3,725 research outputs found
Energy-Aware Competitive Power Allocation for Heterogeneous Networks Under QoS Constraints
This work proposes a distributed power allocation scheme for maximizing
energy efficiency in the uplink of orthogonal frequency-division multiple
access (OFDMA)-based heterogeneous networks (HetNets). The user equipment (UEs)
in the network are modeled as rational agents that engage in a non-cooperative
game where each UE allocates its available transmit power over the set of
assigned subcarriers so as to maximize its individual utility (defined as the
user's throughput per Watt of transmit power) subject to minimum-rate
constraints. In this framework, the relevant solution concept is that of Debreu
equilibrium, a generalization of Nash equilibrium which accounts for the case
where an agent's set of possible actions depends on the actions of its
opponents. Since the problem at hand might not be feasible, Debreu equilibria
do not always exist. However, using techniques from fractional programming, we
provide a characterization of equilibrial power allocation profiles when they
do exist. In particular, Debreu equilibria are found to be the fixed points of
a water-filling best response operator whose water level is a function of
minimum rate constraints and circuit power. Moreover, we also describe a set of
sufficient conditions for the existence and uniqueness of Debreu equilibria
exploiting the contraction properties of the best response operator. This
analysis provides the necessary tools to derive a power allocation scheme that
steers the network to equilibrium in an iterative and distributed manner
without the need for any centralized processing. Numerical simulations are then
used to validate the analysis and assess the performance of the proposed
algorithm as a function of the system parameters.Comment: 37 pages, 12 figures, to appear IEEE Trans. Wireless Commu
Study of RPC gas mixtures for the ARGO-YBJ experiment
The ARGO-YBJ experiment consists of a RPC carpet to be operated at the
Yangbajing laboratory (Tibet, P.R. China), 4300 m a.s.l., and devoted to the
detection of showers initiated by photon primaries in the energy range 100 GeV
- 20 TeV. The measurement technique, namely the timing on the shower front with
a few tens of particles, requires RPC operation with 1 ns time resolution, low
strip multiplicity, high efficiency and low single counting rate. We have
tested RPCs with many gas mixtures, at sea level, in order to optimize these
parameters. The results of this study are reported.Comment: 6 pages, 3 figures. To be published in Nucl. Instr. Meth. A, talk
given at the "5th International Workshop on RPCs and Related Detectors", Bari
(Italy) 199
Distributed energy-efficient power optimization in cellular relay networks with minimum rate constraints
In this work, we derive a distributed power control algo- rithm for energy-efficient uplink transmissions in interference- limited cellular networks, equipped with either multiple or shared relays. The proposed solution is derived by model- ing the mobile terminals as utility-driven rational agents that engage in a noncooperative game, under minimum-rate con- straints. The theoretical analysis of the game equilibrium is used to compare the performance of the two different cellular architectures. Extensive simulations show that the shared relay concept outperforms the distributed one in terms of energy efficiency in most network configurations
Plasma boosted electron beams for driving Free Electron Lasers
In this paper, we report results of simulations, in the framework of both
EuPRAXIA \cite{Walk2017} and EuPRAXIA@SPARC\_LAB \cite{Ferr2017} projects,
aimed at delivering a high brightness electron bunch for driving a Free
Electron Laser (FEL) by employing a plasma post acceleration scheme. The
boosting plasma wave is driven by a tens of \SI{}{\tera\watt} class laser and
doubles the energy of an externally injected beam up to \GeV{1}. The injected
bunch is simulated starting from a photoinjector, matched to plasma, boosted
and finally matched to an undulator, where its ability to produce FEL radiation
is verified to yield O(\num{e11}) photons per shot at \nm{2.7}.Comment: 5 pages, 2 figure
A collimation system for ELI-NP Gamma Beam System - design and simulation of performance
The purpose of this study was to evaluate the performance and refine the design of the collimation system for the gamma radiation source (GBS) currently being realised at ELI-NP facility. The gamma beam, produced by inverse Compton scattering, will provide a tunable average energy in the range between 0.2 and 20Ă‚ MeV, an energy bandwidth 0.5% and a flux of about 108Ă‚ photons/s. As a result of the inverse Compton interaction, the energy of the emitted radiation is related to the emission angle, it is maximum in the backscattering direction and decreases as the angle increase [1,2]. Therefore, the required energy bandwidth can be obtained only by developing a specific collimation system of the gamma beam, i.e. filtering out the radiation emitted at larger angles. The angular acceptance of the collimation for ELI-NP-GBS must be continuously adjustable in a range from about 700 to 60Ă‚ ĂŽÂĽrad, to obtain the required parameters in the entire energy range. The solution identified is a stack of adjustable slits, arranged with a relative rotation around the beam axis to obtain an hole with an approximately circular shape. In this contribution, the final collimation design and its performance evaluated by carrying out a series of detailed Geant4 simulations both of the high-energy and the low-energy beamline are presented
EuPRAXIA@SPARC_LAB: the high-brightness RF photo-injector layout proposal
At EuPRAXIA@SPARC_LAB, the unique combination of an advanced high-brightness
RF injector and a plasma-based accelerator will drive a new multi-disciplinary
user-facility. The facility, that is currently under study at INFN-LNF
Laboratories (Frascati, Italy) in synergy with the EuPRAXIA collaboration, will
operate the plasma-based accelerator in the external injection configuration.
Since in this configuration the stability and reproducibility of the
acceleration process in the plasma stage is strongly influenced by the
RF-generated electron beam, the main challenge for the RF injector design is
related to generating and handling high quality electron beams. In the last
decades of R&D activity, the crucial role of high-brightness RF photo-injectors
in the fields of radiation generation and advanced acceleration schemes has
been largely established, making them effective candidates to drive
plasma-based accelerators as pilots for user facilities. An RF injector
consisting in a high-brightness S-band photo-injector followed by an advanced
X-band linac has been proposed for the EuPRAXIA@SPARC_LAB project. The electron
beam dynamics in the photo-injector has been explored by means of simulations,
resulting in high-brightness, ultra-short bunches with up to 3 kA peak current
at the entrance of the advanced X-band linac booster. The EuPRAXIA@SPARC_LAB
high-brightness photo-injector is described here together with performance
optimisation and sensitivity studies aiming to actual check the robustness and
reliability of the desired working point.Comment: 5 pages,5 figures, EAAC201
- …