Vortex systems on slender rotating bodies and their effect on the aerodynamic coefficients

The turbulent flow of rotational bodies up to a length of 20 diameters with various head shapes and cylindrical tails was examined in the subsonic wind tunnel with the Mach number of M = 0.1. At angles of incidence lower than 30 degrees, a pair of symmetrical eddies rests stationary from head to tail on the trailing side, very close to the body. At angles between 30 and 60 degrees, the stationary eddies are asymmetrically pushed off. Between 60 and 90 degrees, the eddies detach themselves in an instationary manner. This includes, for example, the turbulent flow at the start-up of flying bodies in the presence of lateral winds. The results of measurments obtained by Mello at M = 2, an impulse method, and the cross flow theory according to Allen are used for comparison

Evaluation of electrodeposited alpha Mn2O3 as a catalyst for the Oxygen Evolution Reaction

alpha Mn2O3 is of interest as a low cost and environmentally benign electrocatalyst for the Oxygen Evolution Reaction OER in the process of water splitting. Mechanically stable alpha Mn2O3 electrodes are prepared by annealing of galvanostatically deposited MnOOHx layers on F SnO2 coated glass. The overpotential eta to achieve a current density of j 10 mA cm2 decreases from 590 to 340 mV with increasing layer thickness. Differential capacitance measurements reveal that this high OER activity can be attributed to the large electrochemically active surface area ECSA , which scales linearly with the thickness of these highly porous and electrolyte permeable films. The oxide layers exhibit a reversible oxidation behavior from Mn III to Mn IV , whereas only about 25 of the Mn III is oxidized to Mn IV before the OER reaction takes off. Although the intrinsic activity is small compared to that of other OER catalysts, such as NiFeOx, the combination of high ECSA and good electrical conductivity of these amp; 945; Mn2O3 films ensures that high OER activities can be obtained. The films are found to be stable for gt;2 h in alkaline conditions, as long as the potential does not exceed the corrosion potential of 1.7 V vs. RHE. These findings show that amp; 945; Mn2O3 is a promising OER catalyst for water splitting device

Thin film solar cells based on the ternary compound Cu2SnS3

Alongside with Cu2ZnSnS4 and SnS, the p-type semiconductor Cu2SnS3 also consists of only Earth abundant and low-cost elements and shows comparable opto-electronic properties, with respect to Cu2ZnSnS4 and SnS, making it a promising candidate for photovoltaic applications of the future. In this work, the ternary compound has been produced via the annealing of an electrodeposited precursor in a sulfur and tin sulfide environment. The obtained absorber layer has been structurally investigated by X-ray diffraction and results indicate the crystal structure to be monoclinic. Its optical properties have been measured via photoluminescence, where an asymmetric peak at 0.95 eV has been found. The evaluation of the photoluminescence spectrum indicates a band gap of 0.93 eV which agrees well with the results from the external quantum efficiency. Furthermore, this semiconductor layer has been processed into a photovoltaic device with a power conversion efficiency of 0.54%, a short circuit current of 17.1 mA/cm2, an open circuit voltage of 104 mV hampered by a small shunt resistance, a fill factor of 30.4%, and a maximal external quantum efficiency of just less than 60%. In addition, the potential of this Cu2SnS3 absorber layer for photovoltaic applications is discussed

Towards global sustainability: Education on environmentally clean energy technologies

The recent climate change agreement in Paris highlights the imperative to aggressively decarbonize the energy economy and develop new technologies, especially for the generation of electrical energy that are environmentally clean. This challenge can only be addressed by a multi-pronged approach to research and education of the next generation of scientists and engineers as well as informed public discourse. Consequently this requires the introduction of new and comprehensive education programs on sustainable energy technologies for universities and, possibly, high schools. Among others, the new programs should provide in-depth knowledge in the development of new materials for more efficient energy conversion systems and devices. The enhanced level of education is also needed for properly assessing the competing technologies in terms of their economic and social benefits. The increasing recognition of the significance of clean and efficient energy conversion indicates the need for a comprehensive education program to be developed. The purpose of the present work is to consider the structure of both an education program and the related textbook where the energy-related fundamental and applied subjects are presented in a concentrated and uniform manner. Such a textbook could be an education aid for students of energy-related courses as well as the teachers involved in the formulation of the education programs. The textbook, which should be dedicated mainly for students at the undergraduate levels at universities, and possibly high schools, should include in-depth interdisciplinary sections dedicated to energy experts and graduate students. This paper considers the present international efforts in reducing the impact of climate change and the need to develop new technologies for clean energy generation. It is argued that progress in this area requires recognition of hydrogen as the main energy carrier of the future. This work also delineates the goals of the Sustainable Energy Network, SEN, involved in the UN program of Future Earth

Structure of the catalytic sites in Fe/N/C-catalysts for O-2-reduction in PEM fuel cells

Dieser Beitrag ist mit Zustimmung des Rechteinhabers aufgrund einer (DFG geförderten) Allianz- bzw. Nationallizenz frei zugänglich.This publication is with permission of the rights owner freely accessible due to an Alliance licence and a national licence (funded by the DFG, German Research Foundation) respectively.Fe-based catalytic sites for the reduction of oxygen in acidic medium have been identified by 57Fe Mössbauer spectroscopy of Fe/N/C catalysts containing 0.03 to 1.55 wt% Fe, which were prepared by impregnation of iron acetate on carbon black followed by heat-treatment in NH3 at 950 °C. Four different Fe-species were detected at all iron concentrations: three doublets assigned to molecular FeN4-like sites with their ferrous ions in a low (D1), intermediate (D2) or high (D3) spin state, and two other doublets assigned to a single Fe-species (D4 and D5) consisting of surface oxidized nitride nanoparticles (FexN, with x ≤ 2.1). A fifth Fe-species appears only in those catalysts with Fe-contents ≥0.27 wt%. It is characterized by a very broad singlet, which has been assigned to incomplete FeN4-like sites that quickly dissolve in contact with an acid. Among the five Fe-species identified in these catalysts, only D1 and D3 display catalytic activity for the oxygen reduction reaction (ORR) in the acid medium, with D3 featuring a composite structure with a protonated neighbour basic nitrogen and being by far the most active species, with an estimated turn over frequency for the ORR of 11.4 e− per site per s at 0.8 V vs. RHE. Moreover, all D1 sites and between 1/2 and 2/3 of the D3 sites are acid-resistant. A scheme for the mechanism of site formation upon heat-treatment is also proposed. This identification of the ORR-active sites in these catalysts is of crucial importance to design strategies to improve the catalytic activity and stability of these materials

Formation and suppression of defects during heat treatment of BiVO4 photoanodes for solar water splitting

Metal oxide photoelectrodes typically suffer from poor carrier transport properties and extensive carrier recombination, which is caused by the presence of intrinsic or extrinsic defects in the material. Here, the influence of annealing temperature and atmosphere on the formation and suppression of defects in BiVO4 one of the best performing metal oxide photoanodes is elucidated. Annealing in argon has little or no effect on the photoelectrochemical performance due to the competing effects of an increase in grain size i.e., reduction of grain boundaries and the unfavorable formation of oxygen vacancies. When annealing in air, the formation of oxygen vacancies is suppressed, resulting in up to 1.5 fold enhancement of the photocurrent and an order of magnitude increase of the charge carrier mobility. However, vanadium leaves the BiVO4 lattice above 500 C, which leads to a decrease in carrier lifetime and photocurrent. This vanadium loss can be avoided by supplying excess vanadium in the gas phase during annealing. This leads to enhanced charge carrier mobility and lifetime, resulting in improved photocurrents. Overall, this strategy offers a general approach to prevent unfavorable changes of cation stoichiometry during high temperature treatment of complex metal oxide photoelectrode

Prognostic value of cardiac hybrid imaging integrating single-photon emission computed tomography with coronary computed tomography angiography

Aims Although cardiac hybrid imaging, fusing single-photon emission computed tomography (SPECT) myocardial perfusion imaging with coronary computed tomography angiography (CCTA), provides important complementary diagnostic information for coronary artery disease (CAD) assessment, no prognostic data exist on the predictive value of cardiac hybrid imaging. Hence, the aim of this study was to assess the prognostic value of hybrid SPECT/CCTA images. Methods and results Of 335 consecutive patients undergoing a 1-day stress/rest 99mTc-tetrofosmin SPECT and a CCTA, acquired on stand-alone scanners and fused to obtain cardiac hybrid images, follow-up was obtained in 324 patients (97%). Survival free of all-cause death or non-fatal myocardial infarction (MI) and free of major adverse cardiac events (MACE: death, MI, unstable angina requiring hospitalization, coronary revascularizations) was determined using the Kaplan-Meier method for the following groups: (i) stenosis by CCTA and matching reversible SPECT defect; (ii) unmatched CCTA and SPECT finding; and (iii) normal finding by CCTA and SPECT. Cox's proportional hazard regression was used to identify independent predictors for cardiac events. At a median follow-up of 2.8 years (25th-75th percentile: 1.9-3.6), 69 MACE occurred in 47 patients, including 20 death/MI. A corresponding matched hybrid image finding was associated with a significantly higher death/MI incidence (P < 0.005) and proved to be an independent predictor for MACE. The annual death/MI rate was 6.0, 2.8, and 1.3% for patients with matched, unmatched, and normal findings. Conclusion Cardiac hybrid imaging allows risk stratification in patients with known or suspected CAD. A matched defect on hybrid image is a strong predictor of MAC

Coastal Ocean Forecasting: science foundation and user benefits

The advancement of Coastal Ocean Forecasting Systems (COFS) requires the support of continuous scientific progress addressing: (a) the primary mechanisms driving coastal circulation; (b) methods to achieve fully integrated coastal systems (observations and models), that are dynamically embedded in larger scale systems; and (c) methods to adequately represent air-sea and biophysical interactions. Issues of downscaling, data assimilation, atmosphere-wave-ocean couplings and ecosystem dynamics in the coastal ocean are discussed. These science topics are fundamental for successful COFS, which are connected to evolving downstream applications, dictated by the socioeconomic needs of rapidly increasing coastal populations

Inter-scan variability of coronary artery calcium scoring assessed on 64-multidetector computed tomography vs. dual-source computed tomography: a head-to-head comparison

Aims Coronary artery calcium (CAC) scoring has emerged as a tool for risk stratification and potentially for monitoring response to risk factor modification. Therefore, repeat measurements should provide robust results and low inter-scanner variability for allowing meaningful comparison. The purpose of this study was to investigate inter-scanner variability of CAC for Agatston, volume, and mass scores by head-to-head comparison using two different cardiac computed tomography scanners: 64-detector multislice CT (MSCT) and 64-slice dual-source CT (DSCT). Methods and results Thirty patients underwent CAC measurements on both 64-MSCT (GE LightSpeed XT scanner: 120 kV, 70 mAs, 2.5 mm slices) and 64-DSCT (Siemens Somatom Definition: 120 kV, 80 mAs, 3 mm slices) within <100 days (0-97). Retrospective intra-scan comparison revealed an excellent correlation. The excellent intra-scan (inter-observer) agreement was documented by narrow limits of agreement and a correlation coefficient of variation (COV) of r ≥ 0.99 (P < 0.001) for all CAC scores with a low COV for both scanners (64-MSCT/64-DSCT), i.e. Agatston (2.0/2.1%), mass (3.0/2.0%), and volume (4.7/3.9%). Inter-scanner comparison revealed larger Bland-Altman (BA) limits of agreement, despite high correlation (r ≥ 0.97) for all scores, with COV at 15.1, 21.6, and 44.9% for Agatston, mass, and volume scores. The largest BA limits were observed for volume scores (−1552.8 to 574.2), which was massively improved (−241.0 to 300.4, COV 11.5%) after reanalysing the 64-DSCT scans (Siemens) with GE software/workstation (while Siemens software/workstation does not allow cross-vendor analysis). Phantom measurements confirmed overestimation of volume scores by ‘syngo Ca-Scoring' (Siemens) software which should therefore be reviewed (vendor has been notified). Conclusion Intra- and inter-scan agreement of CAC measurement in a given data set is excellent. Inter-scanner variability is reasonable, particularly for Agatston units in the clinically most relevant range <1000. The use of different software solutions has a greater influence particularly on volume scores than the use of different scanner type