Heating of Micro-protrusions in Accelerating Structures

The thermal and field emission of electrons from protrusions on metal surfaces is a possible limiting factor on the performance and operation of high-gradient room temperature accelerator structures. We present here the results of extensive numerical simulations of electrical and thermal behavior of protrusions. We unify the thermal and field emission in the same numerical framework, describe bounds for the emission current and geometric enhancement, then we calculate the Nottingham and Joule heating terms and solve the heat equation to characterize the thermal evolution of emitters under RF electric field. Our findings suggest that, heating is entirely due to the Nottingham effect, that thermal runaway scenarios are not likely, and that high RF frequency causes smaller swings in temperature and cooler tips. We build a phenomenological model to account for the effect of space charge and show that space charge eliminates the possibility of tip melting, although near melting temperatures reached.Comment: 8 pages, 10 figure

High power operation of an X-band gyrotwistron

We report the first experimental verification of a gyrotwistron amplifier. The device utilized a single 9.858 GHz, TE011 cavity, a heavily attenuated drift tube, and a long tapered output waveguide section. With a 440 kV, 200-245 A, 1 μs electron beam and a sharply tapered axial magnetic field, peak powers above 21 MW were achieved with a gain near 24 dB. Performance was limited by competition from a fundamental TE11 mode. A multimode code was developed to analyze this system, and simulations were in good agreement with the experiment

Remote Detection of Radioactive Material using High-Power Pulsed Electromagnetic Radiation

Remote detection of radioactive materials is impossible when the measurement location is far from the radioactive source such that the leakage of high-energy photons or electrons from the source cannot be measured. Current technologies are less effective in this respect because they only allow the detection at distances to which the high-energy photons or electrons can reach the detector. Here we demonstrate an experimental method for remote detection of radioactive materials by inducing plasma breakdown with the high-power pulsed electromagnetic waves. Measurements of the plasma formation time and its dispersion lead to enhanced detection sensitivity compared to the theoretically predicted one based only on the plasma on and off phenomena. We show that lower power of the incident electromagnetic wave is sufficient for plasma breakdown in atmospheric-pressure air and the elimination of the statistical distribution is possible in the presence of radioactive material.ope

Propagation of gamma rays and production of free electrons in air

A new concept of remote detection of concealed radioactive materials has been recently proposed \cite{Gr.Nusin.2010}-\cite{NusinSprangle}. It is based on the breakdown in air at the focal point of a high-power beam of electromagnetic waves produced by a THz gyrotron. To initiate the avalanche breakdown, seed free electrons should be present in this focal region during the electromagnetic pulse. This paper is devoted to the analysis of production of free electrons by gamma rays leaking from radioactive materials. Within a hundred meters from the radiation source, the fluctuating free electrons appear with the rate that may exceed significantly the natural background ionization rate. During the gyrotron pulse of about 10 microsecond length, such electrons may seed the electric breakdown and create sufficiently dense plasma at the focal region to be detected as an unambiguous effect of the concealed radioactive material.Comment: 27 pages, 10 figure

Cold testing of quasi-optical mode converters using a generator for non-rotating high-order gyrotron modes

In this paper, we test the performance of a quasi-optical, internal-gyrotron mode converter. When cold testing mode converters, a rotating higher-order mode is commonly used. However, this requires a nontrivial design and precise alignment. We thus propose a new technique for testing gyrotron mode converters by using a simple, non-rotating, higher-order mode generator. We demonstrate the feasibility of this technique for a W-band gyrotron quasi-optical mode converter by examining the excitation of a TE6,2 mode from a non-rotating mode generator. Our results demonstrate that this new cold-test scheme is an easy and efficient method for verifying the performance of quasi-optical mode converters.open0

Multi-transmission-line-beam interactive system

We construct here a Lagrangian field formulation for a system consisting of an electron beam interacting with a slow-wave structure modeled by a possibly non-uniform multiple transmission line (MTL). In the case of a single line we recover the linear model of a traveling wave tube (TWT) due to J.R. Pierce. Since a properly chosen MTL can approximate a real waveguide structure with any desired accuracy, the proposed model can be used in particular for design optimization. Furthermore, the Lagrangian formulation provides for: (i) a clear identification of the mathematical source of amplification, (ii) exact expressions for the conserved energy and its flux distributions obtained from the Noether theorem. In the case of uniform MTLs we carry out an exhaustive analysis of eigenmodes and find sharp conditions on the parameters of the system to provide for amplifying regimes

Coherent Cherenkov-Cyclotron Radiation Excited by an Electron Beam in a Metamaterial Waveguide

An electron beam passing through a metamaterial structure is predicted to generate reversed Cherenkov radiation, an unusual and potentially very useful property. We present an experimental test of this phenomenon using an intense electron beam passing through a metamaterial loaded waveguide. Power levels of up to 5 MW are observed in backward wave modes at a frequency of 2.40 GHz using a one microsecond pulsed electron beam of 490 keV, 84 A in a 400 G magnetic field. Contrary to expectations, the output power is not generated in the Cherenkov mode. Instead, the presence of the magnetic field, which is required to transport the electron beam, induces a Cherenkov-cyclotron (or anomalous Doppler) instability at a frequency equal to the Cherenkov frequency minus the cyclotron frequency. Nonlinear simulations indicate that the Cherenkov-cyclotron mode should dominate over the Cherenkov instability at a lower magnetic field where the highest output power is obtained.United States. Air Force Office of Scientific Research. Multidisciplinary University Research Initiative (Grant FA9550-12-1-0489