Elucidating the Performance Limitations of Alkaline Electrolyte Membrane Electrolysis: Dominance of Anion Concentration in Membrane Electrode Assembly

Anion exchange membrane water electrolyzers (AEMWEs) offer a cost-effective technology for producing green hydrogen. Here, an AEMWE with atmospheric plasma spray non-precious metal electrodes was tested in 0.1 to 1.0 M KOH solution, correlating performance with KOH concentration systematically. The highest cell performance was achieved at 1.0 M KOH (ca. 0.4 A cm−2 at 1.80 V), which was close to a traditional alkaline electrolysis cell with ≈6.0 M KOH. The cell exhibited 0.13 V improvement in the performance in 0.30 M KOH compared with 0.10 M KOH at 0.5 A cm−2. However, this improvement becomes more limited when further increasing the KOH concentration. Electrochemical impedance and numerical simulation results show that the ohmic resistance from the membrane was the most notable limiting factor to operate in low KOH concentration and the most sensitive to the changes in KOH concentration at 0.5 A cm−2. It is suggested that the effect of activation loss is more dominant at lower current densities; however, the ohmic loss is the most limiting factor at higher current densities, which is a current range of interest for industrial applications

Aluminosilicates and yeast-based mycotoxin binders: Their ameliorated effects on growth, immunity and serum chemistry in broilers fed aflatoxin and ochratoxin

The aim of this study was to evaluate the effects of commercial toxin binders on growth performance, organ morphology, immunity and serum biochemistry in broilers. Dietary treatments consisted of the negative control (NC): experimental diet with aflatoxin B1 <20 parts per billion (ppb), ochratoxin A (OTA) <5 ppb; control (C) experimental diet without toxin binder; Z1: toxin binder 1 g/kg of zeta plus; Z2: toxin binder 2 g/kg of zeta plus; TX1: toxin binder 1 g/kg of Toxfin Dry; and TX2: toxin binder 2 g/kg of Toxfin Dry). Except for NC, all diets contained 57 ppb aflatoxin B1 and 23 ppb ochratoxin A. Feed intake was higher in the TX1, TX2, NC, Z2 and Z1 treatments than in the control. Weight gain was higher in Z2, TX2, Z1, TX1 and NC than in C. Feed conversion ratio (FCR) was poor in C. The control had the highest liver weight, though the weights of the spleen, kidneys and hearts of the birds were similar in all treatments. Gizzard weight, thymus weight, and bursa of Fabricius were lowest in C. The weight of the pancreas was similar among treatments. The antibody titres against new castle disease were higher in treatments Z2, Z1, TX2, TX1 and NC than in C. Urea and creatinine concentrations, and aspartate aminotransferase activity in serum were similar among treatments, whereas the serum alanine transaminase activity was higher in C than in Z1, TX1, TX2, Z2 and NC. It was concluded that growth rate, FCR and immunity indices were improved in broilers fed toxin binder. At lower levels of mycotoxin in feed, 1 g/kg of toxin binder (clay based or yeast based) was sufficient to ameliorate the adverse effects of aflatoxin B1 and OTA, whereas at higher levels of mycotoxins, supplementation of toxin binder should be increased.Keywords: alanine aminotransferase, aspartate aminotransferase, carcass characteristics, growth performance, toxin binders, urea, creatinin

The Antioxidant Activity of the Leaves of Barleria grandiflora Dalz. (Acanthaceae)

Aqueous and hydro alcoholic extracts of the leaves of Barleria grandiflora Dalz. were evaluated for the antioxidant activity by the FTC and TBA methods. The results obtained in the present study indicate that the leaves of Barleria grandiflora are potential source of natural antioxidants. Initial phytochemical screenings of the extracts have shown the presence of flavanoids, tannins, saponins, carbohydrates and aminoacid

Genome analysis of amaranths: determination of inter- and intra-species variations

Amaranths are an important group of plants and include grain, vegetable and ornamental types. Despite the economic importance of the amaranths, there is very little information available about the extent and nature of genetic diversity present in the genus Amaranthus at molecular level. We now report the randomly amplified polymorphic DNA (RAPD) profiles of different species of Amaranthus as well as different accessions of the species. These RAPD analyses have been carried out using 65 arbitrary sequence decamer primers. From the RAPD data, an UPGMA dendrogram illustrating the inter-as well as intra-species relationships has been computed. The putative hybrid origin of A.dubious from A. hybridus and A. spinosus is also ruled out by the RAPD data. The trends of species relationships amongst the amaranths determined by RAPDs is consistent with their cytogenetic and evolutionary relationships that have already been determined

Geology of South and Southwest part of Uttar Pradesh and its Mineral Significance

The major part of Uttar Pradesh is covered by Gangatic alluvium in the north whereas the southern part is covered by peninsular terrain. This alluvium cover belongs to Holocene age and is mainly dominated by Varanasi older sediments exposed beyond the river basinal areas and Banda younger sediments exposed around the rivers flowing. The older alluvium comprises finer grained, well compacted and more mature sediments occupying extensive stretches at relatively higher elevations. The drainage pattern in region is subdendritic to dendritic type formed by hills and nalas flowing over the soil cover. The Peninsular part of Uttar Pradesh is covered by the rocks of Archean to Mesozoic age. The Bundelkhand craton nuclei mostly composed of Archean granitoids show heterogeneity in texture and composition, intruded by later phase of magmatic activity. The Mahrauni Group of the rocks exposed around Girar, Manpura and Rajaula areas in Madawara block of Lalitpur region. The Bijawar Group is exposed in Sonrai area district Lalitpur of Uttar Pradesh. The rocks of Dudhi Gneissic Complex and Mahakoshal Group are exposed in Sonbhadra and Mirzapur district. Few exposures of Ajabgarh Group rocks are exposed in Mathura district. These Bijawar Group, Mahakoshal Group and Ajabgarh Group rocks are equivalent to Delhi Supergroup. The Bundelkhand craton is capped by the sedimentary units of Vindhyan Supergroup which is exposed mainly in the southern part of Uttar Pradesh and a few exposures are observed in Agra district. The Deccan Trap rocks are also traces in Lalitpur district of Uttar Pradesh

Assessment of kinetic model for ceria oxidation for chemical-looping CO2 dissociation

Chemical looping technologies are identified as to have an excellent potential for CO2 capture and fuels synthesis. Oxygen carriers are the fundamental component of a chemical looping process, and the choice of stable and efficient carriers with fast redox kinetics is the key to the successful design of the process. Hence, understanding the reaction kinetics is of paramount importance for the selection of an appropriate oxygen carrier material. This work provides a method for kinetic model selection based on a statistical approach to identify the reaction mechanism. The study experimentally investigates the oxidation kinetics of CeO2-d by CO2 and applies a statistical method for the selection of the best-fitting kinetic model for the reaction. The kinetic study is performed in the temperature range of 700–1000¿°C with a CO2 concentration between 20 and 40¿vol% in the feed. The measured peak rates of CO production on ceria were influenced both by temperature and concentration of reactant. The total CO production was more influenced by the temperature than by CO2 concentration, with a maximum CO yield of 33.66¿ml/g at 1000¿°C and 40% CO2. The identification of the oxidation kinetic model is performed by fitting different reactions models to the measured reaction rates and statistically comparing them using the Residual sum of squares (RSS), Akaike information criterion (AICc) and the F-test for the selection of the best-fitting one. Models corresponding to the nucleation and grain growth reaction mechanism provided a good fit of the data, with the Sestak-Berggren (SB) model showing the best approximation of the measured rate of reaction with an evaluated activation energy of 79.1¿±¿6.5¿kJ/mol for the CO2 oxidation.Peer ReviewedPostprint (author's final draft

The impact of stringent prescription-only antimicrobial sale regulation (Schedule H1) in India: an interrupted time series analysis, 2008–18

To assess the impact of Schedule H1 regulation notified and implemented in 2014 under the amended rules of the Drugs and Cosmetics Act (DCA), 1940 on the sale of antimicrobials in the private sector in India.The dataset was obtained from the Indian pharmaceutical sales database, PharmaTrac. The outcome measure was the sales volume of antimicrobials in standard units (SUs). A quasi-experimental research design—interrupted time series analysis—was used to detect the impact of the intervention.We observed a substantial rise in antimicrobial consumption during 2008–18 in the private sector in India, both for antimicrobials regulated under Schedule H1 as well as outside the regulation. Key results suggested that post-intervention there was an immediate reduction (level change) in use of Schedule H1 antimicrobials by 10% (P = 0.007), followed by a sustained decline (trend change) in utilization by 9% (P > 0.000) compared with the pre-intervention trend. Segregated analysis on different antimicrobial classes suggests a sharp drop (level changes) and sustained decline (trend changes) in utilization post-intervention compared with the pre-intervention trend. Our findings remained robust on carrying out sensitivity analysis with the oral anti-diabetics market as a control. Post-intervention, the average monthly difference between antimicrobials under Schedule H1 and the control group witnessed an immediate increase of 16.3% (P = 0.10) followed by a sustained reduction of 0.5% (P = 0.13) compared with the pre-intervention scenario.Though the regulation had a positive impact in terms of reducing sales of antimicrobials notified under the regulation, optimizing the effectiveness of such stand-alone policies will be limited unless accompanied by a broader set of interventions

An investigation into co2–brine–cement–reservoir rock interactions for wellbore integrity in co2 geological storage

Geological storage of CO2 in saline aquifers and depleted oil and gas reservoirs can help mitigate CO2 emissions. However, CO2 leakage over a long storage period represents a potential concern. Therefore, it is critical to establish a good understanding of the interactions between CO2–brine and cement–caprock/reservoir rock to ascertain the potential for CO2 leakage. Accordingly, in this work, we prepared a unique set of composite samples to resemble the cement–reservoir rock inter-face. A series of experiments simulating deep wellbore environments were performed to investigate changes in chemical, physical, mechanical, and petrophysical properties of the composite samples. Here, we present the characterisation of composite core samples, including porosity, permeability, and mechanical properties, determined before and after long‐term exposure to CO2‐rich brine. Some of the composite samples were further analysed by X‐ray microcomputed tomography (X‐ray μ‐CT), X‐ray diffraction (XRD), and scanning electron microscopy–energy‐dispersive X‐ray (SEM–EDX). Moreover, the variation of ions concentration in brine at different timescales was studied by per-forming inductively coupled plasma (ICP) analysis. Although no significant changes were observed in the porosity, permeability of the treated composite samples increased by an order of magnitude, due mainly to an increase in the permeability of the sandstone component of the composite samples, rather than the cement or the cement/sandstone interface. Mechanical properties, including Young’s modulus and Poisson’s ratio, were also reduced