Brewster quasi bound states in the continuum in all-dielectric metasurfaces from single magnetic-dipole resonance meta-atoms

Bound states in the continuum (BICs) are ubiquitous in many areas of physics, attracting especial interest for their ability to confine waves with infinite lifetimes. Metasurfaces provide a suitable platform to realize them in photonics; such BICs are remarkably robust, being however complex to tune in frequency-wavevector space.Here we propose a scheme to engineer BICs and quasi-BICs with single magnetic-dipole resonance meta-atoms. Upon changing the orientation of the magnetic-dipole resonances, we show that the resulting quasi-BICs,emerging from the symmetry-protected BIC at normal incidence, become transparent for plane-wave illumination exactly at the magnetic-dipole angle, due to a Brewster-like effect. While yielding infinite Q-factors at normalincidence(canonical BIC), these are termed Brewster quasi-BICs since a transmission channel is always allowed that slightly widens resonances at oblique incidences. This is demonstrated experimentally through reflectance measurements in the microwave regime with high-refractive-index mm-disk metasurfaces. Such Brewster-inspired configuration is a plausible scenario to achieve quasi-BICs throughout the electromagnetic spectrum inaccessible through plane-wave illumination at given angles, which could be extrapolated to other kind of waves.Comment: 15 pages, 7 figures; typos corrected, Figs. 3 & 5 modified, new Fig. 7 & references adde

Reduction of the model noise in non-linear reconstruction via an efficient calculation of the incident field: application to a 434 MHz Scanner

Microwave tomography has been drastically boosted by the development of efficient reconstruction algorithms based on an iterative solution of the corresponding non-linear inverse problem. The accuracy of the electric field radiated by the antennas of a microwave scanner, inside the target area, has been shown to play a significant role on the overall image quality. Taking into account the antenna environment is of prime importance, especially when operating at low frequency. For instance, the wall of a 60 cm diameter whole-body microwave scanner cannot be neglected at 434 MHz, even when using the immersion technique consisting of putting the target in water. Indeed, at such a frequency, the attenuation introduced by water is not sufficient to avoid multiple reflections on the scanner boundary walls. Consequently, the method of calculating the incident field constitutes a key factor in iteratively solving non-linear inverse problems. The selected technique must accommodate high accuracy while maintaining acceptable calculation complexity. In this paper, three distinct techniques are analysed. They are based on the use of i) free-space and ii) non free-space Green's function, and iii) a FDTD approach. All these techniques have been firstly investigated for their 2D version, being used in 2D reconstruction algorithms. However, the scattered field data are collected in a 3D scanner. For assessing the validity of the previous 2D techniques, their results have been compared to both experimentally and 3D-FDTD results.Peer ReviewedPostprint (published version

Microwave imaging techniques for biomedical applications

Microwaves have been considered for medical applications involving the detection of organ movements and changes in tissue water content. More particularly cardiopulmonary interrogation via microwaves has resulted in various sensors monitoring ventricular volume change or movement, arterial wall motion, respiratory movements, pulmonary oedema, etc. In all these applications, microwave sensors perform local measurements and need to be displaced for obtaining an image reproducing the spatial variations of a given quantity. Recently, advances in the area of inverse scattering theory and microwave technology have made possible the development of microwave imaging and tomographic instruments. This paper provides a review of such equipment developed at Suplec and UPC Barcelona, within the frame of successive French-Spanish PICASSO cooperation programs. It reports the most significant results and gives some perspectives for future developments. Firstly, a brief historical survey is given. Then, both technological and numerical aspects are considered. The results of preliminary pre-clinical assessments and in-lab experiments allow to illustrate the capabilities of the existing equipment, as well as its difficulty in dealing with clinical situations. Finally, some remarks on the expected development of microwave imaging techniques for biomedical applications are given.Peer ReviewedPostprint (published version

Small dielectric spheres with high Refractive index as new multifunctional elements for optical devices

The future of ultra-fast optical communication systems is inevitably connected with progress in optical circuits and nanoantennas. One of the key points of this progress is the creation of elementary components of optical devices with scattering diagrams tailored for redirecting the incident light in a desired manner. Here we demonstrate theoretically and experimentally that a small, simple, spatially homogeneous dielectric subwavelength sphere with a high refractive index and low losses (as some semiconductors in the visible or near infrared region) exhibits properties allowing to utilize it as a new multifunctional element for the mentioned devices. This can be achieved by taking advantage of the coherent effects between dipolar and multipolar modes, which produce anomalous scattering effects. The effects open a new way to control the directionality of the scattered light. The directional tuning can be obtained in a practical way just by a change in the frequency of the incident wave, and/or by a well-chosen diameter of the sphere. Dielectric nanoparticles with the required optical properties in the VIS-NIR may be now readily fabricated. These particles could be an efficient alternative to the widely discussed scattering units with a more complicated design.This research was partly supported by MICINN (Spanish Ministry of Science and Innovation) through project FIS2013-45854-P and by the Ministry of Education and Science of Russian Federation through grant 14.Z50.31.0034

Silicon Mie Resonators for Highly Directional Light Emission from monolayer MoS2

Controlling light emission from quantum emitters has important applications ranging from solid-state lighting and displays to nanoscale single-photon sources. Optical antennas have emerged as promising tools to achieve such control right at the location of the emitter, without the need for bulky, external optics. Semiconductor nanoantennas are particularly practical for this purpose because simple geometries, such as wires and spheres, support multiple, degenerate optical resonances. Here, we start by modifying Mie scattering theory developed for plane wave illumination to describe scattering of dipole emission. We then use this theory and experiments to demonstrate several pathways to achieve control over the directionality, polarization state, and spectral emission that rely on a coherent coupling of an emitting dipole to optical resonances of a Si nanowire. A forward-to-backward ratio of 20 was demonstrated for the electric dipole emission at 680 nm from a monolayer MoS2 by optically coupling it to a Si nanowire

Printable all-dielectric water-based absorber

Abstract The phase interplay between overlapping electric and magnetic dipoles of equal amplitude generated by exclusively alldielectric structures presents an intriguing paradigm in the manipulation of electromagnetic energy. Here, we offer a holistic implementation by proposing an additive manufacturing route and associated design principles that enable the programming and fabrication of synthetic multi-material microstructures. In turn, we compose, manufacture and experimentally validate the first demonstrable 3d printed all-dielectric electromagnetic broadband absorbers that point the way to circumventing the technical limitations of conventional metal-dielectric absorber configurations. One of the key innovations is to judicially distribute a dispersive soft matter with a high-dielectric constant, such as water, in a low-dielectric matrix to enhance wave absorption at a reduced length scale. In part, these results extend the promise of additive manufacturing and illustrate the power of topology optimisation to create carefully crafted magnetic and electric responses that are sure to find new applications across the electromagnetic spectrum

Light guiding and switching using eccentric core-shell geometries

High Refractive Index (HRI) dielectric nanoparticles have been proposed as an alternative to metallic ones due to their low absorption and magnetodielectric response in the VIS and NIR ranges. For the latter, important scattering directionality effects can be obtained. Also, systems constituted by dimers of HRI dielectric nanoparticles have shown to produce switching effects by playing with the polarization, frequency or intensity of the incident radiation. Here, we show that scattering directionality effects can be achieved with a single eccentric metallo-HRI dielectric core-shell nanoparticle. As an example, the effect of the metallic core displacements for a single Ag-Si core-shell nanoparticle has been analyzed. We report rotation of the main scattering lobe either clockwise or counterclockwise depending on the polarization of the incident radiation leading to new scattering configurations for switching purposes. Also, the efficiency of the scattering directionality can be enhanced. Finally, chains of these scattering units have shown good radiation guiding effects, and for 1D periodic arrays, redirection of diffracted intensity can be observed as a consequence of blazing effects. The proposed scattering units constitute new blocks for building systems for optical communications, solar energy harvesting devices and light guiding at the nanoscale level.This research was supported by MICINN (Spanish Ministry of Science and Innovation, project FIS2013-45854-P) and Fundación Iberdrola Espan~a, Call for Research on Energy and the Environment Grants. Á.I.B. and Y.G. want to express her gratitude to the University of Cantabria for their PhD grants