31,509 research outputs found
Multiple Radial Cool Molecular Filaments in NGC 1275
We have extended our previous observation (Lim et al. 2008) of NGC1275
covering a central radius of ~10kpc to the entire main body of cool molecular
gas spanning ~14kpc east and west of center. We find no new features beyond the
region previously mapped, and show that all six spatially-resolved features on
both the eastern and western sides (three on each side) comprise radially
aligned filaments. Such radial filaments can be most naturally explained by a
model in which gas deposited "upstream" in localized regions experiencing an
X-ray cooling flow subsequently free falls along the gravitational potential of
PerA, as we previously showed can explain the observed kinematics of the two
longest filaments. All the detected filaments coincide with locally bright
Halpha features, and have a ratio in CO(2-1) to Halpha luminosity of ~1e-3; we
show that these filaments have lower star formation efficiencies than the
nearly constant value found for molecular gas in nearby normal spiral galaxies.
On the other hand, some at least equally luminous Halpha features, including a
previously identified giant HII region, show no detectable cool molecular gas
with a corresponding ratio at least a factor of ~5 lower; in the giant HII
region, essentially all the pre-existing molecular gas may have been converted
to stars. We demonstrate that all the cool molecular filaments are
gravitationally bound, and without any means of support beyond thermal pressure
should collapse on timescales ~< 1e6yrs. By comparison, as we showed previously
the two longest filaments have much longer dynamical ages of ~1e7yrs. Tidal
shear may help delay their collapse, but more likely turbulent velocities of at
least a few tens km/s or magnetic fields with strengths of at least several
~10uG are required to support these filaments.Comment: 52 pages, 11 figures. Accepted to Ap
Coulomb-blockade effect in nonlinear mesoscopic capacitors
We consider an interacting quantum dot working as a coherent source of single
electrons. The dot is tunnel coupled to a reservoir and capacitively coupled to
a gate terminal with an applied ac potential. At low frequencies, this is the
quantum analog of the RC circuit with a purely dynamical response. We
investigate the quantized dynamics as a consequence of ac pulses with large
amplitude. Within a Keldysh-Green function formalism we derive the
time-dependent current in the Coulomb blockade regime. Our theory thus extends
previous models that considered either noninteracting electrons in nonlinear
response or interacting electrons in the linear regime. We prove that the
electron emission and absorption resonances undergo a splitting when the
charging energy is larger than the tunnel broadening. For very large charging
energies, the additional peaks collapse and the original resonances are
recovered, though with a reduced amplitude. Quantization of the charge emitted
by the capacitor is reduced due to Coulomb repulsion and additional plateaus
arise. Additionally, we discuss the differential capacitance and resistance as
a function of time. We find that to leading order in driving frequency the
current can be expressed as a weighted sum of noninteracting currents shifted
by the charging energy.Comment: 13 pages, 9 figures. Minor changes. Published versio
A scattering theory of ultrarelativistic solitons
We construct a perturbative framework for understanding the collision of
solitons (more precisely, solitary waves) in relativistic scalar field
theories. Our perturbative framework is based on the suppression of the
space-time interaction area proportional to , where is the
relative velocity of an incoming solitary wave and . We calculate the leading order results for collisions of (1+1) dimensional
kinks in periodic potentials, and provide explicit, closed form expressions for
the phase shift and the velocity change after the collisions. We find excellent
agreement between our results and detailed numerical simulations. Crucially,
our perturbation series is controlled by a kinematic parameter, and hence not
restricted to small deviations around integrable cases such as the Sine-Gordon
model.Comment: v3: 43 pages, 10 figures, references added, matches version accepted
for publication in PR
Analyzing big time series data in solar engineering using features and PCA
In solar engineering, we encounter big time series data such as the satellite-derived irradiance data and string-level measurements from a utility-scale photovoltaic (PV) system. While storing and hosting big data are certainly possible using today’s data storage technology, it is challenging to effectively and efficiently visualize and analyze the data. We consider a data analytics algorithm to mitigate some of these challenges in this work. The algorithm computes a set of generic and/or application-specific features to characterize the time series, and subsequently uses principal component analysis to project these features onto a two-dimensional space. As each time series can be represented by features, it can be treated as a single data point in the feature space, allowing many operations to become more amenable. Three applications are discussed within the overall framework, namely (1) the PV system type identification, (2) monitoring network design, and (3) anomalous string detection. The proposed framework can be easily translated to many other solar engineer applications
Recommended from our members
Optically pumped colloidal-quantum-dot lasing in LED-like devices with an integrated optical cavity.
Realization of electrically pumped lasing with solution processable materials will have a revolutionary impact on many disciplines including photonics, chemical sensing, and medical diagnostics. Due to readily tunable, size-controlled emission wavelengths, colloidal semiconductor quantum dots (QDs) are attractive materials for attaining this goal. Here we use specially engineered QDs to demonstrate devices that operate as both a light emitting diode (LED) and an optically pumped laser. These structures feature a distributed feedback resonator integrated into a bottom LED electrode. By carefully engineering a refractive-index profile across the device, we are able to obtain good confinement of a waveguided mode within the QD medium, which allows for demonstrating low-threshold lasing even with an ultrathin (about three QD monolayers) active layer. These devices also exhibit strong electroluminescence (EL) under electrical pumping. The conducted studies suggest that the demonstrated dual-function (lasing/EL) structures represent a promising device platform for realizing colloidal QD laser diodes
Magnetoasymmetric transport in a mesoscopic interferometer: From the weak to the strong coupling regime
The microreversibility principle implies that the conductance of a
two-terminal Aharonov-Bohm interferometer is an even function of the applied
magnetic flux. Away from linear response, however, this symmetry is not
fulfilled and the conductance phase of the interferometer when a quantum dot is
inserted in one of its arms can be a continuous function of the bias voltage.
Such magnetoasymmetries have been investigated in related mesoscopic systems
and arise as a consequence of the asymetric response of the internal potential
of the conductor out of equilibrium. Here we discuss magnetoasymmetries in
quantum-dot Aharonov-Bohm interferometers when strong electron-electron
interactions are taken into account beyond the mean-field approach. We find
that at very low temperatures the asymmetric element of the differential
conductance shows an abrupt change for voltages around the Fermi level. At
higher temperatures we recover a smooth variation of the magnetoasymmetry as a
function of the bias. We illustrate our results with the aid of the electron
occupation at the dot, demonstrating that its nonequilibrium component is an
asymmetric function of the flux even to lowest order in voltage. We also
calculate the magnetoasymmetry of the current-current correlations (the noise)
and find that it is given, to a good extent, by the magnetoasymmetry of the
weakly nonlinear conductance term. Therefore, both magnetoasymmetries (noise
and conductance) are related to each other via a higher-order
fluctuation-dissipation relation. This result appears to be true even in the
low temperature regime, where Kondo physics and many-body effects dominate the
transport properties.Comment: 17 pages, 9 figure
Spin- and band-ferromagnetism in trilayer graphene
We study the ground state properties of an ABA-stacked trilayer graphene. The
low energy band structure can be described by a combination of both a linear
and a quadratic particle-hole symmetric dispersions, reminiscent of monolayer-
and bilayer-graphene, respectively. The multi-band structure offers more
channels for instability towards ferromagnetism when the Coulomb interaction is
taken into account. Indeed, if one associates a pseudo-spin 1/2 degree of
freedom to the bands (parabolic/linear), it is possible to realize also a
band-ferromagnetic state, where there is a shift in the energy bands, since
they fill up differently. By using a variational procedure, we compute the
exchange energies for all possible variational ground states and identify the
parameter space for the occurrence of spin- and band-ferromagnetic
instabilities as a function of doping and interaction strength.Comment: 9 pages/ 8 figure
Mechanical compatibility of sol–gel annealing with titanium for orthopaedic prostheses
Sol–gel processing is an attractive method for large-scale surface coating due to its facile and inexpensive preparation, even with the inclusion of precision nanotopographies. These are desirable traits for metal orthopaedic prostheses where ceramic coatings are known to be osteoinductive and the effects may be amplified through nanotexturing. However there are a few concerns associated with the application of sol–gel technology to orthopaedics. Primarily, the annealing stage required to transform the sol–gel into a ceramic may compromise the physical integrity of the underlying metal. Secondly, loose particles on medical implants can be carcinogenic and cause inflammation so the coating needs to be strongly bonded to the implant. These concerns are addressed in this paper. Titanium, the dominant material for orthopaedics at present, is examined before and after sol–gel processing for changes in hardness and flexural modulus. Wear resistance, bending and pull tests are also performed to evaluate the ceramic coating. The findings suggest that sol–gel coatings will be compatible with titanium implants for an optimum temperature of 500 °C
How to Run Through Walls: Dynamics of Bubble and Soliton Collisions
It has recently been shown in high resolution numerical simulations that
relativistic collisions of bubbles in the context of a multi-vacua potential
may lead to the creation of bubbles in a new vacuum. In this paper, we show
that scalar fields with only potential interactions behave like free fields
during high-speed collisions; the kick received by them in a collision can be
deduced simply by a linear superposition of the bubble wall profiles. This
process is equivalent to the scattering of solitons in 1+1 dimensions. We
deduce an expression for the field excursion (shortly after a collision), which
is related simply to the field difference between the parent and bubble vacua,
i.e. contrary to expectations, the excursion cannot be made arbitrarily large
by raising the collision energy. There is however a minimum energy threshold
for this excursion to be realized. We verify these predictions using a number
of 3+1 and 1+1 numerical simulations. A rich phenomenology follows from these
collision induced excursions - they provide a new mechanism for scanning the
landscape, they might end/begin inflation, and they might constitute our very
own big bang, leaving behind a potentially observable anisotropy.Comment: 15pgs, 14 figures, v2, thanks for the feedback
- …