Resilient cooling strategies – A critical review and qualitative assessment

The global effects of climate change will increase the frequency and intensity of extreme events such as heatwaves and power outages, which have consequences for buildings and their cooling systems. Buildings and their cooling systems should be designed and operated to be resilient under such events to protect occupants from potentially dangerous indoor thermal conditions. This study performed a critical review on the state-of-the-art of cooling strategies, with special attention to their performance under heatwaves and power outages. We proposed a definition of resilient cooling and described four criteria for resilience—absorptive capacity, adaptive capacity, restorative capacity, and recovery speed —and used them to qualitatively evaluate the resilience of each strategy. The literature review and qualitative analyses show that to attain resilient cooling, the four resilience criteria should be considered in the design phase of a building or during the planning of retrofits. The building and relevant cooling system characteristics should be considered simultaneously to withstand extreme events. A combination of strategies with different resilience capacities, such as a passive envelope strategy coupled with a low-energy space-cooling solution, may be needed to obtain resilient cooling. Finally, a further direction for a quantitative assessment approach has been pointed out

Potential toxic elements in stream sediments, soils and waters in an abandoned radium mine (central Portugal)

The Alto da Várzea radium mine (AV) exploited ore and U-bearing minerals, such as autunite and torbernite. The mine was exploited underground from 1911 to 1922, closed in 1946 without restoration, and actually a commercial area is deployed. Stream sediments, soils and water samples were collected between 2008 and 2009. Stream sediments are mainly contaminated in As, Th, U and W, which is related to the AV radium mine. The PTEs, As, Co, Cr, Sr, Th, U, W, Zn, and electrical conductivity reached the highest values in soils collected inside the mine influence. Soils are contaminated with As and U and must not be used for any purpose. Most waters have pH values ranging from 4.3 to 6.8 and are poorly mineralized (EC = 41-186 µS/cm; TDS = 33-172 mg/L). Groundwater contains the highest Cu, Cr and Pb contents. Arsenic occurs predominantly as H2(AsO4)- and H(AsO4)2-. Waters are saturated in goethite, haematite and some of them also in lepidocrocite and ferrihydrite, which adsorbs As (V). Lead is divalent in waters collected during the warm season, being mobile in these waters. Thorium occurs mainly as Th(OH)3(CO3)-, Th(OH)2(CO3) and Th(OH)2(CO3) 22- , which increase water Th contents. Uranium occurs predominantly as UO2CO3, but CaUO2(CO3) 32- and CaUO2(CO3)3 also occur, decreasing its mobility in water. The waters are contaminated in NO2-, Mn, Cu, As, Pb and U and must not be used for human consumption and in agricultural activities. The water contamination is mainly associated with the old radium mine and human activities. A restoration of the mining area with PTE monitoring is necessary to avoid a public hazard.Thanks are due to Prof. Joao Coutinho for the determination of organic matter and cation exchange capacity in samples of stream sediments and soils and A. Rodrigues for the water analyses, EDM for some information on the Alto da Varzea mine area. This study had the support of Portuguese Fundacao para a Ciencia e Tecnologia (FCT), through the strategic projects UID/GEO/04035/2013 and UID/MAR/04292/2013 (MARE).info:eu-repo/semantics/publishedVersio

Albumin and multiple sclerosis

A grant from the One-University Open Access Fund at the University of Kansas was used to defray the author's publication fees in this Open Access journal. The Open Access Fund, administered by librarians from the KU, KU Law, and KUMC libraries, is made possible by contributions from the offices of KU Provost, KU Vice Chancellor for Research & Graduate Studies, and KUMC Vice Chancellor for Research. For more information about the Open Access Fund, please see http://library.kumc.edu/authors-fund.xml.Leakage of the blood–brain barrier (BBB) is a common pathological feature in multiple sclerosis (MS). Following a breach of the BBB, albumin, the most abundant protein in plasma, gains access to CNS tissue where it is exposed to an inflammatory milieu and tissue damage, e.g., demyelination. Once in the CNS, albumin can participate in protective mechanisms. For example, due to its high concentration and molecular properties, albumin becomes a target for oxidation and nitration reactions. Furthermore, albumin binds metals and heme thereby limiting their ability to produce reactive oxygen and reactive nitrogen species. Albumin also has the potential to worsen disease. Similar to pathogenic processes that occur during epilepsy, extravasated albumin could induce the expression of proinflammatory cytokines and affect the ability of astrocytes to maintain potassium homeostasis thereby possibly making neurons more vulnerable to glutamate exicitotoxicity, which is thought to be a pathogenic mechanism in MS. The albumin quotient, albumin in cerebrospinal fluid (CSF)/albumin in serum, is used as a measure of blood-CSF barrier dysfunction in MS, but it may be inaccurate since albumin levels in the CSF can be influenced by multiple factors including: 1) albumin becomes proteolytically cleaved during disease, 2) extravasated albumin is taken up by macrophages, microglia, and astrocytes, and 3) the location of BBB damage affects the entry of extravasated albumin into ventricular CSF. A discussion of the roles that albumin performs during MS is put forth

Impact of primary kidney disease on the effects of empagliflozin in patients with chronic kidney disease: secondary analyses of the EMPA-KIDNEY trial

Background: The EMPA KIDNEY trial showed that empagliflozin reduced the risk of the primary composite outcome of kidney disease progression or cardiovascular death in patients with chronic kidney disease mainly through slowing progression. We aimed to assess how effects of empagliflozin might differ by primary kidney disease across its broad population. Methods: EMPA-KIDNEY, a randomised, controlled, phase 3 trial, was conducted at 241 centres in eight countries (Canada, China, Germany, Italy, Japan, Malaysia, the UK, and the USA). Patients were eligible if their estimated glomerular filtration rate (eGFR) was 20 to less than 45 mL/min per 1·73 m2, or 45 to less than 90 mL/min per 1·73 m2 with a urinary albumin-to-creatinine ratio (uACR) of 200 mg/g or higher at screening. They were randomly assigned (1:1) to 10 mg oral empagliflozin once daily or matching placebo. Effects on kidney disease progression (defined as a sustained ≥40% eGFR decline from randomisation, end-stage kidney disease, a sustained eGFR below 10 mL/min per 1·73 m2, or death from kidney failure) were assessed using prespecified Cox models, and eGFR slope analyses used shared parameter models. Subgroup comparisons were performed by including relevant interaction terms in models. EMPA-KIDNEY is registered with ClinicalTrials.gov, NCT03594110. Findings: Between May 15, 2019, and April 16, 2021, 6609 participants were randomly assigned and followed up for a median of 2·0 years (IQR 1·5–2·4). Prespecified subgroupings by primary kidney disease included 2057 (31·1%) participants with diabetic kidney disease, 1669 (25·3%) with glomerular disease, 1445 (21·9%) with hypertensive or renovascular disease, and 1438 (21·8%) with other or unknown causes. Kidney disease progression occurred in 384 (11·6%) of 3304 patients in the empagliflozin group and 504 (15·2%) of 3305 patients in the placebo group (hazard ratio 0·71 [95% CI 0·62–0·81]), with no evidence that the relative effect size varied significantly by primary kidney disease (pheterogeneity=0·62). The between-group difference in chronic eGFR slopes (ie, from 2 months to final follow-up) was 1·37 mL/min per 1·73 m2 per year (95% CI 1·16–1·59), representing a 50% (42–58) reduction in the rate of chronic eGFR decline. This relative effect of empagliflozin on chronic eGFR slope was similar in analyses by different primary kidney diseases, including in explorations by type of glomerular disease and diabetes (p values for heterogeneity all >0·1). Interpretation: In a broad range of patients with chronic kidney disease at risk of progression, including a wide range of non-diabetic causes of chronic kidney disease, empagliflozin reduced risk of kidney disease progression. Relative effect sizes were broadly similar irrespective of the cause of primary kidney disease, suggesting that SGLT2 inhibitors should be part of a standard of care to minimise risk of kidney failure in chronic kidney disease. Funding: Boehringer Ingelheim, Eli Lilly, and UK Medical Research Council

Preemptive analgesic effect of ketamine in patients undergoing elective cesarean section

Objectives: In this study, the preemptive effect of a small dose of ketamine on postoperative wound pain and morphine consumption in patients undergoing elective cesarean section was evaluated. Methods: In a randomized, double-blind clinical trial, 60 women with American Society of Anesthesiologists class I and II identification undergoing elective cesarean section were enrolled. In the case group, the patients received 0.5mg/kg ketamine, and in the control group, they received isotonic saline, 5 minutes before the induction of anesthesia. Anesthesia was induced with 4mg/kg thiopental followed by 1.5mg/kg succinylcholine. A further neuromuscular block was achieved by using 0.2mg/kg of atracurium. Anesthesia was maintained with nitrous oxide 50 and halothane in oxygen. The lungs were mechanically ventilated. After fetus delivery, fentanyl (2μg/kg) and morphine (0.15mg/kg) were given intravenously. In the postanesthesia care unit and in the ward, all patients received morphine. Pain was assessed by the Visual Analog Scales at 2, 6, 12, and 24 hours postoperatively; the amount of morphine used and side effects were recorded. Results: There was no significant difference between the patients considering their operative details, homodynamic variables, side effects, and Apgar scores of their babies at first and fifth minutes. Significantly, lower amounts of morphine were used in the case group (4.8mg±2.5mg vs. 8.1mg±4.2mg) during the first 2 hours after surgery (P=0.01), but the difference was not significant during 2 to 24 hours (3.2±2.2 vs. 3.1±2.3). There were no statistical differences between the groups in pain 2, 6, 12, and 24 hours postoperatively. Discussion: Intraoperative low-dose ketamine had no effect on morphine consumption during 2 to 24 hours after surgery. No significant differences were seen in the pain scores of the 2 groups during the study period. The preoperative administration of 0.5mg/kg ketamine in patients undergoing cesarean section did not elicit a preemptive analgesic effect. Copyright © 2010 by Lippincott Williams & Wilkins

Application of artificial neural networks for formulation and modeling of dye adsorption onto multiwalled carbon nanotubes

In this study, an artificial neural network (ANN) has been developed to predict the adsorption amount of dye (methylene blue) onto multiwalled carbon nanotubes. Batch experiments have been carried out to obtain experimental data. Important parameters in the adsorption system such as initial dye concentration, adsorbent dosage, temperature, pH and contact time have been used as the inputs of the network, while the output is the final concentration of dye in aqueous solution after adsorption. The neural network structure has been optimized by testing various training algorithms and different number of neurons in a hidden layer. An empirical equation for determination of final dye concentration in aqueous solutions after adsorption has been developed by using the weights of the optimized network. The results of the optimized ANN have been compared with conventional models in equilibrium and kinetic fields. According to error analysis and determination coefficient, the ANN was found to be the most appropriate model to describe this adsorption process. Sensitivity analysis showed that initial dye concentration, pH and contact time are the most effective parameters in this process. The influence percentages of these parameters on the output were 28, 24 and 24 %, respectively. © 2012 Springer Science+Business Media Dordrecht.Zohre Shahryari, Ali Mohebbi, Ataallah Soltani Goharrizi, Amir Ahmad Forghan