EAST - WEST CROSS DRIFT STARTER TUNNEL LAYOUT ANALYSIS

The purpose of this analysis is to develop a layout configuration and location for the E-W Cross Drift with the objective to meet repository, testing, and construction requirements

Measurement of Synchrotron x-ray energies and line shapes using diffraction markers

Standard reference markers for accurate, reproducible synchrotron x-ray energies are obtained using a three Si crystal spectrometer. The first two crystals are in the monochromator and the third is used to obtain diffraction markers which monitor the energy. Then for any value of the glancing angle on the reference Si crystal the energy for the (333) diffraction must occur at 3/4 that of the (444) and 3/5 of that for the (555). This establishes for the first time an absolute synchrotron energy scale. Higher-order diffractions are used to determine excitation line profiles. We conclude that the use of reference diffractions is necessary to measure reproducible x-ray energies and to analyze the incident photons\u27 line profile. The detection of diffractions near the edge of measurement and near the Cu edge will provide a fast secondary standard which will allow comparison of edge data between different laboratories. The diffraction profiles will allow the proper analysis of spectral line widths

Technical WOrk Plan for: Construction Effects Monitoring

This document is the technical work plan (TWP) for performing the Construction Effects Monitoring (CEM) activity, which is one of 20 testing and monitoring activities included in Performance Confirmation Plan (BSC 2004 [DIRS 172452]). Collectively, the 20 activities make up the Performance Confirmation Program described in the plan. Each of the other 19 activities will have a separate TWP. This plan, though titled Construction Effects Monitoring, in accordance with the Performance Confirmation Plan, also includes testing that may be performed in addition to monitoring, if required. Performance confirmation is required by regulation 10 CFR Part 63 [DIRS 173273], and was started during site characterization (consistent with the regulation) and will continue until permanent closure of the repository (10 CFR 63.13 1 (b) [DIRS 173273]). This CEM activity has two primary goals: (1) to collect, analyze, and report on repository rock properties data for the purpose of confirming geotechnical and design parameters used in repository design, and (2) to provide information intended to confirm that the ability to retrieve waste from the repository has been preserved. It will be necessary for information from this CEM activity to be evaluated in combination with that obtained from other Performance Confirmation Program activities to achieve these goals. These relationships with other Performance Confirmation Program activities (e.g., drift inspection, subsurface mapping, and seismicity monitoring) will be discussed in later sections of this TWP

Early Mesozoic Paleotectonic-Paleogeographic Reconstruction of Southern Sierra Nevada Region

A paleotectonic-paleogeographic reconstruction was based on structural, petrologic, and geochronologic studies of pre-Sierra Nevada batholith framework rocks exposed between the San Joaquin River and the Garlock fault. Most available fossil data from roof pendants of this region indicate Late Triassic to Early Jurassic ages. An additional fossil locality from the western wall rocks yields a Late Permian Tethyan fauna. This is a maximum age for the enclosing rocks, for the fossils are in a limestone olistolith. As yet there is no sign of Paleozoic strata in the region except perhaps along the eastern Sierran crest in small metamorphic septa, and in the western foothills where ophiolitic rocks are present

Limitations of decomposition-based imaging of longitudinal absorber configurations

We examine theoretically and experimentally an imaging scheme that uses the transverse intensity profile of the scattered light to reconstruct the locations of absorbers embedded in a turbid medium. This method is based on an a priori knowledge of the scattered light patterns associated with a single absorber that is located at various positions inside the medium. We discuss the range of validity of this method, and its sensitivity with regard to noise, and propose an algorithm to improve its accuracy

Decomposition-based recovery of absorbers in turbid media

We suggest that the concept of the point-spread function traditionally used to predict the blurred image pattern of various light sources embedded inside turbid media can be generalized under certain conditions to predict also the presence and location of spatially localized absorbing inhomogeneities based on shadow point-spread functions associated with each localized absorber in the medium. The combined image obtained from several absorbers can then be decomposed approximately into the arithmetic sums of these individual shadow point-spread functions with suitable weights that can be obtained from multiple-regression analysis. This technique permits the reconstruction of the location of absorbers

Identifying a Test to Monitor Weightlifting Performance in Competitive Male and Female Weightlifters

Monitoring tests are commonly used to assess weightlifter’s preparedness for competition. Although various monitoring tests have been used, it is not clear which test is the strongest indicator of weightlifting performance. Therefore, the purpose of this study was to (1) determine the relationships between vertical jump, isometric mid-thigh pull (IMTP) and weightlifting performance; and (2) compare vertical jumps to IMTP as monitoring tests of weightlifting performance in a large cohort of male and female weightlifters. Methods: Fifty-two competitive weightlifters (31 males, 21 females) participated in squat and countermovement jump testing (SJ, CMJ), and IMTP testing performed on force plates. All laboratory testing data was correlated to a recent competition where the athletes had attempted to peak. Results: Squat jump height (SJH) was the strongest correlate for men and women with the Sinclair Total (r = 0.686, p ≤ 0.01; r = 0.487, p ≤ 0.05, respectively) compared to countermovement jump height (r = 0.642, p ≤ 0.01; r = 0.413, p = 0.063), IMTP peak force allometrically scaled to body mass (r = 0.542, p ≤ 0.01; r = −0.044, p = 0.851) and rate of force development at 200 ms (r = 0.066, p = 0.723; r = 0.086, p = 0.711), respectively. Further, SJH was a stronger correlate of relative weightlifting performance compared to IMTP peak force in females (p = 0.042), but not male weightlifters (p = 0.191). Conclusions: Although CMJ and IMTP are still considered strong indicators of weightlifting performance, SJH appears to be the most indicative measure of weightlifting performance across a wide-range of performance levels. Thus, SJH can be used as a reliable measure to monitor weightlifting performance in male and female weightlifters

Assessment Practices and Experiences of Sex Trafficking in Caseloads of Service Providers Working with High Risk Youth in Indiana

With increased recognition of sex trafficking, calls have been made for greater identification and screening. Lack of awareness and assessment likely contribute to low identification of sex trafficking victims. The present study examined assessment practices, confidence in detecting trafficking, and experiences with DMST survivors in the caseloads of service providers in the past year. Employees at high-risk settings were recruited, resulting in a sample of 76 providers representing 21 agencies. Data revealed that while general risk factors were typically assessed, sex trafficking-specific risk factors and experiences were assessed less often. Approximately 30% of participants indicated they worked with at least one sex trafficking victim in the past year. However, 44% of participants indicated low confidence in detection. Approximately 23% of participants had completed sex trafficking training, but few differences emerged between those with and without prior training. Increased training, assessment, and evaluations of the effectiveness of training programs are recommended

Nudges and other moral technologies in the context of power: Assigning and accepting responsibility

Strawson argues that we should understand moral responsibility in terms of our practices of holding responsible and taking responsibility. The former covers what is commonly referred to as backward-looking responsibility , while the latter covers what is commonly referred to as forward-looking responsibility . We consider new technologies and interventions that facilitate assignment of responsibility. Assigning responsibility is best understood as the second- or third-personal analogue of taking responsibility. It establishes forward-looking responsibility. But unlike taking responsibility, it establishes forward-looking responsibility in someone else. When such assignments are accepted, they function in such a way that those to whom responsibility has been assigned face the same obligations and are susceptible to the same reactive attitudes as someone who takes responsibility. One family of interventions interests us in particular: nudges. We contend that many instances of nudging tacitly assign responsibility to nudgees for actions, values, and relationships that they might not otherwise have taken responsibility for. To the extent that nudgees tacitly accept such assignments, they become responsible for upholding norms that would otherwise have fallen under the purview of other actors. While this may be empowering in some cases, it can also function in such a way that it burdens people with more responsibility that they can (reasonably be expected to) manage

Charge radii and structural evolution in Sr, Zr, and Mo isotopes

The evolution of the ground-state nuclear shapes in neutron-rich Sr, Zr, and Mo isotopes, including both even-even and odd-A nuclei, is studied within a self-consistent mean-field approximation based on the D1S Gogny interaction. Neutron separation energies and charge radii are calculated and compared with available data. A correlation between a shape transition and a discontinuity in those observables is found microscopically. While in Sr and Zr isotopes the steep behavior observed in the isotopic dependence of the charge radii is a consequence of a sharp prolate-oblate transition, the smooth behavior found in Mo isotopes has its origin in an emergent region of triaxiality.Comment: 6 pages, 7 figures, to be published in Phys. Lett.