Development of a unique laboratory standard indium gallium arsenide detector for the 500 to 1700 micron spectral region, phase 2

In the course of this work, 5 mm diameter InGaAs pin detectors were produced which met or exceeded all of the goals of the program. The best results achieved were: shunt resistance of over 300 K ohms; rise time of less than 300 ns; contact resistance of less than 20 ohms; quantum efficiency of over 50 percent in the 0.5 to 1.7 micron range; and devices were maintained and operated at 125 C without deterioration for over 100 hours. In order to achieve the goals of this program, several major technological advances were realized, among them: successful design, construction and operation of a hydride VPE reactor capable of growing epitaxial layers on 2 inch diameter InP substrates with a capacity of over 8 wafers per day; wafer processing was upgraded to handle 2 inch wafers; a double layer Si3N4/SiO2 antireflection coating which enhances response over the 0.5 to 1.7 micron range was developed; a method for anisotropic, precisely controlled CH4/H2 plasma etching for enhancement of response at short wavelengths was developed; and electronic and optical testing methods were developed to allow full characterization of detectors with size and spectral response characteristics. On the basis of the work and results achieved in this program, it is concluded that large size, high shunt resistance, high quantum efficiency InGaAs pin detectors are not only feasible but also manufacturable on industrial scale. This device spans a significant portion of visible and near infrared spectral range and it will allow a single detector to be used for the 0.5 to 1.7 micron spectral region, rather than the presently used silicon (for 0.5 to 1.1 microns) and germanium (0.8 to 1.7 microns)

Propfan experimental data analysis

A data reduction method, which is consistent with the performance prediction methods used for analysis of new aircraft designs, is defined and compared to the method currently used by NASA using data obtained from an Ames Res. Center 11 foot transonic wind tunnel test. Pressure and flow visualization data from the Ames test for both the powered straight underwing nacelle, and an unpowered contoured overwing nacelle installation is used to determine the flow phenomena present for a wind mounted turboprop installation. The test data is compared to analytic methods, showing the analytic methods to be suitable for design and analysis of new configurations. The data analysis indicated that designs with zero interference drag levels are achieveable with proper wind and nacelle tailoring. A new overwing contoured nacelle design and a modification to the wing leading edge extension for the current wind tunnel model design are evaluated. Hardware constraints of the current model parts prevent obtaining any significant performance improvement due to a modified nacelle contouring. A new aspect ratio wing design for an up outboard rotation turboprop installation is defined, and an advanced contoured nacelle is provided

Effect of Humic Acid on Adsorption of Polychlorinated Biphenyls onto Organoclay

Mitigation of risks stemming from contaminated sediments in freshwater and estuarine environments remains an important challenge to the field of environmental science and engineering. Capping sediments with reactive materials is one approach that has recently been the subject of research and development. This research evaluated the use of organoclay as a sorbent in a reactive cap for in situ remediation of contaminated sediments, and provides an original contribution by presenting the sorption characteristics of individual polychlorinated biphenyls (PCB) congeners in the presence of high concentrations of humic acids typical of sediment porewater environments. Sorption of coplanar and noncoplanar PCBs on three commercially available organoclays was studied in this work. Studies were conducted to evaluate the kinetics of adsorption of PCBs on organoclay and to determine the effect of humic acid on the kinetics of adsorption. Isotherm studies were conducted to determine the adsorption affinity of PCBs for organoclays in the presence and absence of humic acid. Studies showed a 45 to 96% reduction in the sorption affinity for organoclays after preloading with high concentrations of humic acid, depending both on the congener and the composition of organoclay. Desorption of PCBs upon addition of humic acid after PCBs were equilibrated with organoclay was statistically significant, although the magnitude of the effect was much smaller than that observed from preloading of humic acid

Evaluation of Activated Carbon as a Reactive Cap Sorbent for Sequestration of PCBs in Presence of Humic Acid

This study investigated the interferences caused by high humic acid concentrations on the adsorption of coplanar and noncoplanar polychlorinated biphenyls (PCBs) on coconut shell activated carbon. In particular, the research focuses on the application of activated carbon as a reactive cap for contaminated sediment sites, a possible intervention to reduce contaminant flux through pore water, and to organisms in aquatic environments. Kinetic and equilibrium studies were conducted using activated carbon as a sorbent for individual PCB congeners including BZ 1, 52, 77, 153, and 169, respectively, in the presence and absence of humic acid. Results showed that preloading of activated carbon with humic acid significantly reduced the adsorption affinity for all selected PCB congeners. Experiments conducted without preloading of activated carbon demonstrated that desorption upon subsequent spiking with humic acid (simulating long-term exposure to pore water that contains high humic acid concentrations) was not found to be statistically significant, and varied with coplanarity of PCBs. Results provide important information for the design of reactive caps in sediments where high concentrations of dissolved organic carbon are found, and highlight the importance of considering site conditions when designing effective reactive caps

Genetic modifiers of cognitive maintenance among older adults.

ObjectiveIdentify genetic factors associated with cognitive maintenance in late life and assess their association with gray matter (GM) volume in brain networks affected in aging.MethodsWe conducted a genome-wide association study of ∼2.4 M markers to identify modifiers of cognitive trajectories in Caucasian participants (N = 7,328) from two population-based cohorts of non-demented elderly. Standardized measures of global cognitive function (z-scores) over 10 and 6 years were calculated among participants and mixed model regression was used to determine subject-specific cognitive slopes. "Cognitive maintenance" was defined as a change in slope of ≥ 0 and was compared with all cognitive decliners (slope < 0). In an independent cohort of cognitively normal older Caucasians adults (N = 122), top association findings were then used to create genetic scores to assess whether carrying more cognitive maintenance alleles was associated with greater GM volume in specific brain networks using voxel-based morphometry.ResultsThe most significant association was on chromosome 11 (rs7109806, P = 7.8 × 10(-8)) near RIC3. RIC3 modulates activity of α7 nicotinic acetylcholine receptors, which have been implicated in synaptic plasticity and beta-amyloid binding. In the neuroimaging cohort, carrying more cognitive maintenance alleles was associated with greater volume in the right executive control network (RECN; PFWE  = 0.01).ConclusionsThese findings suggest that there may be genetic loci that promote healthy cognitive aging and that they may do so by conferring robustness to GM in the RECN. Future work is required to validate top candidate genes such as RIC3 for involvement in cognitive maintenance

From Black Strings to Black Holes

Using recently developed numerical methods, we examine neutral compactified non-uniform black strings which connect to the Gregory-Laflamme critical point. By studying the geometry of the horizon we give evidence that this branch of solutions may connect to the black hole solutions, as conjectured by Kol. We find the geometry of the topology changing solution is likely to be nakedly singular at the point where the horizon radius is zero. We show that these solutions can all be expressed in the coordinate system discussed by Harmark and Obers.Comment: 6 pages, 5 figures, RevTe

Fate of the Black String Instability

Gregory and Laflamme showed that certain nonextremal black strings (and p-branes) are unstable to linearized perturbations. It is widely believed that this instability will cause the black string horizon to classically pinch off and then quantum mechanically separate, resulting in higher dimensional black holes. We argue that this cannot happen. Under very mild assumptions, classical event horizons cannot pinch off. Instead, they settle down to new static black string solutions which are not translationally invariant along the string.Comment: 11 pages, v2: few clarifications and references adde