of 100 MHz in the as fired condition and after surface polishing. It was observed that polishing substantially increased void detectability. Voids as small as 100 micrometers in diameter were detected in polished specimens with 0.90 probability at a 0.95 confidence level. In addition, inspection times were reduced up to a factor of 10 after polishing. The applicability of the SLAM technique for detection of naturally occurring flaws of similar dimensions to the seeded voids is discussed. A FORTRAN program listing is given for calculating and plotting flaw detection statistics

Crystallization and characterization of Y2O3-SiO2 glasses

Glasses in the yttria-silica system with 20 to 40 mol pct Y2O3 were subjected to recrystallization studies after melting at 1900 to 2100 C in W crucibles in 1 and 50 atm N2. The TEM and XRD results obtained indicate the presence of the delta, gamma, gamma prime, and beta-Y2Si2O7 crystalline phases, depending on melting and quenching conditions. Heat treatment in air at 1100 to 1600 C increased the amount of crystallization, and led to the formation of Y2SiO5, cristabalite, and polymorphs of Y2Si2O7. Also investigated were the effects of 5 and 10 wt pct zirconia additions

Building Community in the Asynchronous Environment; Perspectives Across the Campus

Technology and circumstances have opened doors to online education, and there are many reasons why students opt for online education. While online education offers the comfort of convenience, it also brings in several concerns of feeling alone, sitting in front of a device, and attempting to complete coursework with little support synchronously. Throughout this interactive session, you will have the opportunity to hear from different perspectives on how we have brought the classroom to the living room by enhancing our online offerings while building a sense of community

Prolonged Dyspnea after Interscalene Block: Attributed to Undiagnosed Addison's Disease and Myasthenia Gravis

This report describes a patient who had a series of daily interscalene nerve blocks to treat pain following a shoulder manipulation for postsurgical stiffness. She experienced acute respiratory compromise that persisted for many weeks. All typical and unusual causes of these symptoms were ruled out. Her treating pulmonologist theorized that the ipsilateral carotid body had been injured. However, it was subsequently determined that the constellation of symptoms and their prolonged duration were best explained by a poor stress response from Addison's disease coupled with exacerbation of early onset myasthenia gravis. This patient's case is not a typical reaction to interscalene nerve blocks, and thus preoperative testing would not be recommended for myasthenia gravis or Addison's disease without underlying suspicion. We describe this report to inform physicians to consider a workup for these diagnoses if a typical workup rules out all usual causes of complications from an interscalene block

Rethinking Special Education Teacher Preparation for a Post-Pandemic World

The pivot to remote teaching was a wake-up call for institutions of higher education (IHE) teacher preparation programs. This discussion will share solutions and tips for successfully building capacity in a new teacher preparation era. Many IHEs problem-solved, resulting in a myriad of solutions to keep their teacher preparation programs running and relevant during the pivot to remote teaching and learning. This presentation discussion will assist in uncovering a list of teacher preparation program practices that evolved out of the Covid-19 pandemic that seeks to increase the number of pre-service teacher candidates enrolled in IHE teacher preparation programs. The presenters also argue a collaborative, curated post-pandemic pedagogical solution will improve outcomes for teacher preparation candidates and, in turn, advance the positive results for their future students in a post-pandemic world

Relation of Fertility to Selected Socio-Economic Factors

Sociolog

Function of mammalian M-cones depends on the level of CRALBP in Müller cells

Cone photoreceptors mediate daytime vision in vertebrates. The rapid and efficient regeneration of their visual pigments following photoactivation is critical for the cones to remain photoresponsive in bright and rapidly changing light conditions. Cone pigment regeneration depends on the recycling of visual chromophore, which takes place via the canonical visual cycle in the retinal pigment epithelium (RPE) and the Müller cell-driven intraretinal visual cycle. The molecular mechanisms that enable the neural retina to regenerate visual chromophore for cones have not been fully elucidated. However, one known component of the two visual cycles is the cellular retinaldehyde-binding protein (CRALBP), which is expressed both in the RPE and in Müller cells. To understand the significance of CRALBP in cone pigment regeneration, we examined the function of cones in mice heterozygous for Rlbp1, the gene encoding CRALBP. We found that CRALBP expression was reduced by ∼50% in both the RPE and retina of Rlbp1+/- mice. Electroretinography (ERG) showed that the dark adaptation of rods and cones is unaltered in Rlbp1+/- mice, indicating a normal RPE visual cycle. However, pharmacologic blockade of the RPE visual cycle revealed suppressed cone dark adaptation in Rlbp1+/- mice in comparison with controls. We conclude that the expression level of CRALPB specifically in the Müller cells modulates the efficiency of the retina visual cycle. Finally, blocking the RPE visual cycle also suppressed further cone dark adaptation in Rlbp1-/- mice, revealing a shunt in the classical RPE visual cycle that bypasses CRALBP and allows partial but unexpectedly rapid cone dark adaptation