Measurements of a rotor flow in ground effect and visualization of the brown-out phenomenon

Quantitative and qualitative results of a series of experiments conducted on a rotor in ground effect at low forward speeds are presented. The velocity over a wide area of the ground effect wake was measured using Particle Image Velocimetry (PIV), and the evolution of the flow is described as the forward speed increases. Helicopter brown-out was simulated through a series of flow visualisation experiments. The technique involved sprinkling a fine powder on the ground below and ahead of the rotor. This helps to validate the experimental simulation of the brown-out phenomenon. Larger dust clouds were observed at lower advance ratio, and the dust cloud penetrated into the areas of the flow including those where vorticity levels were of low or negligible magnitude

Parameter estimation applied to Nimbus 6 wide-angle longwave radiation measurements

A parameter estimation technique was used to analyze the August 1975 Nimbus 6 Earth radiation budget data to demonstrate the concept of deconvolution. The longwave radiation field at the top of the atmosphere is defined from satellite data by a fifth degree and fifth order spherical harmonic representation. The variations of the major features of the radiation field are defined by analyzing the data separately for each two-day duty cycle. A table of coefficient values for each spherical harmonic representation is given along with global mean, gradients, degree variances, and contour plots. In addition, the entire data set is analyzed to define the monthly average radiation field

Simulation study of a geometric shape factor technique for estimating earth-emitted radiant flux densities from wide-field-of-view radiation measurements

Geometric shape factors were computed and applied to satellite simulated irradiance measurements to estimate Earth emitted flux densities for global and zonal scales and for areas smaller than the detector field of view (FOV). Wide field of view flat plate detectors were emphasized, but spherical detectors were also studied. The radiation field was modeled after data from the Nimbus 2 and 3 satellites. At a satellite altitude of 600 km, zonal estimates were in error 1.0 to 1.2 percent and global estimates were in error less than 0.2 percent. Estimates with unrestricted field of view (UFOV) detectors were about the same for Lambertian and limb darkening radiation models. The opposite was found for restricted field of view detectors. The UFOV detectors are found to be poor estimators of flux density from the total FOV and are shown to be much better as estimators of flux density from a circle centered at the FOV with an area significantly smaller than that for the total FOV

Assessment of casting filling by modeling surface entrainment events using CFD

The reliability of cast components is dependent on the quality of the casting process. During this highly transient filling phase the prevention of free surface turbulence and consequential oxide entrainment is critical to ensure the mechanical integrity of the component. Past research has highlighted a number of events that lead to entrainment of surface oxides. Using FLOW-3D, flow structures that result in surface entrainment events have been simulated and an algorithm developed that allows entrainment and defect motion to be tracked. This enables prediction of the quantity and motion of oxide film generated from each event. The algorithm was tested experimentally and compared to experimental data from previously published work. A quantitative criterion is proposed to assess the damage of each type of event. Complete running systems have also been studied to understand how they could be assessed for quality of filling based on the flows within them

Time-fixed rendezvous by impulse factoring with an intermediate timing constraint

A method is presented for factoring a two-impulse orbital transfer into a three- or four-impulse transfer which solves the rendezvous problem and satisfies an intermediate timing constraint. Both the time of rendezvous and the intermediate time of a alinement are formulated as any element of a finite sequence of times. These times are integer multiples of a constant plus an additive constant. The rendezvous condition is an equality constraint, whereas the intermediate alinement is an inequality constraint. The two timing constraints are satisfied by factoring the impulses into collinear parts that vectorially sum to the original impulse and by varying the resultant period differences and the number of revolutions in each orbit. Five different types of solutions arise by considering factoring either or both of the two impulses into two or three parts with a limit for four total impulses. The impulse-factoring technique may be applied to any two-impulse transfer which has distinct orbital periods

The modelling of oxide film entrainment in casting systems using computational modelling

As Campbell stated in 2006, “the use of entrainment models to optimise filling systems designs for castings has huge commercial potential that has so far being neglected by modellers”. In this paper a methodology using computational modelling to define entraining events and track the entrained oxide films is presented. Research has shown that these oxide films present within the casting volume are highly detrimental to casting integrity, thus their entrainment during mould filling is especially undesirable. The method developed for the modelling of oxide entrainment has been validated against previously published data by Green and Campbell (1994) [31]. The validation shows good quantitative correlation with experimental data. However there is scope for further development which has the potential to both improve the accuracy and further validate the technique

Millimeter wave experiment for ATS-F

A detailed description of spaceborne equipment is provided. The equipment consists of two transmitters radiating signals at 20 and 30 GHz from either U.S. coverage horn antennas or a narrow beam parabolic antenna. Three modes of operation are provided: a continuous wave mode, a multitone mode in which nine spectral lines having 180 MHz separation and spaced symmetrically about each carrier, and a communications mode in which communications signals from the main spacecraft transponder are modulated on the two carriers. Detailed performance attained in the flight/prototype model of the equipment is presented both under laboratory conditions and under environmental extremes. Provisions made for ensuring reliability in space operation are described. Also described the bench test equipment developed for use with the experiment, and a summary of the new technology is included

Deconvolution and analysis of wide-angle longwave radiation data from Nimbus 6 Earth radiation budget experiment for the first year

One year of longwave radiation data from July 1975 through June 1976 from the Nimbus 6 satellite Earth radiation budget experiment is analyzed by representing the radiation field by a spherical harmonic expansion. The data are from the wide field of view instrument. Contour maps of the longwave radiation field and spherical harmonic coefficients to degree 12 and order 12 are presented for a 12 month data period

Modification of an impulse-factoring orbital transfer technique to account for orbit determination and maneuver execution errors

A method has previously been developed to satisfy terminal rendezvous and intermediate timing constraints for planetary missions involving orbital operations. The method uses impulse factoring in which a two-impulse transfer is divided into three or four impulses which add one or two intermediate orbits. The periods of the intermediate orbits and the number of revolutions in each orbit are varied to satisfy timing constraints. Techniques are developed to retarget the orbital transfer in the presence of orbit-determination and maneuver-execution errors. Sample results indicate that the nominal transfer can be retargeted with little change in either the magnitude (Delta V) or location of the individual impulses. Additonally, the total Delta V required for the retargeted transfer is little different from that required for the nominal transfer. A digital computer program developed to implement the techniques is described