231 research outputs found
Study of the Feasibility of an X-Ray Free Electron Laser with a 15 GeV CLIC Beam
This note presents a study of the feasibility of a Free Electron Laser (FEL) using an electron beam from the Compact Linear Collider (CLIC). We first show that, with the nominal CLIC layout, the energy spread at 15 GeV would be too large to allow FEL saturation in an undulator of reasonable length. An alternative scheme was studied, with a dedicated source, with a by-pass of the damping rings and with magnetic compression between the various acceleration stages. With this scheme, the energy spread of the CLIC beam can be reduced from 1.5% to 0.1%, but the emittance is much larger and, although the power gain is better than in the nominal case, FEL saturation is still not reached. We show that the energy spread or the transverse emittance would have to be reduced by another order of magnitude in order to obtain FEL saturation
Numerical Studies of a Confocal Resonator Pick-Up with FEMLAB
Diagnostic devices aimed at measuring beam profiles in high intensity accelerators are often perturbed by microwave fields generated by the beam itself upstream of the detection device, which propagate inside the vacuum pipe. These parasitic waveguide modes can significantly reduce the signal-to-noise ratio and thus the sensitivity of the beam monitor. This warrants investigation of detection devices that are sensitive to the direct electromagnetic fields of the beam, but largely ignore the parasitic waveguide modes. A new pick-up based on a confocal resonator configuration situated transversely to the direction of propagation of the beam is currently under development at Uppsala University, Sweden. Since a confocal resonator can have a high quality factor for the diffraction losses, then reciprocity suggests that it only couples weakly to external fields while keeping anyway a significant coupling to the direct fields of the beam. Numerical simulations were performed with FEMLAB to better characterize the electromagnetic properties of a confocal resonator pick-up to be operated in the multi-GHz range, especially in terms of eigen-frequencies and coupling to external electromagnetic fields. Our results were then compared to analytical predictions and a good agreement was found, despite a few limitations in the computation of the resonant modes. Having recently built a first confocal resonator prototype, we also performed experimental cross-checks of our numerical studies with a microwave network analyzer. Our results are presented in detail in this report and we discuss further applications of the confocal resonator microwave pick-up
A Very Intense Neutrino Super Beam Experiment for Leptonic CP Violation Discovery based on the European Spallation Source Linac: A Snowmass 2013 White Paper
Very intense neutrino beams and large neutrino detectors will be needed in
order to enable the discovery of CP violation in the leptonic sector. We
propose to use the proton linac of the European Spallation Source currently
under construction in Lund, Sweden to deliver, in parallel with the spallation
neutron production, a very intense, cost effective and high performance
neutrino beam. The baseline program for the European Spallation Source linac is
that it will be fully operational at 5 MW average power by 2022, producing 2
GeV 2.86 ms long proton pulses at a rate of 14 Hz. Our proposal is to upgrade
the linac to 10 MW average power and 28 Hz, producing 14 pulses/s for neutron
production and 14 pulses/s for neutrino production. Furthermore, because of the
high current required in the pulsed neutrino horn, the length of the pulses
used for neutrino production needs to be compressed to a few s with the
aid of an accumulator ring. A long baseline experiment using this Super Beam
and a megaton underground Water Cherenkov detector located in existing mines
300-600 km from Lund will make it possible to discover leptonic CP violation at
5 significance level in up to 50% of the leptonic Dirac CP-violating
phase range. This experiment could also determine the neutrino mass hierarchy
at a significance level of more than 3 if this issue will not already
have been settled by other experiments by then. The mass hierarchy performance
could be increased by combining the neutrino beam results with those obtained
from atmospheric neutrinos detected by the same large volume detector. This
detector will also be used to measure the proton lifetime, detect cosmological
neutrinos and neutrinos from supernova explosions. Results on the sensitivity
to leptonic CP violation and the neutrino mass hierarchy are presented.Comment: 28 page
Baby MIND: A magnetised spectrometer for the WAGASCI experiment
The WAGASCI experiment being built at the J-PARC neutrino beam line will
measure the difference in cross sections from neutrinos interacting with a
water and scintillator targets, in order to constrain neutrino cross sections,
essential for the T2K neutrino oscillation measurements. A prototype Magnetised
Iron Neutrino Detector (MIND), called Baby MIND, is being constructed at CERN
to act as a magnetic spectrometer behind the main WAGASCI target to be able to
measure the charge and momentum of the outgoing muon from neutrino charged
current interactions.Comment: Poster presented at NuPhys2016 (London, 12-14 December 2016). Title +
4 pages, LaTeX, 6 figure
Baby MIND Experiment Construction Status
Baby MIND is a magnetized iron neutrino detector, with novel design features,
and is planned to serve as a downstream magnetized muon spectrometer for the
WAGASCI experiment on the T2K neutrino beam line in Japan. One of the main
goals of this experiment is to reduce systematic uncertainties relevant to
CP-violation searches, by measuring the neutrino contamination in the
anti-neutrino beam mode of T2K. Baby MIND is currently being constructed at
CERN, and is planned to be operational in Japan in October 2017.Comment: Poster presented at NuPhys2016 (London, 12-14 December 2016). 4
pages, LaTeX, 7 figure
Baby MIND: A magnetized segmented neutrino detector for the WAGASCI experiment
T2K (Tokai-to-Kamioka) is a long-baseline neutrino experiment in Japan
designed to study various parameters of neutrino oscillations. A near detector
complex (ND280) is located 280~m downstream of the production target and
measures neutrino beam parameters before any oscillations occur. ND280's
measurements are used to predict the number and spectra of neutrinos in the
Super-Kamiokande detector at the distance of 295~km. The difference in the
target material between the far (water) and near (scintillator, hydrocarbon)
detectors leads to the main non-cancelling systematic uncertainty for the
oscillation analysis. In order to reduce this uncertainty a new
WAter-Grid-And-SCintillator detector (WAGASCI) has been developed. A magnetized
iron neutrino detector (Baby MIND) will be used to measure momentum and charge
identification of the outgoing muons from charged current interactions. The
Baby MIND modules are composed of magnetized iron plates and long plastic
scintillator bars read out at the both ends with wavelength shifting fibers and
silicon photomultipliers. The front-end electronics board has been developed to
perform the readout and digitization of the signals from the scintillator bars.
Detector elements were tested with cosmic rays and in the PS beam at CERN. The
obtained results are presented in this paper.Comment: In new version: modified both plots of Fig.1 and added one sentence
in the introduction part explaining Baby MIND role in WAGASCI experiment,
added information for the affiliation
- …