A Thermal Management System to Reuse Thermal Waste Released by High-Power Light-Emitting Diodes

© 1963-2012 IEEE. In this article, a comprehensive and efficient thermal management system is proposed to harvest and reuse the thermal waste of high-power light-emitting diodes (HP-LEDs) for the first time. Besides a conventional cooling system, including a thermoelectric (TE) cooler (TEC), a heatsink, and a fan, the proposed thermal management system also employs a TE generator (TEG), a temperature sensor, a voltage boost converter, and a microcontroller for thermal waste recycling. In this system, some of the thermal waste released by the HP-LED is harvested by the TEG and converted into electrical energy. With the help of a voltage boost converter, the harvested electrical power is used to power a temperature sensor for monitoring the surface temperature of the HP-LED. The entire system is regulated by the microcontroller. The system is elaborately established, tested, and the results are discussed. The experimental results show that the proposed system has an output electrical power of approximately 696.5μW , which is used to power a temperature sensor as a demonstration. The sensor works well, and the discrepancy of the surface temperature of the HP-LED measured by the sensor and by a thermometer is less than 5.38%, which validates the proposed thermal management system

Direct multiple shoot induction and plant regeneration from dormant buds of Codonopsis pilosula (Franch.) Nannf.

An efficient and reproducible protocol for in vitro plant multiplication system via direct organogenesis from dormant buds of Codonopsis pilosula Nannf was developed. Multiple shoots were induced at a frequency of 75% after nine weeks on Murashige and Skoog (MS) medium supplemented with BAP (1.0 mg/l), NAA (0.5 mg/l), 3% sucrose and 0.7% agar. Approximately, 15 to 18 shoots were formed at the base of each dormant bud. Higher concentrations of BAP and NAA resulted in callus formation. Further development of shoot elongation and multiplication were also studied. Well-grown shoots of 2.8 cm height and 3.8 proliferation coefficient were achieved by sub-culturing on MS medium supplemented with 0.2 mg/l BAP and 0.05 mg/l IBA. At higher concentrations, BAP (0.5 mg/l) promoted higher shoot proliferation coefficient (4.2); however, it negatively affected shoot elongation. Further, low NAA concentration was beneficial to shoot proliferation. All in vitro-derived shoots measuring 2.5 to 3 cm in length, rooted when grown on ½MS (half of all MS elements) basal medium containing 1.5 mg/l IBA within 3 weeks, 100% of shoots developed roots and test-tube seedlings grew stout.Key words: Codonopsis pilosula, dormant bud, direct organogenesis, multiple shoot, shoot elongation, rooting

Suppression of photoconductivity by magnetic field in epitaxial manganite thin films

The erasure of photoinduced resistance (PR) by the magnetic field was investigated in manganite films. The PR was significantly suppressed when a magnetic field was introduced at low temperature. The decrease (or increase) of PR with increment of magnetic field was observed in ferromagnetic (or paramagnetic) phases of films, respectively. Our results are suggested to be the coaction of two effects under magnetic fields: (i) the reorientation of domains and spin directions of photoexcited carriers and (ii) electrons trapped around oxygen vacancies released and recombined with majority carriers in films. The interplay of the external fields is a good demonstration of the strong coupling between spins and charges in colossal magnetoresistance materials. © 2012 American Institute of Physics.published_or_final_versio

Improving the Energy-Conversion Efficiency of a PV-TE System with an Intelligent Power-Track Switching Technique and Efficient Thermal-Management Scheme

A photovoltaic-thermoelectric (PV-TE) hybrid system can be used for efficient thermal energy utilization from the generated waste heat in PV devices. In this article, an efficient PV-TE hybrid system with intelligent power-track switching technique and thermal management based on energy conversion is proposed. To make the output power of PV-TE system stable and normalized, an incorporated stable voltage circuit is designed based on energy conversion. In addition, a control-and-monitoring strategy is launched in the system to realize the normal collecting for the output power of PV-TE system. Finally, a battery protection circuit is performed to ensure that the energy converted by the entire system is effectively stored. The experimental results show that more electrical energy about 84 034 J was obtained with our energy harvesting system than that of a single photovoltaic (PV) cell. Besides, the thermal gradient of PV cells is indirectly reduced the operation of the whole system, which is automatically monitored due to the proposed intelligent power-track switching technique

Production Scheduling Requirements to Smart Manufacturing

The production scheduling has attracted a lot of researchers for many years, however most of the approaches are not targeted to deal with real manufacturing environments, and those that are, are very particular for the case study. It is crucial to consider important features related with the factories, such as products and machines characteristics and unexpected disturbances, but also information such as when the parts arrive to the factory and when should be delivered. So, the purpose of this paper is to identify some important characteristics that have been considered independently in a lot of studies and that should be considered together to develop a generic scheduling framework to be used in a real manufacturing environment.authorsversionpublishe

Investigation on Photovoltaic Performance based on Matchstick-Like Cu2S–In2S3Heterostructure Nanocrystals and Polymer

In this paper, we synthesized a novel type II cuprous sulfide (Cu2S)–indium sulfide (In2S3) heterostructure nanocrystals with matchstick-like morphology in pure dodecanethiol. The photovoltaic properties of the heterostructure nanocrystals were investigated based on the blends of the nanocrystals and poly(2-methoxy-5-(2′-ethylhexoxy)-p-phenylenevinylene) (MEH-PPV). In comparison with the photovoltaic properties of the blends of Cu2S or In2S3nanocrystals alone and MEH-PPV, the power conversion efficiency of the hybrid device based on blend of Cu2S–In2S3and MEH-PPV is enhanced by ~3–5 times. This improvement is consistent with the improved exciton dissociation or separation and better charge transport abilities in type II heterostructure nanocrystals

An elitist quantum-inspired evolutionary algorithm for the flexible job-shop scheduling problem

The flexible job shop scheduling problem (FJSP) is vital to manufacturers especially in today’s constantly changing environment. It is a strongly NP-hard problem and therefore metaheuristics or heuristics are usually pursued to solve it. Most of the existing metaheuristics and heuristics, however, have low efficiency in convergence speed. To overcome this drawback, this paper develops an elitist quantum-inspired evolutionary algorithm. The algorithm aims to minimise the maximum completion time (makespan). It performs a global search with the quantum-inspired evolutionary algorithm and a local search with a method that is inspired by the motion mechanism of the electrons around an atomic nucleus. Three novel algorithms are proposed and their effect on the whole search is discussed. The elitist strategy is adopted to prevent the optimal solution from being destroyed during the evolutionary process. The results show that the proposed algorithm outperforms the best-known algorithms for FJSPs on most of the FJSP benchmarks

HIV/TB Co-Infection in Mainland China: A Meta-Analysis

Background: TB and HIV co-epidemic is a major public health problem in many parts of the world, particularly in developing counties. We aimed to summarize the prevalence of TB and HIV co-infection in mainland China, using meta-analysis based on systematic review of published articles. Methods: We systematically reviewed published studies, from the MEDLINE and Chinese BioMedical Literature Databases, on the prevalence of HIV infection among TB patients and on the prevalence of TB among HIV/AIDS population until 15 April 2010, and quantitatively summarized the estimates using meta-analysis. Results: In total, 29 studies were included in this review, with consistently homogeneous results. TB patients, for whom the summary prevalence of HIV infection was 0.9 % (0.6%–1.4%) in mainland China, were found to be a potential target population for HIV screening. The prevalence of TB among HIV/AIDS population was 7.2 % (4.2%–12.3%), but this was much higher when the analyses were restricted to AIDS patients (22.8%). Significantly higher prevalence was observed for males and hospital-based studies. Conclusions: Our analyses indicated that the prevalence of HIV/TB co-infection in China deserves special attention, screening of TB among HIV/AIDS populations should be attached more importance, which would be much more helpful for treatment of both diseases

Assessment of HIF-1α expression and release following endothelial injury in-vitro and in-vivo

Background: Endothelial injury is an early and enduring feature of cardiovascular disease. Inflammation and hypoxia may be responsible for this, and are often associated with the up-regulation of several transcriptional factors that include Hypoxia Inducible Factor-1 (HIF-1). Although it has been reported that HIF-1α is detectable in plasma, it is known to be unstable. Our aim was to optimize an assay for HIF-1α to be applied to in vitro and in vivo applications, and to use this assay to assess the release kinetics of HIF-1 following endothelial injury. Methods: An ELISA for the measurement of HIF in cell-culture medium and plasma was optimized, and the assay used to determine the best conditions for sample collection and storage. The results of the ELISA were validated using Western blotting and immunohistochemistry (IHC). In vitro, a standardized injury was produced in a monolayer of rat aortic endothelial cells (RAECs) and intracellular HIF-1α was measured at intervals over 24 hours. In vivo, a rat angioplasty model was used. The right carotid artery was injured using a 2F Fogarty balloon catheter. HIF-1α was measured in the plasma and in the arterial tissue (0, 1, 2, 3 and 5 days post injury). Results: The HIF-1α ELISA had a limit of detection of 2.7 pg/ mL and was linear up to 1000 pg/ mL. Between and within-assay coefficient of variation values were less than 15%. HIF-1α was unstable in cell lysates and plasma, and it was necessary to add a protease inhibitor immediately after collection, and to store samples at -800C prior to analysis. The dynamics of HIF-1α release were different for the in vitro and in vivo models. In vitro, HIF-1α reached maximum concentrations approximately 2h post injury, whereas peak values in plasma and tissues occurred approximately 2 days post injury, in the balloon injury model. Conclusion: HIF-1α can be measured in plasma, but this requires careful sample collection and storage. The carotid artery balloon injury model is associated with the transient release of HIF-1α into the circulation that probably reflects the hypoxia induced in the artery wall