Lithostratigraphy and geochemical characterization of limestone deposits around Kushimaga Area in Yobe Of North-Eastern Nigeria

This study presents detailed petrographic and chemical compositional characteristic of limestone deposits for possible industrial uses and specifications. The study area falls within the Gongola basin, North-eastern Nigeria. Core limestone samples were collected from four boreholes at the depth of approximately 25 metres each in Kushimaga area around Gulani in Yobe state; north-eastern Nigeria. Lithological units were observed in the following sequence; topsoil and clay with an average thickness of 1.513m, limestone 5.553m, shale 7.853m respectively. Eleven limestone samples were selected from the boreholes for petrography and chemical analysis (Fluorescence Spectroscopy analysis). From the petrograhic studies the limestone samples are composed (visual estimate) of over 95% calcite, trace amounts of colourless already recrystallized fossil of planktonic forams and mollusc, weakly deformed greenish grains of glauconite about 0.2 to 0.3 mm in grain size, traces of opaque, isotropic, high relief iron oxide minerals with 0.03 to 0.5 mm grains sizes are present disseminated in the form of limonite. Traces of quartz and feldspar grains of silt size class were also noted in thin sections. With less than 10% grains the samples are classified as mudstone. The results of chemical analyses of limestone shows a range values of SiO2, 10.05wt% to 32.00wt% , CaO, 21.00wt% to 53.99wt%, MgO, 0.35wt% to 1.00wt%, Al2O3, 2.15wt% to 12.69wt%, Fe2O3, 1.28wt% to 4.90wt%, Na2O, 0.002wt% to 0.18wt%, K2O, 0.9wt% to 1.96wt%, TiO2, 0.21wt% to 1.00wt%, P2O5, 0.17wt% to 0.69wt%, MnO, 0.21wt% to 0.55wt%, loss on ignition, 21.98% to 36.87%, while the result of chemical classification of the limestone show a range of Ca/Mg, 23.33% to 125.68% and Mg/Ca, 0.00% to 0.04% of the Kushimaga limestone. However, the limestone beds of the research area were compared with other standard chemical industrial specifications. The study revealed that the limestone around Kushimaga area satisfies the chemical factors for Portland cement production but falls below the standard chemical specifications for other industrial uses; glass, sugar and Paint pigments and filler productions.Keywords: Argillaceous, bivariant, core, lithology, petrography and stratigraph

Etude Comparative Des Produits Issus De La Transformation En Filature Des Fibres De Trois Nouvelles Variétés De Cotonnier

Résumé - Au Mali, comme ailleurs en Afrique, la sélection variétale est à la base du succès de la culture cotonnière. Le coton du Mali est presqu’entièrement exporté ; les fibres issues des variétés cultivées doivent répondre aux exigences du marché en termes de caractéristiques technologiques des fibres, facteurs clés du fonctionnement de la filature. Cette étude comparative a été réalisée sur trois nouvelles variétés de cotonniers A, B et C, issues d’un point d'expérimentation. L'objectif de l'étude est d’identifier les variétés ayant les meilleures performances variétales et industrielles pour la vulgarisation en production commerciale par les sociétés cotonnières. 1 échantillon représentatif de 100g de coton fibre, 20 échantillons de 5 m de rubans de carde, d’étirage et de 10 m de mèches, 30 échantillons de 100 m de fil et 40 échantillons de 500 mm de fil ont été respectivement prélevés par balle de chaque variété et à différentes étapes du processus de transformation par variété. Ces échantillons ont été testés sur des appareils de mesure dans les conditions requises au laboratoire de métrologie textile du CERFITEX, Ségou - Mali.L’analyse de variance (ANOVA) des données relatives aux fibres, rubans, mèches et fils et la comparaison de leurs principales caractéristiques de qualité à celle de la production mondiale avec l’application des USTER STATISTICS 2018 ont montré que les variétés de cotonnier A et B sont nettement meilleures que celle de C. Les performances variétales et industrielles de A et B, meilleures que celles de C sont recommandées à la vulgarisation Mots clés : Coton, caractéristiques technologiques, qualité, fibres, fils. [Comparative Study Of The Products Resulting From The Transformation Into Spinning Of The Fibers Of Three New Varieties Of Cotton]Abstract - In Mali, as elsewhere in Africa, varietal selection is the basis of the success of cotton growing. Cotton from Mali is almost entirely exported; fibers from cultivated varieties must meet market requirements in terms of the technological characteristics of fibers, key factors in the operation of the spinning mill. This comparative study was carried out on three new varieties of cotton A, B and C, from an experimental point. The objective of the study is to identify the varieties with the best varietal and industrial performance for popularization in commercial production by cotton companies. 1 representative sample of 100g of cotton fiber, 20 samples of 5m of carding and drawing slivers and 10m of rovings, 30 samples of 100m of yarn and 40 samples of 500mm of yarn were respectively taken per bale of each variety and at different stages of the transformation process by variety. These samples were tested on measuring devices under the required conditions at the CERFITEX textile metrology laboratory, Ségou - Mali.The analysis of variance (ANOVA) of fiber, sliver, roving and yarn data and the comparison of their main quality characteristics to that of world production with the application of USTER STATISTICS 2018 showed that cotton varieties A and B are clearly better than those of C. The varietal and industrial performances of A and B, better than that of C are recommended for popularisation Keywords : Cotton, technological characteristics, quality, fibres, yarns

The Influence of Some Pyrazole Derivatives on The Corrosion Behaviour of Mild Steel in 1M HCl Solution

Abstract The inhibitive action of some pyrazole derivatives, namely N1, N1-bis (2-(bis ((3,5-dimethyl-1H-pyrazol-1-yl) methyl) amino)ethyl)-N2, N2-bis ((3,5-dimethyl-1H-pyrazol-1-yl) methyl) ethane-1,2-diamine: PAP and diethyl 1,1'-(((4-acetylphenyl) azanediyl) bis (methylene)) bis (5-methyl-1H-pyrazole-3-carboxylate): PAC against the corrosion of mild steel in 1 M HCl solution has been investigated using weight loss measurements, Tafel polarisation and electrochemical impedance spectroscopy (EIS) techniques. The experimental results obtained revealed that these compounds inhibited the steel corrosion in acid solution, the protection efficiency increased with increasing inhibitors concentration. The results obtained from the different corrosion evaluation techniques are in good agreement. Potentiodynamic polarisation studies clearly showed that PAP and PAC acted as mixed inhibitors affecting both cathodic and anodic corrosion currents. Adsorption of these inhibitors on steel surface obeyed to Langmuir adsorption isotherm. Thermodynamic data of adsorption showed that inhibition of steel corrosion in 1M HCl solution by pyrazole compounds is due to the formation of a chemisorbed film on the steel surface. SEM and EDX supported the adsorption conclusions

Thymoquinone-induced conformational changes of PAK1 interrupt prosurvival MEK-ERK signaling in colorectal cancer

Background Thymoquinone (TQ) was shown to reduce tumor growth in several cancer models both in vitro and in vivo. So far only a few targets of TQ, including protein kinases have been identified. Considering that kinases are promising candidates for targeted anticancer therapy, we studied the complex kinase network regulated by TQ. Methods Novel kinase targets influenced by TQ were revealed by in silico analysis of peptide array data obtained from TQ-treated HCT116wt cells. Western blotting and kinase activity assays were used to determine changes in kinase expression patterns in colorectal cancer cells (HCT116wt, DLD-1, HT29). To study the viability/apoptotic effects of combining the PAK1 inhibitor IPA-3 and TQ, crystal violet assay and AnnexinV/PI staining were employed. Interactions between PAK1 and ERK1/2 were investigated by co-immunoprecipitation and modeled by docking studies. Transfection with different PAK1 mutants unraveled the role of TQ-induced changes in PAK1 phosphorylation and TQ´s effects on PAK1 scaffold function. Results Of the 104 proteins identified, 50 were upregulated ≥2 fold by TQ and included molecules in the AKT-MEK-ERK1/2 pathway. Oncogenic PAK1 emerged as an interesting TQ target. Time-dependent changes in two PAK1 phosphorylation sites generated a specific kinase profile with early increase in pPAKThr212 followed by late increase in pPAKThr423. TQ induced an increase of pERK1/2 and triggered the early formation of an ERK1/2-PAK1 complex. Modeling confirmed that TQ binds in the vicinity of Thr212 accompanied by conformational changes in ERK2-PAK1 binding. Transfecting the cells with the non-phosphorylatable mutant T212A revealed an increase of pPAKThr423 and enhanced apoptosis. Likewise, an increase in apoptosis was observed in cells transfected with both the kinase-dead K299R mutant and PAK1 siRNA. Using structural modeling we suggest that TQ interferes also with the kinase domain consequently disturbing its interaction with pPAKThr423, finally inhibiting MEK-ERK1/2 signaling and disrupting its prosurvival function. pERK1/2 loss was also validated in vivo. Conclusions Our study shows for the first time that the small molecule TQ directly binds to PAK1 changing its conformation and scaffold function. Because TQ affects the central RAF/MEK/ERK1/2 pathway, the combination of TQ with targeted therapies is worth considering for future anticancer treatments

Interferometry of Direct Photons in Central 280Pb+208Pb Collisions at 158A GeV

Two-particle correlations of direct photons were measured in central 208Pb+208Pb collisions at 158 AGeV. The invariant interferometric radii were extracted for 100<K_T<300 MeV/c and compared to radii extracted from charged pion correlations. The yield of soft direct photons, K_T<300 MeV/c, was extracted from the correlation strength and compared to theoretical calculations.Comment: 5 pages, 4 figure

Systematics of Inclusive Photon Production in 158 AGeV Pb Induced Reactions on Ni, Nb, and Pb Targets

The multiplicity of inclusive photons has been measured on an event-by-event basis for 158 AGeV Pb induced reactions on Ni, Nb, and Pb targets. The systematics of the pseudorapidity densities at midrapidity (rho_max) and the width of the pseudorapidity distributions have been studied for varying centralities for these collisions. A power law fit to the photon yield as a function of the number of participating nucleons gives a value of 1.13+-0.03 for the exponent. The mean transverse momentum, , of photons determined from the ratio of the measured electromagnetic transverse energy and photon multiplicity, remains almost constant with increasing rho_max. Results are compared with model predictions.Comment: 16 pages including 4 figure

Event-by-Event Fluctuations in Particle Multiplicities and Transverse Energy Produced in 158.A GeV Pb+Pb collisions

Event-by-event fluctuations in the multiplicities of charged particles and photons, and the total transverse energy in 158$\cdot A$ GeV Pb+Pb collisions are studied for a wide range of centralities. For narrow centrality bins the multiplicity and transverse energy distributions are found to be near perfect Gaussians. The effect of detector acceptance on the multiplicity fluctuations has been studied and demonstrated to follow statistical considerations. The centrality dependence of the charged particle multiplicity fluctuations in the measured data has been found to agree reasonably well with those obtained from a participant model. However for photons the multiplicity fluctuations has been found to be lower compared to those obtained from a participant model. The multiplicity and transverse energy fluctuations have also been compared to those obtained from the VENUS event generator.Comment: To appear in Physical Review C; changes : more detailed discussion on errors and few figures modifie