1,252 research outputs found
Geoelectrical signatures of redox processes
Common redox potential sensors provide point measurements and are error prone. Destructive sampling can cause contact with air which will influence the redox state. Hence, assessing redox conditions in soil is challenging. Redox sensitive reactions like the degradation of organic contaminants will change water chemistry and geophysical properties. We explored geophysical techniques ERT and SIP to observe the degradation processes of Propylene Glycol (PG), a de-icing chemical used at airports. Two laboratory experiments were performed to monitor changes caused by PG degradation: 1) 3D ERT was measured, every week, in four sand tanks. One rich in oxides. 2) SIP was measured, every three days, in twenty-six oxides rich sand columns. In both experiments PG was applied just above the water table. ERT - When iron and manganese oxides were available, degradation reduced resistivity. When oxides were unavailable, the electrical resistivity increased, most likely due to methane production which reduced water saturation. SIP - An increase of the real conductivity was associated with the metal ions release but independent of the frequency. Also an increase of phase angle and imaginary conductivity at frequencies below 1Hz that precede the ion release was observed in the water
Monitoring redox sensitive conditions at the groundwater interface using electrical resistivity and self-potential
Assessing redox conditions in soil and groundwater is challenging because redox reactions are oxygen sensitive, hence, destructive sampling methods may provide contact with air and influence the redox state. Furthermore, commonly used redox potential sensors provide only point measurements and are prone to error. This paper assesses whether combining electrical resistivity (ER) and self-potential (SP) measurements can allow the mapping of zones affected by anaerobic degradation. We use ER imaging because anaerobic degradation can release iron and manganese ions, which decreases pore water resistivity, and produces gas, which increases resistivity. Also, electrochemical differences between anaerobic and aerobic zones may create an electron flow, forming a self-potential anomaly. In this laboratory study, with four sand tanks with constant water table heights, time-lapse ER and SP mapped changes in electrical/electron flow properties due to organic contaminant (propylene glycol) degradation. Sampled pore water mapped degradation and water chemistry. When iron and manganese oxides were available, degradation reduced resistivity, because of cation release in pore water. When iron and manganese oxides were unavailable, resistivity increased, plausibly from methane production, which reduced water saturation. To bypass the reactions producing methane and release of metallic cations, a metal pipe was installed in the sand tanks between anaerobic and aerobic zones. The degradation creates an electron surplus at the anaerobic degradation site. The metal pipe allowed electron flow from the anaerobic degradation site to the oxygen-rich near surface. The electrical current sent through the metal pipe formed an SP anomaly observable on the surface of the sand tank. Time-lapse ER demonstrates potential for mapping degradation zones under anaerobic conditions. When an electrical conductor bridges the anaerobic zone with the near surface, the electron flow causes an SP anomaly on the surface. However, electrochemical differences between anaerobic and aerobic zones alone produced no SP signal. Despite their limitations, ER and SP are promising tools for monitoring redox sensitive conditions in unsaturated sandy soils but should not be used in isolation
Performance Modeling of Fresnel-Based CPV Systems: Effects of Deformations under Real Operation Conditions
Getting a lower energy cost has always been a challenge for concentrated photovoltaic. The FK concentrator enhances the performance (efficiency, acceptance angle and manufacturing tolerances) of the conventional CPV system based on a Fresnel primary stage and a secondary lens, while keeping its simplicity and potentially lowâcost manufacturing. At the same time FâXTP (Fresnel lens+reflective prism), at the first glance has better cost potential but significantly higher sensitivity to manufacturing errors. This work presents comparison of these two approaches applied to two main technologies of Fresnel lens production (PMMA and Silicone on Glass) and effect of standard deformations that occur under real operation condition
4f spin density in the reentrant ferromagnet SmMn2Ge2
The spin contribution to the magnetic moment in SmMn2Ge2 has been measured by
magnetic Compton scattering in both the low and high temperature ferromagnetic
phases. At low temperature, the Sm site is shown to possess a large 4f spin
moment of 3.4 +/- 0.1 Bohr magnetons, aligned antiparallel to the total
magnetic moment. At high temperature, the data show conclusively that ordered
magnetic moments are present on the samarium site.Comment: 5 pages, 2 figures, transferred from PRL to PRB (Rapid Comm.
Development and characterization of a microfluidic model of the tumour microenvironment
The physical microenvironment of tumours is characterized by heterotypic cell interactions and physiological gradients of nutrients, waste products and oxygen. This tumour microenvironment has a major impact on the biology of cancer cells and their response to chemotherapeutic agents. Despite this, most in vitro cancer research still relies primarily on cells grown in 2D and in isolation in nutrient- and oxygen-rich conditions. Here, a microfluidic device is presented that is easy to use and enables modelling and study of the tumour microenvironment in real-time. The versatility of this microfluidic platform allows for different aspects of the microenvironment to be monitored and dissected. This is exemplified here by real-time profiling of oxygen and glucose concentrations inside the device as well as effects on cell proliferation and growth, ROS generation and apoptosis. Heterotypic cell interactions were also studied. The device provides a live âwindowâ into the microenvironment and could be used to study cancer cells for which it is difficult to generate tumour spheroids. Another major application of the device is the study of effects of the microenvironment on cellular drug responses. Some data is presented for this indicating the deviceâs potential to enable more physiological in vitro drug screening
Testing real-time systems using TINA
The paper presents a technique for model-based black-box conformance testing of real-time systems using the Time Petri Net Analyzer TINA. Such test suites are derived from a prioritized time Petri net composed of two concurrent sub-nets specifying respectively the expected behaviour of the system under test and its environment.We describe how the toolbox TINA has been extended to support automatic generation of time-optimal test suites. The result is optimal in the sense that the set of test cases in the test suite have the shortest possible accumulated time to be executed. Input/output conformance serves as the notion of implementation correctness, essentially timed trace inclusion taking environment assumptions into account. Test cases selection is based either on using manually formulated test purposes or automatically from various coverage criteria specifying structural criteria of the model to be fulfilled by the test suite. We discuss how test purposes and coverage criterion are specified in the linear temporal logic SE-LTL, derive test sequences, and assign verdicts
Topology and Computational Performance of Attractor Neural Networks
To explore the relation between network structure and function, we studied
the computational performance of Hopfield-type attractor neural nets with
regular lattice, random, small-world and scale-free topologies. The random net
is the most efficient for storage and retrieval of patterns by the entire
network. However, in the scale-free case retrieval errors are not distributed
uniformly: the portion of a pattern encoded by the subset of highly connected
nodes is more robust and efficiently recognized than the rest of the pattern.
The scale-free network thus achieves a very strong partial recognition.
Implications for brain function and social dynamics are suggestive.Comment: 2 figures included. Submitted to Phys. Rev. Letter
Method for estimating potential recognition capacity of texture-based biometrics
When adopting an image-based biometric system, an important factor for consideration is its potential recognition capacity, since it not only defines the potential number of individuals likely to be identifiable, but also serves as a useful figure-of-merit for performance. Based on block transform coding commonly used for image compression, this study presents a method to enable coarse estimation of potential recognition capacity for texture-based biometrics. Essentially, each image block is treated as a constituent biometric component, and image texture contained in each block is binary coded to represent the corresponding texture class. The statistical variability among the binary values assigned to corresponding blocks is then exploited for estimation of potential recognition capacity. In particular, methodologies are proposed to determine appropriate image partition based on separation between texture classes and informativeness of an image block based on statistical randomness. By applying the proposed method to a commercial fingerprint system and a bespoke hand vein system, the potential recognition capacity is estimated to around 10^36 for a fingerprint area of 25 â
mm^2 which is in good agreement with the estimates reported, and around 10^15 for a hand vein area of 2268 â
mm^2 which has not been reported before
- âŠ