Improving Structural Lumber Quality in a Sample of Picea Mariana Logs Sawn According to the Knots

This paper examines the effect of knots on the strength recovery of black spruce lumber. A model was developed and used to simulate sawing and grading of boards from knotty logs. Since a log internal defect scanner was unavailable, the internal knot morphology was modeled from external measurements. A standard cant and flitch sawing pattern was used in the simulations and rotated about the log axis. for each 30° of log rotation, the theoretical lumber grades were obtained based on knot sizes and positions within the boards. A best and worst sawing rotation angle based on the potential lumber grade yield was retained for each of 54 logs simulated Half of the logs were sawn into 2 X 4 nominal lumber according to the best rotation angle and the other half according to the worst rotation angle. The resulting pieces of lumber were first visually graded according to the knots and then according to all defects, followed by dynamic MOE testing and finally tested to destruction using a third-point standard bending procedure. The results demonstrate that there was little difference in visual grades between the "best" and "worst" groups and that knots played a minimal role in grade determination of the boards. However, there was significant difference in terms of MOE values, where the group of "best" boards showed an overall 15% increase over the "worst" boards. This result significantly impacts the potential MSR yield of the sample pieces of lumber. Bending tests showed a lurther 25% difference in average MOR between the two groups. These results suggest that there is potential for black spruce to yield higher strength lumber when knots are considered during breakdown. Further refinements should include a model that determines quality in terms of knot position within the board section rather than one that determines quality in terms of potential visual grades

Experimental results and first 22Na source image reconstruction by two prototype modules in coincidence of a liquid xenon positron emission tomograph for small animal imaging

International audienceA detector with a very specific design using liquid Xenon (LXe) in the scintillation mode is studied for Positron Emission Tomography (PET) of small animals. Two prototype modules equipped with Position Sensitive Photo Multiplier Tubes (PSPMTs) operating in the VUV range (178 nm) and at 165 K were built and studied in coincidence. This paper reports on energy, time and spatial resolution capabilities of this experimental test bench. Furthermore, these experimental results were used to perform the first image reconstruction of a 22Na source placed in the experimental setup

A liquid Xenon Positron Emission Tomograph for small animal imaging : first experimental results of a prototype cell

A detector using liquid Xenon (LXe) in the scintillation mode is studied for Positron Emission Tomography (PET) of small animals. Its specific design aims at taking full advantage of the Liquid Xenon scintillation properties. This paper reports on energy, time and spatial resolution capabilities of the first LXe prototype module equipped with a Position Sensitive Photo- Multiplier tube (PSPMT) operating in the VUV range (178 nm) and at 165 K. The experimental results show that such a LXe PET configuration might be a promising solution insensitive to any parallax effect.Comment: 34 pages, 18 pages, to appear in NIM

Design and construction of a Cherenkov imager for charge measurement of nuclear cosmic rays

A proximity focusing Cherenkov imager called CHERCAM, has been built for the charge measurement of nuclear cosmic rays with the CREAM instrument. It consists of a silica aerogel radiator plane across from a detector plane equipped with 1,600 1" diameter photomultipliers. The two planes are separated by a ring expansion gap. The Cherenkov light yield is proportional to the charge squared of the incident particle. The expected relative light collection accuracy is in the few percents range. It leads to an expected single element separation over the range of nuclear charge Z of main interest 1 < Z < 26. CHERCAM is designed to fly with the CREAM balloon experiment. The design of the instrument and the implemented technical solutions allowing its safe operation in high altitude conditions (radiations, low pressure, cold) are presented.Comment: 24 pages, 19 figure

Does document relevance affect the searcher's perception 0f time?

Time plays an essential role in multiple areas of Information Retrieval (IR) studies such as search evaluation, user behavior analysis, temporal search result ranking and query understanding. Especially, in search evaluation studies, time is usually adopted as a measure to quantify users' efforts in search processes. Psychological studies have reported that the time perception of human beings can be affected by many stimuli, such as attention and motivation, which are closely related to many cognitive factors in search. Considering the fact that users' search experiences are affected by their subjective feelings of time, rather than the objective time measured by timing devices, it is necessary to look into the different factors that have impacts on search users' perception of time. In this work, we make a first step towards revealing the time perception mechanism of search users with the following contributions: (1) We establish an experimental research framework to measure the subjective perception of time while reading documents in search scenario, which originates from but is also different from traditional time perception measurements in psychological studies. (2) With the framework, we show that while users are reading result documents, document relevance has small yet visible effect on search users' perception of time. By further examining the impact of other factors, we demonstrate that the effect on relevant documents can also be influenced by individuals and tasks. (3) We conduct a preliminary experiment in which the difference between perceived time and dwell time is taken into consideration in a search evaluation task. We found that the revised framework achieved a better correlation with users' satisfaction feedbacks. This work may help us better understand the time perception mechanism of search users and provide insights in how to better incorporate time factor in search evaluation studies

Multiple-look effects on temporal discrimination within sound sequences

The multiple-look notion holds that the difference limen (DL) decreases with multiple observations. We investigated this notion for temporal discrimination in isochronous sound sequences. In Experiment 1, we established a multiple-look effect when sequences comprised nine standard time intervals (S) followed by an increasing number of comparison time intervals (C), but no multiple-look effect when one trailing C interval was preceded by an increasing number of S intervals. In Experiment 2, we extended the design. There were four sequential conditions: (a) 9 leading S intervals followed by 1, 2, …, or 9 C-intervals; (b) 9 leading C intervals followed by 1, 2, …, or 9 S intervals; (c) 9 trailing C-intervals preceded by 1, 2, …, or 9 S-intervals; and (d) 9 trailing S-intervals preceded by 1, 2, …, or 9 C-intervals. Both the interval accretions before and after the tempo change caused multiple-look effects, irrespective of the time order of S and C. Complete deconfounding of the number of intervals before and after the tempo change was accomplished in Experiment 3. The multiple-look effect of interval accretion before the tempo change was twice as big as that after the tempo change. The diminishing returns relation between the DL and interval accretion could be described well by a reciprocal function

Visual onset expands subjective time

We report a distortion of subjective time perception in which the duration of a first interval is perceived to be longer than the succeeding interval of the same duration. The amount of time expansion depends on the onset type defining the first interval. When a stimulus appears abruptly, its duration is perceived to be longer than when it appears following a stationary array. The difference in the processing time for the stimulus onset and motion onset, measured as reaction times, agrees with the difference in time expansion. Our results suggest that initial transient responses for a visual onset serve as a temporal marker for time estimation, and a systematic change in the processing time for onsets affects perceived time

A fuzzy multi-criteria decision making approach for managing performance and risk in integrated procurement-production planning

Nowadays in Supply Chain (SC) networks, a high level of risk comes from SC partners. An effective risk management process becomes as a consequence mandatory, especially at the tactical planning level. The aim of this article is to present a risk-oriented integrated procurement–production approach for tactical planning in a multi-echelon SC network involving multiple suppliers, multiple parallel manufacturing plants, multiple subcontractors and several customers. An originality of the work is to combine an analytical model allowing to build feasible scenarios and a multi-criteria approach for assessing these scenarios. The literature has mainly addressed the problem through cost or profit-based optimisation and seldom considers more qualitative yet important criteria linked to risk, like trust in the supplier, flexibility or resilience. Unlike the traditional approaches, we present a method evaluating each possible supply scenario through performance-based and risk-based decision criteria, involving both qualitative and quantitative factors, in order to clearly separate the performance of a scenario and the risk taken if it is adopted. Since the decision-maker often cannot provide crisp values for some critical data, fuzzy sets theory is suggested in order to model vague information based on subjective expertise. Fuzzy Technique for Order of Preference by Similarity to Ideal Solution is used to determine both the performance and risk measures correlated to each possible tactical plan. The applicability and tractability of the proposed approach is shown on an illustrative example and a sensitivity analysis is performed to investigate the influence of criteria weights on the selection of the procurement–production plan