An experimental investigation into quasi-static and fatigue damage development in bolted-hole specimens

AbstractAn extensive experimental program has been carried out to investigate and understand the sequence of damage development throughout the life of bolted-hole composite laminates under quasi-static loading and tension–tension fatigue. Quasi-isotropic carbon/epoxy laminates, with stacking sequence [452/902/-452/02]S defined as ply scaled and [45/90/-45/0]2S defined as sub-laminate scaled, were used. Specimens were cycled at 5 Hz with various amplitudes to 1 × 106 cycles unless failure occurred prior to this limit. For all cases an R ratio of 0.1 was used. Bolt washer pressures of 23 MPa and 70 MPa were investigated. For the ply-level case, the quasi-static test showed both delamination and fibre-dominated pull-out failures for a washer pressure of 23 MPa, and pull-out failure only for 70 MPa. Delamination dominates in fatigue tests. For the sub-laminate case the tests failed by pull-out in both quasi-static and fatigue tests for all washer pressures. It is shown in this paper how the role of delamination is critical in the case of fatigue loading and how this interacts with bolt clamp-up forces. A number of tests were analysed for damage using X-ray CT scanning and comparisons of damage are made with tests from previous open-hole studies

Interaction of Z-pins with Multiple Mode II Delaminations in Composite Laminates

The application of Z-pinning is a subject of great interest in the field of through-thickness reinforcement (TTR) of composite laminates. To date, the majority of Z-pin characterisation work has been conducted on fracture coupons containing a single embedded delamination, which is often not representative of real failure of reinforced composite structures in service. In this investigation a test procedure to produce two independent Mode II delaminations was developed to analyse their interaction with a region of Z-pin reinforcement. Initially numerical models were used to optimise the chosen configuration. Experimental results show in detail the response of Z-pins to two independent delaminations. These results highlight the ability of the Z-pins to effectively arrest mode II delaminations at multiple levels through the sample thickness. Additionally they provide a much needed data set for validation and verification of Z-pin numerical modelling tools

Soil moisture content measurement using optical fiber long period gratings

The use of an optical fibre long period grating (LPG) as a soil moisture sensor is reported. Characterization of the device in both clay and sandy soils revealed a sensitivity to moisture levels in the range 10-50%, and the results were compared with the output from a Theta probe, the standard soil moisture sensor, which measures the impedance of the soil. © (2017) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only

A novel model of delamination bridging via Z-pins in composite laminates

AbstractA new micro-mechanical model is proposed for describing the bridging actions exerted by through-thickness reinforcement on delaminations in prepreg based composite materials, subjected to a mixed-mode (I–II) loading regime. The model applies to micro-fasteners in the form of brittle fibrous rods (Z-pins) inserted in the through-thickness direction of composite laminates. These are described as Euler–Bernoulli beams inserted in an elastic foundation that represents the embedding composite laminate. Equilibrium equations that relate the delamination opening/sliding displacements to the bridging forces exerted by the Z-pins on the interlaminar crack edges are derived. The Z-pin failure meso-mechanics is explained in terms of the laminate architecture and the delamination mode. The apparent fracture toughness of Z-pinned laminates is obtained from as energy dissipated by the pull out of the through-thickness reinforcement, normalised with respect to a reference area. The model is validated by means of experimental data obtained for single carbon/BMI Z-pins inserted in a quasi-isotropic laminate