4,667 research outputs found
Highly senstivive determination of 2.4,6-Trinitrotolunene and Related Byproducts Using a Diol Functionalized Column for High Performance Liquid Chromatography
Cataloged from PDF version of article.In this work, a new detection method for complete separation of 2,4,6-trinitrotoluene (TNT); 2,4-dinitrotoluene (2,4-DNT); 2,6-dinitrotoluene (2,6-DNT); 2-aminodinitrotoluene (2-ADNT) and 4-aminodinitrotoluene (4-ADNT) molecules in high-performance liquid-chromatography (HPLC) with UV sensor has been developed using diol column. This approach improves on cost, time, and sensitivity over the existing methods, providing a simple and effective alternative. Total analysis time was less than 13 minutes including column re-equilibration between runs, in which water and acetonitrile were used as gradient elution solvents. Under optimized conditions, the minimum resolution between 2,4-DNT and 2,6-DNT peaks was 2.06. The recovery rates for spiked environmental samples were between 95-98%. The detection limits for diol column ranged from 0.78 to 1.17 μg/L for TNT and its byproducts. While the solvent consumption was 26.4 mL/min for two-phase EPA and 30 mL/min for EPA 8330 methods, it was only 8.8 mL/min for diol column. The resolution was improved up to 49% respect to two-phase EPA and EPA 8330 methods. When compared to C-18 and phenyl-3 columns, solvent usage was reduced up to 64% using diol column and resolution was enhanced approximately two-fold. The sensitivity of diol column was afforded by the hydroxyl groups on polyol layer, joining the formation of charge-transfer complexes with nitroaromatic compounds according to acceptor-donor interactions. Having compliance with current requirements, the proposed method demonstrates sensitive and robust separation. © 2014 Gumuscu et al
Rapid fabrication of microfluidic PDMS devices from reusable PDMS molds using laser ablation
The conventional fabrication methods for microfluidic devices require cleanroom processes that are costly and time-consuming. We present a novel, facile, and low-cost method for rapid fabrication of polydimethylsiloxane (PDMS) molds and devices. The method consists of three main fabrication steps: female mold (FM), male mold (MM), and chip fabrication. We use a CO2 laser cutter to pattern a thin, spin-coated PDMS layer for FM fabrication. We then obtain reusable PDMS MM from the FM using PDMS/PDMS casting. Finally, a second casting step is used to replicate PDMS devices from the MM. Demolding of one PDMS layer from another is carried out without any potentially hazardous chemical surface treatment. We have successfully demonstrated that this novel method allows fabrication of microfluidic molds and devices with precise dimensions (thickness, width, length) using a single material, PDMS, which is very common across microfluidic laboratories. The whole process, from idea to device testing, can be completed in 1.5 h in a standard laboratory. © 2016 IOP Publishing Ltd
Smear microscopy and culture conversion rates among smear positive pulmonary tuberculosis patients by HIV status in Dar es Salaam, Tanzania
Tanzania ranks 15th among the world's 22 countries with the largest tuberculosis burden and tuberculosis has continued to be among the major public health problems in the country. Limited data, especially in patients co infected with HIV, are available to predict the duration of time required for a smear positive pulmonary tuberculosis patient to achieve sputum conversion after starting effective treatment. In this study we assessed the sputum smear and culture conversion rates among HIV positive and HIV negative smear positive pulmonary tuberculosis patients in Dar es Salaam The study was a prospective cohort study which lasted for nine months, from April to December 2008 A total of 502 smear positive pulmonary tuberculosis patients were recruited. HIV test results were obtained for 498 patients, of which 33.7% were HIV positive. After two weeks of treatment the conversion rate by standard sputum microscopy was higher in HIV positive(72.8%) than HIV negative(63.3%) patients by univariate analysis(P = 0.046), but not in multivariate analysis. Also after two weeks of treatment the conversion rate by fluorescence microscopy was higher in HIV positive (72.8%) than in HIV negative(63.2%) patients by univariate analysis (P = 0.043) but not in the multivariate analysis. The conversion rates by both methods during the rest of the treatment period (8, 12, and 20 weeks) were not significantly different between HIV positive and HIV negative patients.With regards to culture, the conversion rate during the whole period of the treatment (2, 8, 12 and 20 weeks) were not significantly different between HIV positive and HIV negative patients.\ud
Conversion rates of standard smear microscopy, fluorescence microscopy and culture did not differ between HIV positive and HIV negative pulmonary tuberculosis patients
Cross Sections for the Exclusive Photon Electroproduction on the Proton and Generalized Parton Distributions
Unpolarized and beam-polarized fourfold cross sections (d4σ/dQ2dxBdtdϕ) for the ep → e\u27p\u27γ reaction were measured using the CLAS detector and the 5.75-GeV polarized electron beam of the Jefferson Lab accelerator, for 110 (Q2;xB;t) bins over the widest phase space ever explored in the valence-quark region. Several models of generalized parton distributions (GPDs) describe the data well at most of our kinematics. This increases our confidence that we understand the GPD H, expected to be the dominant contributor to these observables. Through a leading-twist extraction of Compton form factors, these results support the model predictions of a larger nucleon size at lower quark-momentum fraction xB
Label-Free Nanometer-Resolution Imaging of Biological Architectures through Surface Enhanced Raman Scattering
Label free imaging of the chemical environment of biological specimens would readily bridge the supramolecular and the cellular scales, if a chemical fingerprint technique such as Raman scattering can be coupled with super resolution imaging. We demonst
Target and Beam-Target Spin Asymmetries in Exclusive Pion Electroproduction for Q² \u3e 1 GeV² . II. ep→ eπºp
Beam-target double-spin asymmetries and target single-spin asymmetries were measured for the exclusive π0 electroproduction reaction γ∗p→pπ0, expanding an analysis of the γ∗p→nπ+ reaction from the same experiment. The results were obtained from scattering of 6-GeV longitudinally polarized electrons off longitudinally polarized protons using the CEBAF Large Acceptance Spectrometer at Jefferson Laboratory. The kinematic ranges covered are 1.1 \u3c W \u3c 3 GeV and 1 \u3c Q2\u3c 6 GeV2 . Results were obtained for about 5700 bins in W, Q2, cos(θ∗) , and ϕ∗. The beam-target asymmetries were found to generally be greater than zero, with relatively modest ϕ∗ dependence. The target asymmetries exhibit very strong ϕ∗ dependence, with a change in sign occurring between results at low W and high W , in contrast to π+ electroproduction. Reasonable agreement is found with phenomenological fits to previous data for W \u3c 1.6 GeV, but significant differences are seen at higher W . When combined with cross-sectional measurements, as well as π+ observables, the present results will provide powerful constraints on nucleon resonance amplitudes at moderate and large values of Q2, for resonances with masses as high as 2.4 GeV
Label-free nanometer-resolution imaging of biological architectures through surface enhanced raman scattering
Label free imaging of the chemical environment of biological specimens would readily bridge the supramolecular and the cellular scales, if a chemical fingerprint technique such as Raman scattering can be coupled with super resolution imaging. We demonstrate the possibility of label-free super-resolution Raman imaging, by applying stochastic reconstruction to temporal fluctuations of the surface enhanced Raman scattering (SERS) signal which originate from biomolecular layers on large-area plasmonic surfaces with a high and uniform hot-spot density (>1011/cm2, 20 to 35 nm spacing). A resolution of 20 nm is demonstrated in reconstructed images of self-assembled peptide network and fibrilated lamellipodia of cardiomyocytes. Blink rate density is observed to be proportional to the excitation intensity and at high excitation densities (>10 kW/cm2) blinking is accompanied by molecular breakdown. However, at low powers, simultaneous Raman measurements show that SERS can provide sufficient blink rates required for image reconstruction without completely damaging the chemical structure
Accelerated diabetic wound healing by topical application of combination oral antidiabetic agents-loaded nanofibrous scaffolds: An in vitro and in vivo evaluation study
The combination of oral antidiabetic drugs, pioglitazone, metformin, and glibenclamide, which also
exhibit the strongest anti-inflammatory action among oral antidiabetic drugs, were loaded into
chitosan/gelatin/polycaprolactone (PCL) by electrospinning and polyvinyl pyrrolidone (PVP)/PCL
composite nanofibrous scaffolds by pressurized gyration to compare the diabetic wound healing
effect. The combination therapies significantly accelerated diabetic wound healing in type-1
diabetic rats and organized densely packed collagen fibers in the dermis, it also showed better
regeneration of the dermis and epidermis than single drug-loaded scaffolds with less inflammatory
cell infiltration and edema. The formation of the hair follicles started in 14 days only in the
combination therapy and lower proinflammatory cytokine levels were observed compared to single
drug-loaded treatment groups. The combination therapy increased the wettability and hydrophilicity
of scaffolds, demonstrated sustained drug release over 14 days, has high tensile strength and
suitable cytocompatibility on L929 (mouse fibroblast) cell and created a suitable area for the
proliferation of fibroblast cells. Consequently, the application of metformin and pioglitazone-loaded
chitosan/gelatin/PCL nanofibrous scaffolds to a diabetic wound area offer high bioavailability,
fewer systemic side effects, and reduced frequency of dosage and amount of drug
Precise Determination of the Deuteron Spin Structure at Low to Moderate Q² with CLAS and Extraction of the Neutron Contribution
We present the final results for the deuteron spin structure functions obtained from the full data set collected in 2000–2001 with Jefferson Lab\u27s continuous electron beam accelerator facility (CEBAF) using the CEBAF large acceptance spectrometer (CLAS). Polarized electrons with energies of 1.6, 2.5, 4.2, and 5.8 GeV were scattered from deuteron (15ND3 ) targets, dynamically polarized along the beam direction, and detected with CLAS. From the measured double-spin asymmetry, the virtual photon absorption asymmetry Ad1 and the polarized structure function gd1 were extracted over a wide kinematic range (0.05GeV2 \u3c Q2 \u3c 5GeV2 and 0.9 GeV \u3c W \u3c 3GeV ). We use an unfolding procedure and a parametrization of the corresponding proton results to extract from these data the polarized structure functions An1 and gn1 of the (bound) neutron, which are so far unknown in the resonance region, W \u3c 2 GeV. We compare our final results, including several moments of the deuteron and neutron spin structure functions, with various theoretical models and expectations, as well as parametrizations of the world data. The unprecedented precision and dense kinematic coverage of these data can aid in future extractions of polarized parton distributions, tests of perturbative QCD predictions for the quark polarization at large x , a better understanding of quark-hadron duality, and more precise values for higher-twist matrix elements in the framework of the operator product expansion
Beam-Target Double-Spin Asymmetry in Quasielastic Electron Scattering off the Deuteron with CLAS
Background: The deuteron plays a pivotal role in nuclear and hadronic physics, as both the simplest bound multinucleon system and as an effective neutron target. Quasielastic electron scattering on the deuteron is a benchmark reaction to test our understanding of deuteron structure and the properties and interactions of the two nucleons bound in the deuteron.
Purpose: The experimental data presented here can be used to test state-of-the-art models of the deuteron and the two-nucleon interaction in the final state after two-body breakup of the deuteron. Focusing on polarization degrees of freedom, we gain information on spin-momentum correlations in the deuteron ground state (due to the D-state admixture) and on the limits of the impulse approximation (IA) picture as it applies to measurements of spin-dependent observables like spin structure functions for bound nucleons. Information on this reaction can also be used to reduce systematic uncertainties on the determination of neutron form factors or deuteron polarization through quasielastic polarized electron scattering.
Method: We measured the beam-target double-spin asymmetry (A||) for quasielastic electron scattering off the deuteron at several beam energies (1.6-1.7, 2.5, 4.2, and 5.6-5.8 GeV), using the CEBAF Large Acceptance Spectrometer (CLAS) at the Thomas Jefferson National Accelerator Facility. The deuterons were polarized along (or opposite to) the beam direction. The double-spin asymmetries were measured as a function of photon virtuality Q2 (0.13-3.17 (GeV/c)2), missing momentum (pm = 0.0-0.5 GeV/c), and the angle between the (inferred) spectator neutron and the momentum transfer direction (θnq).
Results: The results are compared with a recent model that includes final-state interactions (FSI) using a complete parametrization of nucleon-nucleon scattering, as well as a simplified model using the plane wave impulse approximation (PWIA). We find overall good agreement with both the PWIA and FSI expectations at low to medium missing momenta (pm \u3c= 0.25 GeV/c), including the change of the asymmetry due to the contribution of the deuteron D state at higher momenta. At the highest missing momenta, our data clearly agree better with the calculations including FSI.
Conclusions: Final-state interactions seem to play a lesser role for polarization observables in deuteron two-body electrodisintegration than for absolute cross sections. Our data, while limited in statistical power, indicate that PWIA models work reasonably well to understand the asymmetries at lower missing momenta. In turn, this information can be used to extract the product of beam and target polarization (PbPt) from quasielastic electron-deuteron scattering, which is useful for measurements of spin observables in electron-neutron inelastic scattering. However, at the highest missing (neutron) momenta, FSI effects become important and must be accounted for
- …