3,844 research outputs found
Gamble mode: Resonance contact mode in atomic force microscopy
Active noise reduction has been accomplished in atomic force microscopy by applying a high frequency, low amplitude vibration to the cantilever while it is in contact with a surface. The applied excitation (>~ 200 kHz; ~ 1 nm) is acoustically coupled to the tip and dampens the resonance Q factors of the system. The applied frequency is well above the bandwidth of the acquisition system (50 kHz). We call this mode "gamble mode" or "resonance contact.
Noise reduction in atomic force microscopy: Resonance contact mode
Noise reduction has been accomplished in atomic force microscopy by applying a high frequency, low amplitude vibration to the cantilever while it is in contact with a surface. The applied excitation (>~200 kHz; ~1 nm) is acoustically coupled to the tip and dampens the resonance Q factors of the system. The applied frequency is well above the bandwidth of the acquisition system (50 kHz). We call this mode "resonance contact" mode. The nonlinear behavior of the tip–sample interaction allows the high frequency excitation to effectively broaden the frequency response of the system resonances
Remotely controlled mirror of variable geometry for small angle x-ray diffraction with synchrotron radiation
A total-reflecting mirror of 120-cm length was designed and built to focus synchrotron radiation emanating from the electron-positron storage ring at the Stanford Linear Accelerator Center (SPEAR). The reflecting surface is of
unpolished float glass. The bending and tilt mechanism allows very fine control of the curvature and selectability of the critical angle for wavelengths ranging from 0.5 to 3.0 Å. Elliptical curvature is used to minimize aberrations. The mirror is placed asymmetrically onto the ellipse so as to achieve a tenfold demagnification of the source. The bending mechanism reduces nonelastic
deformation (flow) and minimizes strains and stresses in the glass despite its length. Special design features assure stability of the focused image. The mirror
reduces the intensity of shorter wavelength harmonics by a factor of approximately 100
ERTS-1 applications to Minnesota land use mapping
Land use class definitions that can be operationally employed with ERTS-1 imagery are being developed with the cooperation of personnel from several state, regional, and federal agencies with land management responsibilities within the state and the University of Minnesota. Investigations of urban, extractive, forest, and wetlands areas indicate that it is feasible to subdivide each of these classes into several sub-classes with the use of ERTS-1 images from one or more time periods
Calcium supplements and cancer risk : a meta-analysis of randomised controlled trials
Peer reviewedPublisher PD
Effect of calcium supplements on risk of myocardial infarction and cardiovascular events : meta-analysis
Peer reviewedPublisher PD
Cooling of cryogenic electron bilayers via the Coulomb interaction
Heat dissipation in current-carrying cryogenic nanostructures is problematic
because the phonon density of states decreases strongly as energy decreases. We
show that the Coulomb interaction can prove a valuable resource for carrier
cooling via coupling to a nearby, cold electron reservoir. Specifically, we
consider the geometry of an electron bilayer in a silicon-based
heterostructure, and analyze the power transfer. We show that across a range of
temperatures, separations, and sheet densities, the electron-electron
interaction dominates the phonon heat-dissipation modes as the main cooling
mechanism. Coulomb cooling is most effective at low densities, when phonon
cooling is least effective in silicon, making it especially relevant for
experiments attempting to perform coherent manipulations of single spins.Comment: 9 pages, 5 figure
Transport Properties of Carbon Nanotube C Peapods
We measure the conductance of carbon nanotube peapods from room temperature
down to 250mK. Our devices show both metallic and semiconducting behavior at
room temperature. At the lowest temperatures, we observe single electron
effects. Our results suggest that the encapsulated C molecules do not
introduce substantial backscattering for electrons near the Fermi level. This
is remarkable given that previous tunneling spectroscopy measurements show that
encapsulated C strongly modifies the electronic structure of a nanotube
away from the Fermi level.Comment: 9 pages, 4 figures. This is one of two manuscripts replacing the one
orginally submitted as arXiv:cond-mat/0606258. The other one is
arXiv:0704.3641 [cond-mat
Calculation of Spectral Degradation Due to Contaminant Films on Infrared and Optical Sensors
Molecular surface contaminants can cause degradation of optical systems, especially if the contaminants exhibit strong absorption bands in the region of interest. Different strategies for estimation of spectral degradation responses due to uniform films for various types of systems are reviewed. One tool for calculating the effects of contaminant film thickness on signal degradation in the mid IR region is the simulation program CALCRT. The CALCRT database will be reviewed to correlate spectral n and k values associated with specific classes of organic functional groups. Various schemes are also investigated to estimate the spectral degradation in the UV-Vis region. Experimental measurements of reflectance changes in the IR to UV-Vis regions due to specific contaminants will be compared. Approaches for estimating changes in thermal emissivity and solar absorptivity will also be discussed
- …