Mineral exploration potential of ERTS-1 data

The author has identified the following significant results. Preliminary analysis of a mosaic composing eight individual ERTS frames (1:1,000,000) extending well beyond the test site has revealed a number of tectonic structural trends that are controlled by regional lineations. So far most of the regional lineations fall into three general directions: east by northeast, northwest, and north-south. From preliminary examination, it appears that the older Precambrian basement predominates in the NE-bearing structural trends, whereas the predominate NW trend is most likely associated with the Texas Structural Zone, and the north-south trend being the Utah-Arizona belt and/or part of the southern Basin and Range Province. One major lineation, made up of many parallel lineations, is noticeable just north of Lake Pleasant which extends for approximately 100 miles in a northern direction out of the target area. This feature corresponds to a Precambrian schist formation shown on the USGS geologic map of Arizona

Mineral exploration potential of ERTS-1 data

The author has identified the following significant results. ERTS-1 imagery of an area approximately 15,000 square miles in Arizona was interpreted for regional structure and tectonic units. Eight fault systems were identified by trend, of which two, northeast and northwest, are considered to be related to porphyry copper mineralization. Nine tectonic units can be identified on the imagery as distinct geological identities. The boundaries between these units can be correlated with theoretical shear directions related to the San Andreas stress system. Fourier analysis of the N 50 W fault trend indicates a fundamental spacing between Fourier energy maxima that can be related to distances between copper deposits

Low-cost point-focus solar concentrator, phase 1

The results of the preliminary design study for the low cost point focus solar concentrator (LCPFSC) development program are presented. A summary description of the preliminary design is given. The design philosophy used to achieve a cost effective design for mass production is described. The concentrator meets all design requirements specified and is based on practical design solutions in every possible way

High-resolution broadband spectroscopy using externally dispersed interferometry at the Hale telescope: Part 1, data analysis and results

High-resolution broadband spectroscopy at near-infrared wavelengths (950 to 2450 nm) has been performed using externally dispersed interferometry (EDI) at the Hale telescope at Mt. Palomar. Observations of stars were performed with the “TEDI” interferometer mounted within the central hole of the 200-in. primary mirror in series with the comounted TripleSpec near-infrared echelle spectrograph. These are the first multidelay EDI demonstrations on starlight, as earlier measurements used a single delay or laboratory sources. We demonstrate very high (10×) resolution boost, from original 2700 to 27,000 with current set of delays (up to 3 cm), well beyond the classical limits enforced by the slit width and detector pixel Nyquist limit. Significantly, the EDI used with multiple delays rather than a single delay as used previously yields an order of magnitude or more improvement in the stability against native spectrograph point spread function (PSF) drifts along the dispersion direction. We observe a dramatic (20×) reduction in sensitivity to PSF shift using our standard processing. A recently realized method of further reducing the PSF shift sensitivity to zero is described theoretically and demonstrated in a simple simulation which produces a 350× times reduction. We demonstrate superb rejection of fixed pattern noise due to bad detector pixels—EDI only responds to changes in pixel intensity synchronous to applied dithering. This part 1 describes data analysis, results, and instrument noise. A section on theoretical photon limited sensitivity is in a companion paper, part 2

Proton-Neutron Interaction near Closed Shells

Odd-odd nuclei around double shell closures are a direct source of information on the proton-neutron interaction between valence nucleons. We have performed shell-model calculations for doubly odd nuclei close to $^{208}$Pb, $^{132}$Sn and $^{100}$Sn using realistic effective interactions derived from the CD-Bonn nucleon-nucleon potential. The calculated results are compared with the available experimental data, attention being focused on particle-hole and particle-particle multiplets. While a good agreement is obtained for all the nuclei considered, a detailed analysis of the matrix elements of the effective interaction shows that a stronger core-polarization contribution seems to be needed in the particle-particle case.Comment: 8 pages, 6 figures, Proccedings of the International Conference "Nuclear Structure and Related Topics", Dubna, Russia, September 2-6, 2003, to be published in Yadernaia Fizika (Physics of Atomic Nuclei

Carrier-Induced Magnetic Circular Dichloism in the Magnetoresistive Pyrochlore Tl2Mn2O7

Infrared magnetic circular dichloism (MCD), or equivalently magneto-optical Kerr effect, has been measured on the Tl2Mn2O7 pyrochlore, which is well known for exhibiting a large magnetoresistance around the Curie temperature T_C ~ 120 K. A circularly polarized, infrared synchrotron radiation is used as the light source. A pronounced MCD signal is observed exactly at the plasma edge of the reflectivity near and below T_c. However, contrary to the conventional behavior of MCD for ferromagnets, the observed MCD of Tl2Mn2O7 grows with the applied magnetic field, and not scaled with the internal magnetization. It is shown that these results can be basically understood in terms of a classical magnetoplasma resonance. The absence of a magnetization-scaled MCD indicates a weak spin-orbit coupling of the carriers in Tl2Mn2O7. We discuss the present results in terms of the microscopic electronic structures of Tl2Mn2O7.Comment: 5 pages, 5 figures, submitted to J. Phys. Soc. Jp

Nanocomposites of polymer and inorganic nanoparticles for optical and magnetic applications

This article provides an up-to-date review on nanocomposites composed of inorganic nanoparticles and the polymer matrix for optical and magnetic applications. Optical or magnetic characteristics can change upon the decrease of particle sizes to very small dimensions, which are, in general, of major interest in the area of nanocomposite materials. The use of inorganic nanoparticles into the polymer matrix can provide high-performance novel materials that find applications in many industrial fields. With this respect, frequently considered features are optical properties such as light absorption (UV and color), and the extent of light scattering or, in the case of metal particles, photoluminescence, dichroism, and so on, and magnetic properties such as superparamagnetism, electromagnetic wave absorption, and electromagnetic interference shielding. A general introduction, definition, and historical development of polymer–inorganic nanocomposites as well as a comprehensive review of synthetic techniques for polymer–inorganic nanocomposites will be given. Future possibilities for the development of nanocomposites for optical and magnetic applications are also introduced. It is expected that the use of new functional inorganic nano-fillers will lead to new polymer–inorganic nanocomposites with unique combinations of material properties. By careful selection of synthetic techniques and understanding/exploiting the unique physics of the polymeric nanocomposites in such materials, novel functional polymer–inorganic nanocomposites can be designed and fabricated for new interesting applications such as optoelectronic and magneto-optic applications

Nonsynchronous, episodic incision: Evidence of threshold exceedance and complex response as controls of terrace formation

Terrace sequences can represent regional or continental scale factors such as climatic fluctuations, neotectonic activity, and base-level change. However, they can also reflect random incision events brought about by local scale, geomorphic threshold exceedance, and subsequent complex response. This study explores the formative processes of three discontinuous, but adjacent, late Pleistocene to late Holocene stepterrace sequences in southeastern Australia. Correlation of river terrace fills was undertaken by comparing terrace remnants based on topography, morphology, sedimentology, stratigraphy, and chronology. A geomorphic model of floodplain abandonment and terrace formation for this valley setting is presented. Most of southeastern Australia has shown no evidence of tectonic uplift during the late Quaternary. Bedrock bars on the Hunter River isolate the study reach from downstream base-level changes. The nonsynchronous, episodic behavior of incision events in this catchment strongly indicates that climate is not a dominant control on terrace formation. With the exclusion of climatic fluctuations, tectonic uplift and base-level change as causes of incision, catastrophic floods, and the exceedance of geomorphic thresholds emerge as the dominant controls of terrace formation. Crow

Observation of magnetic circular dichroism in Fe L_{2,3} x-ray-fluorescence spectra

We report experiments demonstrating circular dichroism in the x-ray-fluorescence spectra of magnetic systems, as predicted by a recent theory. The data, on the L_{2,3} edges of ferromagnetic iron, are compared with fully relativistic local spin density functional calculations, and the relationship between the dichroic spectra and the spin-resolved local density of occupied states is discussed