Physico-chemical Characteristics Of Ethanol–diesel Blend Fuel

In this research we are discussing the physicochemical characteristics of sweet diesel after desulphurization alone and also these characteristics are tested with the adding of high purity HPLC ethanol (99.9%). Those fuel properties of ethanol blended with diesel were experimentally determined to find their stability and to increase their properties and efficiency in the diesel engines. First, we made 4 blends of diesel with ethanol and the fifth sample was pure diesel. The samples were 0% ethanol and 100 % diesel, the second sample was 5% ethanol and 95 % diesel, the third sample was 10 % ethanol and 90% diesel, the fourth sample was 15 % ethanol and 85 % diesel and the fifth and last sample was 20 % ethanol and 80 % diesel. The physicochemical characteristics of the diesel ethanol blends were determined by the following experiments (cetane number, ASTM distillation, flash point, pour point, kinematic viscosity, ASTM density and calorific value). the aim of this research is to obtain an optimum blend of diesel ethanol fuel to help in improving the diesel engines and to lower the emission in the engine and the exhaust gases produced in the engines. This blend we obtained in this research was done to meet the EURO 5 standards and regulations, also to help to make an economic improvement in the industry of diesel in Egypt and in the world. The diesel ethanol blend was to be an effective fuel as we will see in the different tests and ASTM methods. Many tests and experiments done during this research project and the obtained results were similar to the EURO 5 standard emissions regulation

High Octane Number Gasoline-ether Blend

Gasoline produced in Egypt is a low-grade gasoline that contains high concentration of harmful components that are having a toll on our environment. In addition, those pollutants cause countless diseases and deaths annually to the Egyptian population. This paper targets two main sectors in the production of commercial gasoline. The improvement engine efficiency through the upgrading of octane number is first experimented by using a blend stock that ranges from gasoline fractions and Isomerates. An optimum was then chosen depending on the results obtained from different tests. Through those experiments, it was determined which samples obeyed the EU regulation for transportation emissions. Having an excellent gasoline with a high-octane number but produced large quantities of harmful emissions was unacceptable. This leads to the section aim of this research, which was to produce an environmental gasoline. This meant that once the gasoline sample is combusted, it should produce limited amounts of emissions such as 1% benzene since benzene is carcinogenic. A sample with euro 3 specification was produced and showed excellent gasoline properties such as an RON value of around 95 without the use of octane enhancers. A second sample showed better results satisfied euro 5 regulations and produced an even higher-octane number than the euro 3 sample. This sample was the optimum environmental ETBE-gasoline high octane number blend. By understanding the composition of those samples, maximum yield of commercial gasoline could be produced. This would also lead to the reduction of pollutants in the environment. Completing this task with successful results means that this environmental high octane number gasoline could be produced and used in Egypt. Such blends should be produced on a large scale by exercising euro 3 and/or 5 regulations

Structure of ternary additive hard-sphere fluid mixtures

Monte Carlo simulations on the structural properties of ternary fluid mixtures of additive hard spheres are reported. The results are compared with those obtained from a recent analytical approximation [S. B. Yuste, A. Santos, and M. Lopez de Haro, J. Chem. Phys. 108, 3683 (1998)] to the radial distribution functions of hard-sphere mixtures and with the results derived from the solution of the Ornstein-Zernike integral equation with both the Martynov-Sarkisov and the Percus-Yevick closures. Very good agreement between the results of the first two approaches and simulation is observed, with a noticeable improvement over the Percus-Yevick predictions especially near contact.Comment: 11 pages, including 8 figures; A minor change; accepted for publication in PR

Hormetic UV-C seed treatments for the control of tomato diseases

© 2019 British Society for Plant Pathology Hormesis is a dose response phenomenon in which low, non-damaging doses of a stressor bring about a positive response in the organism undergoing treatment. Evidence is provided here that hormetic UV-C treatments of tomato seed can control disease caused by Botrytis cinerea, Fusarium oxysporum f. sp. lycopersici (FOL) and f. sp. radicis-lycopersici (FORL) on tomato (Solanum lycopersicum). Treating seeds with a 4kJm−2 dose of UV-C significantly reduced both the disease incidence and progression of B.cinerea, with approximately 10% reductions in both on cv. Shirley. Disease severity assays for FOL and FORL on cv. Moneymaker showed dose-dependent responses: UV-C treatments of 4 and 6kJm−2 significantly reduced the disease severity scores of FOL, whilst only the 6kJm−2 showed significant reductions for FORL. To determine the effects of treatment on germination and seedling growth, UV-C doses of 4, 8 and 12kJm−2 were performed on cv. Shirley. No negative impacts on germination or seedling growth were observed for any of the treatments. However, the 8kJm−2 treatment showed significant biostimulation, with increases in seedling, root and hypocotyl dry weight of 11.4%, 23.1% and 12.0%, respectively, when compared to the control. Furthermore, significant increases in the root-mass fraction (10.6%) and root:shoot ratio (13.1%) along with a decrease in shoot-mass fraction (2.0%) indicates that the 8kJm−2 treatment stimulated root growth to the greatest extent. There was no effect on hypocotyl and primary root length or the number of lateral roots, indicating no adverse effects to basic root architecture or seedling growth

Ethylene responsive transcription factor ERF109 retards PCD and improves salt tolerance in plant

Semi-quantitative RT-PCR for tobacco VIGS lines of 13 knocked down TFs induced 2 h post oxalic acid treatment (20 mM) as compared to their WT and VIGS line with empty pTRV2 (V2) plants. Amplicon sizes of different genes and primers used are shown in Additional file 5: Table S3. The Nbactin gene was used as the house-keeping control. Gene codes refer to those indicated in Additional file 3: Table S2. (DOCX 684 kb

Metabolomic Response of Calotropis procera Growing in the Desert to Changes in Water Availability

Water availability is a major limitation for agricultural productivity. Plants growing in severe arid climates such as deserts provide tools for studying plant growth and performance under extreme drought conditions. The perennial species Calotropis procera used in this study is a shrub growing in many arid areas which has an exceptional ability to adapt and be productive in severe arid conditions. We describe the results of studying the metabolomic response of wild C procera plants growing in the desert to a one time water supply. Leaves of C. procera plants were taken at three time points before and 1 hour, 6 hours and 12 hours after watering and subjected to a metabolomics and lipidomics analysis. Analysis of the data reveals that within one hour after watering C. procera has already responded on the metabolic level to the sudden water availability as evidenced by major changes such as increased levels of most amino acids, a decrease in sucrose, raffinose and maltitol, a decrease in storage lipids (triacylglycerols) and an increase in membrane lipids including photosynthetic membranes. These changes still prevail at the 6 hour time point after watering however 12 hours after watering the metabolomics data are essentially indistinguishable from the prewatering state thus demonstrating not only a rapid response to water availability but also a rapid response to loss of water. Taken together these data suggest that the ability of C. procera to survive under the very harsh drought conditions prevailing in the desert might be associated with its rapid adjustments to water availability and losses

Analysis of transcriptional response to heat stress in Rhazya stricta

Clusters of assembled transcripts of R. stricta SRA in mature leaves (A5-L8) at different time points of the day (A, morning; F-H, midday & L, dusk). Grey lines indicate expression patterns of individual transcripts in a given cluster. Blue lines indicate overall expression pattern across different transcripts of a given cluster. (PDF 397 kb

Treatment of Infections in Young Infants in Low- and Middle-Income Countries:A Systematic Review and Meta-analysis of Frontline Health Worker Diagnosis and Antibiotic Access

BACKGROUND: Inadequate illness recognition and access to antibiotics contribute to high case fatality from infections in young infants (<2 months) in low- and middle-income countries (LMICs). We aimed to address three questions regarding access to treatment for young infant infections in LMICs: (1) Can frontline health workers accurately diagnose possible bacterial infection (pBI)?; (2) How available and affordable are antibiotics?; (3) How often are antibiotics procured without a prescription? METHODS AND FINDINGS: We searched PubMed, Embase, WHO/Health Action International (HAI), databases, service provision assessments (SPAs), Demographic and Health Surveys, Multiple Indicator Cluster Surveys, and grey literature with no date restriction until May 2014. Data were identified from 37 published studies, 46 HAI national surveys, and eight SPAs. For study question 1, meta-analysis showed that clinical sign-based algorithms predicted bacterial infection in young infants with high sensitivity (87%, 95% CI 82%-91%) and lower specificity (62%, 95% CI 48%-75%) (six studies, n = 14,254). Frontline health workers diagnosed pBI in young infants with an average sensitivity of 82% (95% CI 76%-88%) and specificity of 69% (95% CI 54%-83%) (eight studies, n = 11,857) compared to physicians. For question 2, first-line injectable agents (ampicillin, gentamicin, and penicillin) had low variable availability in first-level health facilities in Africa and South Asia. Oral amoxicillin and cotrimoxazole were widely available at low cost in most regions. For question 3, no studies on young infants were identified, however 25% of pediatric antibiotic purchases in LMICs were obtained without a prescription (11 studies, 95% CI 18%-34%), with lower rates among infants <1 year. Study limitations included potential selection bias and lack of neonatal-specific data. CONCLUSIONS: Trained frontline health workers may screen for pBI in young infants with relatively high sensitivity and lower specificity. Availability of first-line injectable antibiotics appears low in many health facilities in Africa and Asia. Improved data and advocacy are needed to increase the availability and appropriate utilization of antibiotics for young infant infections in LMICs. REVIEW REGISTRATION: PROSPERO International prospective register of systematic reviews (CRD42013004586). Please see later in the article for the Editors' Summary