38,803 research outputs found
Millimeter-wave antenna system
Parabolic reflectors fabricated from Carbon Fiber Reinforced Plastic (CFRP) composite material will not distort their shape by more than 3 percent of millimeter wavelength, despite large temperature differences on reflector surfaces. CFRP has zero thermal expansion. It is derived from charred polyacrylonitrite plastic filaments that are combined with epoxy resin
Making a national atlas of population by computer
This paper describes the conceptual and practical problems encountered and solved in producing a multi-colour atlas of population characteristics in Great Britain. The atlas itself is in A4 format; it consists of some thirty-four maps of Great Britain in four colours and the same number of regional maps, together with descriptive text. All maps were plotted on a laser plotter with a resolution of 127 microns. The paper describes how mapping of ratios, such as percentages, was found to be highly misleading and describes the novel probability mapping solution adopted, based on the signed chi-square statistic. In addition, the rationale for selecting the class intervals and for selecting colour schemes is described
Smilansky's model of irreversible quantum graphs, II: the point spectrum
In the model suggested by Smilansky one studies an operator describing the
interaction between a quantum graph and a system of K one-dimensional
oscillators attached at different points of the graph. This paper is a
continuation of our investigation of the case K>1. For the sake of simplicity
we consider K=2, but our argument applies to the general situation. In this
second paper we apply the variational approach to the study of the point
spectrum.Comment: 18 page
Indoor radio channel characterization and modeling for a 5.2-GHz bodyworn receiver
[Abstract]: Wireless local area network applications may include the use of bodyworn or handportable terminals. For the first time, this paper compares measurements and simulations of a narrowband 5.2-GHz radio channel incorporating a fixed transmitter and a mobile bodyworn receiver. Two indoor environments were considered,
an 18-m long corridor and a 42-m2 office. The modeling
technique was a site-specific ray-tracing simulator incorporating the radiation pattern of the bodyworn receiver. In the corridor, the measured body-shadowing effect was 5.4 dB, while it was 15.7 dB in the office. First- and second-order small-scale fading statistics
for the measured and simulated results are presented and compared with theoretical Rayleigh and lognormal distributions. The root mean square error in the cumulative distributions for the simulated results was less than 0.74% for line-of-sight conditions and less than 1.4% for nonline-of-sight conditions
Propagation modelling and measurements in a populated indoor environment at 5.2 GHz
There are a number of significant radiowave propagation phenomena present in the populated indoor environment, including multipath fading and human body effects. The latter can be divided into shadowing and scattering caused by pedestrian movement, and antenna-body interaction with bodyworn or hand portable terminals [1]. Human occupants within indoor environments are not always stationary and their movement will lead to temporal channel variations that can strongly affect the quality of indoor wireless communication systems. Hence, populated environments remain a major challenge for wireless local area networks (WLAN) and other indoor communication systems. Therefore, it is important to develop an understanding of the potential and limitations of indoor radiowave propagation at key frequencies of interest, such as the 5.2 GHz band employed by commercial wireless LAN standards such as IEEE 802.11a and HiperLAN 2.
Although several indoor wireless models have been proposed in the literature, these temporal variations have not yet been thoroughly investigated. Therefore, we have made an important contribution to the area by conducting a systematic study of the problem, including a propagation measurement campaign and statistical channel characterization of human body effects on line-of-sight indoor propagation at 5.2 GHz.
Measurements were performed in the everyday environment of a 7.2 m wide University hallway to determine the statistical characteristics of the 5.2 GHz channel for a fixed, transverse line-of-sight (LOS) link perturbed by pedestrian movement. Data were acquired at hours of relatively high pedestrian activity, between 12.00 and 14.00. The location was chosen as a typical indoor wireless system environment that had sufficient channel variability to permit a valid statistical analysis.
The paper compares the first and second order statistics of the empirical signals with the Gaussian-derived distributions commonly used in wireless communications. The analysis shows that, as the number of pedestrians within the measurement location increases, the Ricean K-factor that best fits the Cumulative Distribution Function (CDF) of the empirical data tends to decrease proportionally, ranging from K=7 with 1 pedestrian to K=0 with 4 pedestrians. These results are consistent with previous results obtained for controlled measurement scenarios using a fixed link at 5.2 GHz in [2], where the K factor reduced as the number of pedestrians within a controlled measurement area increased. Level crossing rate results were Rice distributed, considering a maximum Doppler frequency of 8.67 Hz. While average fade duration results were significantly higher than theoretically computed Rice and Rayleigh, due to the fades caused by pedestrians.
A novel statistical model that accurately describes the 5.2 GHz channel in the considered indoor environment is proposed. For the first time, the received envelope CDF is explicitly described in terms of a quantitative measurement of pedestrian traffic within the indoor environment. The model provides an insight into the prediction of human body shadowing effects for indoor channels at 5.2 GHz
The tidal stripping of satellites
We present an improved analytic calculation for the tidal radius of
satellites and test our results against N-body simulations.
The tidal radius in general depends upon four factors: the potential of the
host galaxy, the potential of the satellite, the orbit of the satellite and
{\it the orbit of the star within the satellite}. We demonstrate that this last
point is critical and suggest using {\it three tidal radii} to cover the range
of orbits of stars within the satellite. In this way we show explicitly that
prograde star orbits will be more easily stripped than radial orbits; while
radial orbits are more easily stripped than retrograde ones. This result has
previously been established by several authors numerically, but can now be
understood analytically. For point mass, power-law (which includes the
isothermal sphere), and a restricted class of split power law potentials our
solution is fully analytic. For more general potentials, we provide an equation
which may be rapidly solved numerically. Over short times (\simlt 1-2 Gyrs
satellite orbit), we find excellent agreement between our analytic and
numerical models. Over longer times, star orbits within the satellite are
transformed by the tidal field of the host galaxy. In a Hubble time, this
causes a convergence of the three limiting tidal radii towards the prograde
stripping radius. Beyond the prograde stripping radius, the velocity dispersion
will be tangentially anisotropic.Comment: 10 pages, 5 figures. Final version accepted for publication in MNRAS.
Some new fully analytic tidal radii have been added for power law density
profiles (including the isothermal sphere) and some split power law
Kinetic pathways of multi-phase surfactant systems
The relaxation following a temperature quench of two-phase (lamellar and
sponge phase) and three-phase (lamellar, sponge and micellar phase) samples,
has been studied in an SDS/octanol/brine system. In the three-phase case we
have observed samples that are initially mainly sponge phase with lamellar and
micellar phase on the top and bottom respectively. Upon decreasing temperature
most of the volume of the sponge phase is replaced by lamellar phase. During
the equilibriation we have observed three regimes of behaviour within the
sponge phase: (i) disruption in the sponge texture, then (ii) after the sponge
phase homogenises there is a lamellar nucleation regime and finally (iii) a
bizarre plume connects the lamellar phase with the micellar phase. The
relaxation of the two-phase sample proceeds instead in two stages. First
lamellar drops nucleate in the sponge phase forming a onion `gel' structure.
Over time the lamellar structure compacts while equilibriating into a two phase
lamellar/sponge phase sample. We offer possible explanatioins for some of these
observations in the context of a general theory for phase kinetics in systems
with one fast and one slow variable.Comment: 1 textfile, 20 figures (jpg), to appear in PR
- âŠ