Determination of hydroxyl groups in biorefinery resources via quantitative 31P NMR spectroscopy

The analysis of chemical structural characteristics of biorefinery product streams (such as lignin and tannin) has advanced substantially over the past decade, with traditional wet-chemical techniques being replaced or supplemented by NMR methodologies. Quantitative 31P NMR spectroscopy is a promising technique for the analysis of hydroxyl groups because of its unique characterization capability and broad potential applicability across the biorefinery research community. This protocol describes procedures for (i) the preparation/solubilization of lignin and tannin, (ii) the phosphitylation of their hydroxyl groups, (iii) NMR acquisition details, and (iv) the ensuing data analyses and means to precisely calculate the content of the different types of hydroxyl groups. Compared with traditional wet-chemical techniques, the technique of quantitative 31P NMR spectroscopy offers unique advantages in measuring hydroxyl groups in a single spectrum with high signal resolution. The method provides complete quantitative information about the hydroxyl groups with small amounts of sample (~30 mg) within a relatively short experimental time (~30-120 min)

Highly percolated poly(vinyl alcohol) and bacterial nanocellulose synthesized in situ by physical-crosslinking:Exploiting polymer synergies for biomedical nanocomposites

Bacterial cellulose (BC) grown from a culture medium in the presence of water-soluble poly(vinyl alcohol) (PVA) produced an assemblage that was used as precursor for the synthesis of biocompatible nanocomposites.</p

Bicomponent lignocellulose thin films to study the role of surface lignin in cellulolytic reactions

44 Pág.Ultrathin bicomponent films of cellulose and lignin derivatives were deposited on silica supports by spin coating, and after conversion into the respective polymer precursor, they were used as a model system to investigate interfacial phenomena relevant to lignocellulose biocatalysis. Film morphology, surface chemical composition, and wettability were determined by atomic force microscopy, X-ray photoelectron spectroscopy, and water contact angle, respectively. Phase separation of cellulose and lignin produced structures that resembled the cell wall of fibers and were used to monitor enzyme binding and cellulolytic reactions via quartz crystal microgravimetry. The rate and extent of hydrolysis was quantified by using kinetic models that indicated the role of the surface lignin domains in enzyme inhibition. Hydrophobic interactions between cellulases and the substrates and their critical role on irreversible adsorption were elucidated by using acetylated lignin films with different degrees of substitution. Overall, it is concluded that sensors based on the proposed ultrathin films of lignocellulose can facilitate a better understanding of the complex events that occur during bioconversion of cellulosic biomass.The funding support from TEKES and Academy of Finland (Finland Distinguish Professorship, O.J.R.) and the Hoffman Graduate Fellowship (NC State, I.C.H.) are gratefully acknowledged. Dr. Anna-Stiina Jääskeläinen (VTT, Finland) and Laura Taajamaa (Aalto) are thanked for insightful discussion.N