227 research outputs found
Carbon molecular sieve membranes for selective CO2 separation at elevated temperatures and pressures
The use of Carbon Molecular Sieve Membranes (CMSM) for selective CO2 separation from post-combustion CO2-rich streams from steel plant was experimentally evaluated and reported in this paper. Efficient CMSMs were developed for such application and their promising potentials in operating at elevated temperatures and pressures were experimentally demonstrated. The best performance in terms of flux as well as perm-selectivity, above the Robeson upper bound, was obtained using a CMSM developed with ethylenediamine in the dip-coating stage of the fabrication. In fact, adding ethylenediamine was proven to be particularly important in narrowing down the pore size distribution to ultra-micropore and establishing effective CO2 adsorption site over the membrane surface and the pores wall. It was shown that using a tailored CMSM with a precursor synthesized by co-polymerization of ethylenediamine with Novolac can improve the CO2/N2 ideal perm-selectivity from 33 to 97 at operational conditions of 200 °C and 20 bar.The project has received funding through the NWO P16-10 project
Continuous thickening of activated sludge by electro-flotation
The present study was conducted for thickening of activated sludge by continuous electro-flotation (EF) process. The effects of some key factors such as initial pH, current density, operating time, electrode type (stainless steel and graphite) and operation conditions on the sludge thickening by determine of sludge volume reduction (SVR) and sludge solid concentration (SSC) and as well as removal of chemical oxygen demand (COD), total solids (TS), total suspended solids (TSS) and color were investigated. The results showed that the process has a good efficiency. The highest amount of SVR efficiency (89.3) and SSC (38 g L-1) were achieved at current density of 8 mA cm(-2) in 15 min for stainless steel. Moreover, as surface/volume ratio increased, better thickening happened because increases both mass transfer and electro-generation of O-2 and H-2 at the surface of electrodes in low applied current density. Accordingly, consumed electrical energy was 0.15-1 kW h m(-3). Although suitable cell design is entirely essential, the use of chemicals and temperature increase are not effective. Consequently, EF is a comparatively appropriate process for thickening; in the water separated from the process, the amounts pertaining to COD, TS, TSS and color were respectively 112, 1601, 140 mg L-1 and 5 TCU which are useable for subsequent different consumptions. Crown Copyright (C) 2013 Published by Elsevier B.V. All rights reserved
Multi‐scale studies of 3d printed Mn–Na–W/SiO2 catalyst for oxidative coupling of methane
This work presents multi-scale approaches to investigate 3D printed structured Mn–Na–W/SiO_{2} atalysts used for the oxidative coupling of methane (OCM) reaction. The performance of the 3D printed catalysts has been compared to their conventional analogues, packed beds of pellets and powder. The physicochemical properties of the 3D printed catalysts were investigated using scanning electron microscopy, nitrogen adsorption and X-ray diffraction (XRD). Performance and durability tests of the 3D printed catalysts were conducted in the laboratory and in a miniplant under real reaction conditions. In addition, synchrotron-based X-ray diffraction computed tomography technique (XRD-CT) was employed to obtain cross sectional maps at three different positions selected within the 3D printed catalyst body during the OCM reaction. The maps revealed the evolution of catalyst active phases and silica support on spatial and temporal scales within the interiors of the 3D printed catalyst under operating conditions. These results were accompanied with SEM-EDS analysis that indicated a homogeneous distribution of the active catalyst particles across the silica support
Municipal solid waste management during COVID-19 pandemic: a comparison between the current activities and guidelines
The COVID-19 pandemic has affected everyone�s lifestyle and this has resulted in a change in the quantity and composition of municipal solid wastes. Moreover, the post-pandemic waste management is very important as a bad management may lead to the more spread of the disease. The objective of this study was to evaluate the application of guidelines presented for the era of the COVID-19 pandemic in proper solid waste management. To this end, the data were collected by using interviews and field researches and then the obtained data were compared with the international guidelines presented by international organizations. By investigating the municipal waste management during this pandemic and its changes compared to pre-COVID-19, coordination of the plans with the guidelines was investigated. The activities of storage, collection, transportation, recycling, final landfill, as well as the observation of the health instructions by staff and informal sections were assessed in the current research. Although the results showed that the situation was satisfactory in the sections like health and safety of waste management operators due to the existence of protocols and general educations, the waste management plans have not been changed much from before the epidemic of the Coronavirus. The absence of a national policy and plan for waste management in the era of a pandemic and ignoring the guidelines developed by other countries and organizations were observable. Therefore, the codification of new policies for municipal waste management during an epidemic is necessary. © 2021, Springer Nature Switzerland AG
Study of littered wastes in different urban land-uses: An 6 environmental status assessment
Littered waste is a severe environmental problem. Although there have been many studies on wastes littered in the environments like beaches and seas, there is insufficient information on littered wastes in the urban settings. In this research, employing visual survey by the field litter counts method, littered wastes in six urban land uses in Qazvin, Iran were studied. The results showed that administrative and recreational land uses, by an average of 5.22 and 9.59 items per 100 m, respectively, had the lowest pollution, while low-density commercial land use had the maximum pollution by 185.96 items per 100 m. Urban littered waste ratios were not the same in various land uses: cigarette waste and paper and cardboard accounted for higher than 80 of the whole littered wastes in most studied land uses. The cigarette butt was also the most frequently litter in the city. In terms of environmental status, administrative and recreational areas can be defined as places with good conditions, while low-density commercial land use had bad conditions. Consequently, urban land use was acknowledged as a significant factor in the density of littered waste. More attention to cleaning the commercial land use to reduce the density of littered waste, and also finding methods to decrease littering waste by citizens, is a need in urban environment. © 2020, Springer Nature Switzerland AG
Set optimization - a rather short introduction
Recent developments in set optimization are surveyed and extended including
various set relations as well as fundamental constructions of a convex analysis
for set- and vector-valued functions, and duality for set optimization
problems. Extensive sections with bibliographical comments summarize the state
of the art. Applications to vector optimization and financial risk measures are
discussed along with algorithmic approaches to set optimization problems
Co-encapsulation of pancreatic islets and pentoxifylline in alginate-based microcapsules with enhanced immunosuppressive effects
Estrogen- and Progesterone (P4)-Mediated Epigenetic Modifications of Endometrial Stromal Cells (EnSCs) and/or Mesenchymal Stem/Stromal Cells (MSCs) in the Etiopathogenesis of Endometriosis
Endometriosis is a common chronic inflammatory condition in which endometrial tissue appears outside the uterine cavity. Because ectopic endometriosis cells express both estrogen and progesterone (P4) receptors, they grow and undergo cyclic proliferation and breakdown similar to the endometrium. This debilitating gynecological disease affects up to 15% of reproductive aged women. Despite many years of research, the etiopathogenesis of endometrial lesions remains unclear. Retrograde transport of the viable menstrual endometrial cells with retained ability for attachment within the pelvic cavity, proliferation, differentiation and subsequent invasion into the surrounding tissue constitutes the rationale for widely accepted implantation theory. Accordingly, the most abundant cells in the endometrium are endometrial stromal cells (EnSCs). These cells constitute a particular population with clonogenic activity that resembles properties of mesenchymal stem/stromal cells (MSCs). Thus, a significant role of stem cell-based dysfunction in formation of the initial endometrial lesions is suspected. There is increasing evidence that the role of epigenetic mechanisms and processes in endometriosis have been underestimated. The importance of excess estrogen exposure and P4 resistance in epigenetic homeostasis failure in the endometrial/endometriotic tissue are crucial. Epigenetic alterations regarding transcription factors of estrogen and P4 signaling pathways in MSCs are robust in endometriotic tissue. Thus, perspectives for the future may include MSCs and EnSCs as the targets of epigenetic therapies in the prevention and treatment of endometriosis. Here, we reviewed the current known changes in the epigenetic background of EnSCs and MSCs due to estrogen/P4 imbalances in the context of etiopathogenesis of endometriosis
Orthogonalities and functional equations
In this survey we show how various notions of orthogonality appear in the theory of functional equations. After introducing some orthogonality relations, we give examples of functional equations postulated for orthogonal vectors only. We show their solutions as well as some applications. Then we discuss the problem of stability of some of them considering various aspects of the problem. In the sequel, we mention the orthogonality equation and the problem of preserving orthogonality. Last, but not least, in addition to presenting results, we state some open problems concerning these topics. Taking into account the big amount of results concerning functional equations postulated for orthogonal vectors which have appeared in the literature during the last decades, we restrict ourselves to the most classical equations
- …