Tailoring strain in SrTiO3 compound by low energy He+ irradiation

The ability to generate a change of the lattice parameter in a near-surface layer of a controllable thickness by ion implantation of strontium titanate is reported here using low energy He+ ions. The induced strain follows a distribution within a typical near-surface layer of 200 nm as obtained from structural analysis. Due to clamping effect from the underlying layer, only perpendicular expansion is observed. Maximum distortions up to 5-7% are obtained with no evidence of amorphisation at fluences of 1E16 He+ ions/cm2 and ion energies in the range 10-30 keV.Comment: 11 pages, 4 figures, Accepted for publication in Europhysics Letter (http://iopscience.iop.org/0295-5075

Synthesis of nanostructured ThO 2 pellets

International audienc

Correction Mesoporous thin film WO3 photoanode for photoelectrochemical water splitting a sol gel dip coating approach

Correction for Mesoporous thin film WO3 photoanode for photoelectrochemical water splitting a sol gel dip coating approach by Samantha Hilliard et al., Sustainable Energy Fuels, 2017, 1, 145 15

Photochemical versus Thermal Synthesis of Cobalt Oxyhydroxide Nanocrystals

Photochemical methods facilitate the generation, isolation, and study of metastable nanomaterials having unusual size, composition, and morphology. These harder-to-isolate and highly reactive phases, inaccessible using conventional high-temperature pyrolysis, are likely to possess enhanced and unprecedented chemical, electromagnetic, and catalytic properties. We report a fast, low-temperature and scalable photochemical route to synthesize very small (~3 nm) monodisperse cobalt oxyhydroxide (Co(O)OH) nanocrystals. This method uses readily and commercially available pentaamminechlorocobalt(III) chloride, [Co(NH3) 5Cl]Cl2, under acidic or neutral pH and proceeds under either near-UV (350 nm) or Vis (575 nm) illumination. Control experiments showed that the reaction proceeds at competent rates only in the presence of light, does not involve a free radical mechanism, is insensitive to O 2, and proceeds in two steps: (1) Aquation of [Co(NH3) 5Cl] 2+ to yield [Co(NH3) 5(H2O)] 3+, followed by (2) slow photoinduced release of NH3 from the aqua complex. This reaction is slow enough for Co(O)OH to form but fast enough so that nanocrystals are small (ca. 3 nm). The alternative dark thermal reaction proceeds much more slowly and produces much larger (~250 nm) polydisperse Co(O)OH aggregates. UV-Vis absorption measurements and ab initio calculations yield a Co(O)OH band gap of 1.7 eV. Fast thermal annealing of Co(O)OH nanocrystals leads to Co3O4 nanocrystals with overall retention of nanoparticle size and morphology. Thermogravimetric analysis shows that oxyhydroxide to mixed-oxide phase transition occurs at significantly lower temperatures (up to T = 64 degrees C) for small nanocrystals compared with the bulk

Influence of calcium on the transport processes in nickel oxide: Consequence in nickel oxidation.

International audienc

Procedures for the refinement of incommensurate structures unsing XND. Coding issues for the refinement of incommensurate structures

International audienc