Spectroscopic properties of Er3+-doped antimony oxide glass

International audienceSpectroscopic properties of Er3+ ions have been studied in the 60Sb2O3-20WO3-19Na2O-1Bi2O3 (SWNB) glasses doped with 0.25 and 0.50 mol% Er2O3 respectively. The Judd-Ofelt parameters measured from the absorption spectra have been used to calculate the radiative life-time (τr) and the stimulated emission cross section. The low phonon energy, a reduced quenching effect and a high quantum efficiency of 90% for the 1.53 μm expected laser emission into pumping at 980 nm are in favor of promising material laser application

Scattering defect in large diameter titanium-doped sapphire crystals grown by the Kyropoulos technique

International audienceThe Kyropoulos technique allows growing large diameter Ti doped sapphire for Chirped pulse amplification laser. A scattering defect peculiar to Kyropoulos grown crystals is presented. This defect is characterized by different techniques: luminescence, absorption measurement, X-ray rocking curve. The impact of this defect to the potential application in chirped pulse amplification CPA laser is evaluated. The nature of this defect is discussed. Modified convexity of the interface is proposed to avoid the formation of this defect and increase the quality of the Ti sapphire crystal

Clustering of rare earth in glasses, aluminum effect: experiments and modeling

Luminescent spectra of Eu3+-doped sol-gel glasses have been analyzed during the densification process and compared according to the presence or not of aluminum as a codoping ion. A transition temperature from hydrated to dehydroxyled environments has been found different for doped and codoped samples. However, only slight modifications have been displayed from luminescence measurements beyond this transition. To support the experimental analysis, molecular dynamics simulations have been performed to model the doped and codoped glass structures. Despite no evidence of rare earth clustering reduction due to aluminum has been found, the modeled structures have shown that the luminescent ions are mainly located in aluminum-rich domains. The synthesis of both experimental and numerical analyses has lead us to interpret the aluminum effect as responsible for differences in structure of the luminescent sites rather than for an effective dispersion of the rare earth ions. (C) 2004 Elsevier B.V. All rights reserved

Influence of Nd3+ doping on the structural and near-IR photoluminescence properties of nanostructured TiO2 films

n/

Rare-earth-activated glasses for solar energy conversion

The solar cells efficiency may be improved by better exploitation of the solar spectrum, making use of the down-conversion mechanism, where one high energy photon is cut into two low energy photons. The choice of the matrix is a crucial point to obtain an efficient down-conversion process with rare-earth ions. When energy transfer between rare earth ions is used to activate this process, high emission and absorption cross sections as well as low cut-off phonon energy are mandatory. In this paper we present some results concerning 70SiO2-30HfO2 glass ceramic planar waveguides co-activated by Tb3+/Yb3+ ions, fabricated by sol gel route using a top-down approach, and a bulk fluoride glass of molar composition 70ZrF4 23.5LaF3 0.5AlF3 6GaF3 co-activated by Pr3+/Yb3+ ion. Attention is focused on the assessment of the energy transfer efficiency between the two couples of rare earth ions in the different hosts

Thermal and Optical Characterization of Undoped and Neodymium-Doped Y3ScAl4O12 Ceramics

Y3–3xNd3xSc1Al4O12 (x = 0, 0.01, and 0.02) ceramics were fabricated by sintering at high temperature under vacuum. Unit cell parameter refinement and chemical analysis have been performed. The morphological characterization shows micrograins with no visible defects. The thermal analysis of these ceramics is presented, by measuring the specific heat in the temperature range from 300 to 500 K. Their values at room temperature are in the range 0.81–0.90 J g1–K–1. The thermal conductivity has been determined by two methods: by the experimental measurement of the thermal diffusivity by the photopyroelectric method, and by spectroscopy, evaluating the thermal load. The thermal conductivities are in the range 9.7–6.5 W K–1 m–1 in the temperature interval from 300 to 500 K. The thermooptic coefficients were measured at 632 nm by the dark mode method using a prism coupler, and the obtained values are in the range 12.8–13.3 × 10–6 K–1. The nonlinear refractive index values at 795 nm have been evaluated to calibrate the nonlinear optical response of these materials.This work is supported by the Spanish Government under projects MAT2011-29255-C02-01-02, MAT2013-47395-C4-4-R, and the Catalan Government under project 2014SGR1358. It was also funded by the European Commission under the Seventh Framework Programme, project Cleanspace, FP7-SPACE-2010-1-GA No. 263044

Large Ti-doped sapphire bulk crystal for high power laser applications

International audienc

New Er3+ doped antimony oxide based glasses: Thermal analysis, structural and spectral properties

International audienceThe novel oxide glass compositions based on Sb2O3 are elaborated and characterized, in the system (90-X)Sb2O3–10Na2O–XBi2O3 (SNB). We are interested in bismuth rates incorporated into the glass, its effect on the different physical properties that have been measured, and especially, in radiative and spectroscopic properties of erbium doped SNB glasses. Differential scanning calorimeter (DSC) measurements show an improvement of the stability factor,ΔT, of the glasses, which can indicate a reinforcement of the network. Both FTIR and Raman spectra have also been considered in terms of bismuth influence. As a function of composition, we have principally measured optical absorption, visible and infrared emission, and lifetime. The Judd–Ofelt parameters measured from the absorption spectra have been used to calculate the radiative lifetime (τr) and the stimulated emission cross section. The spectroscopic quality factor χ = Ω4/Ω6 = 0.73, low phonon energy of ∼600–700 cm−1, a reduced quenching effect, and a high quantum efficiency of 90% for the 1.53 μm measured emission, by pumping at 980 nm, are in favor of promising laser application