Carbon films grown from plasma on III-V semiconductors

Dielectric carbon films were grown on n- and p-type GaAs and InP substrates using plasmas generated at 30 KHz from gaseous hydrocarbons. The effect of gas source, flow rate, and power on film growth were investigated. Methane and n-butane gases were utilized. The flow rate and power ranged from 30 to 50 sccm and 25 to 300 W, respectively. AES measurements show only carbon to be present in the films. The relative Ar ion sputtering rate (3 KeV) of carbon depends on the ratio power/pressure. In addition, the degree of asymmetry associated with the carbon-semiconductor interface is approximately power-independent. SIMS spectra indicate different H-C bonding configurations to be present in the films. Band gaps as high as 3.05 eV are obtained from optical absorption studies

The role of the helicopter in transportation

A general overview is presented of the role that the helicopter plays in the current aviation scene with special emphasis on its use in the airport access function. Technological problems of present-day aircraft are discussed along with some plausible solutions. The economic and regulatory aspects of commercial helicopter operations are presented. Finally six commercial operations utilizing helicopters are reviewed and conditions that enhance the success of the helicopter in the airport access function are proposed

Maximum normalized acceleration as a flying qualities parameter

In 1984, Maximum Normalized Rate (MNR) was presented as a Flying Qualities parameter. Subsequent analysis of data from ground based simulation and flight test revealed the utility of a companion parameter, Maximum Normalized Acceleration (MNA). MNR and MNA profiles reveal the presence of both continuous and pulsed compensation strategies during discrete attitude tracking. In addition, MNR appears to be a suitable metric for pilot opinion in the LATHOS data base, while the MNR/MNA relationship is sensitive to pilot-induced-oscillation (PIO) and roll ratcheting problems. As part of an investigation of this problem, Northrop has developed an analysis technique known as the Step Target Method. The Step Target method is essentially a one degree-of-freedom simulation, where an attitude command in the form of a step function is presented to a closed-loop pilot/aircraft model. The two parameters MNR and MNA were shown to be useful in Flying Qualities analysis. MNR was shown to correlate with Pilot Opinion Rating in the LATHOS data base, while MNA reflects PIO and roll ratcheting. Profiles of MNR versus MNA reveal the presence of pulsed compensation strategies in both ground based and in-flight simulation. Furthermore, comparison of continuous and discrete attitude tracking simulation data reveals that these two tracking tasks exhibit independent sensitivities to aircraft characteristics

Investigating the BPS Spectrum of Non-Critical E_n Strings

We use the effective action of the $E_n$ non-critical strings to study its BPS spectrum for $0 \le n \le 8$. We show how to introduce mass parameters, or Wilson lines, into the effective action, and then perform the appropriate asymptotic expansions that yield the BPS spectrum. The result is the $E_n$ character expansion of the spectrum, and is equivalent to performing the mirror map on a Calabi-Yau with up to nine K\"ahler moduli. This enables a much more detailed examination of the $E_n$ structure of the theory, and provides extensive checks on the effective action description of the non-critical string. We extract some universal ($E_n$ independent) information concerning the degeneracies of BPS excitations.Comment: 50 pages, harvmac (b

Eccentric discs in binaries with intermediate mass ratios: Superhumps in the VY Sculptoris stars

We investigate the role of the eccentric disc resonance in systems with mass ratios q greater than 1/4, and demonstrate the effects that changes in the mass flux from the secondary star have upon the disc radius and structure. The addition of material with low specific angular momentum to its outer edge restricts a disc radially. Should the mass flux from the secondary be reduced, it is possible for the disc in a system with mass ratio as large as 1/3 to expand to the 3:1 eccentric inner Lindblad resonance and for superhumps to be excited.Comment: 6 pages with 7 figures, accepted by MNRA

Flight test of navigation and guidance sensor errors measured on STOL approaches

Navigation and guidance sensor error characteristics were measured during STOL approach-flight investigations. Data from some of the state sensors of a digital avionics system were compared to corresponding outputs from an inertial navigation system. These sensors include the vertical gyro, compass, and accelerometers. Barometric altimeter data were compared to altitude measured by a tracking radar. Data were recorded with the Augmentor Wing Jet STOL Research Aircraft parked and in flight

Maximum Normalized Rate as a Flying Qualities Parameter

Discrete attitude commands have become a standard task for flying qualities evaluation and control system testing. Much pilot opinion data is now available for ground-based and in-flight simulations, but adequate performance measures and prediction methods have not been established. The Step Target Tracking Prediction method, introduced in 1978, correlated time-on-target and rms tracking data with NT-33 in-flight longitudinal simulations, but did not employ parameters easily measured in manned flight and simulation. Recent application of the Step Target Tracking Prediction method to lateral flying qualities analysis has led to a new measure of performance. This quantity, called Maximum Normalized Rate (MNR), reflects the greatest attitude rate a pilot can employ during a discrete maneuver without excessive overshoot and oscillation. MNR correlates NT-33 lateral pilot opinion ratings well, and is easily measured during flight test or simulation. Futhermore, the Step Target MNR method can be used to analyze large amplitude problems concerning rate limiting and nonlinear aerodynamics

Auger electron spectroscopy, secondary ion mass spectroscopy and optical characterization of a-C-H and BN films

The amorphous dielectrics a-C:H and BN were deposited on III-V semiconductors. Optical band gaps as high as 3 eV were measured for a-C:H generated by C4H10 plasmas; a comparison was made with bad gaps obtained from films prepared by CH4 glow discharges. The ion beam deposited BN films exhibited amorphous behavior with band gaps on the order of 5 eV. Film compositions were studied by Auger electron spectroscopy (AES), x-ray photoelectron spectroscopy (XPS) and secondary ion mass spectrometry (SIMS). The optical properties were characterized by ellipsometry, UV/VIS absorption, and IR reflection and transmission. Etching rates of a-C:H subjected to O2 dicharges were determined

Ellipsometric and optical study of some uncommon insulator films on 3-5 semiconductors

Optical properties of three types of insulating films that show promise in potential applications in the 3-4 semiconductor technology were evaluated, namely a-C:H, BN and CaF2. The plasma deposited a-C:H shows an amorphous behavior with optical energy gaps of approximately 2 to 2.4 eV. These a-C:H films have higher density and/or hardness, higher refractive index and lower optical energy gaps with increasing energy of the particles in the plasma, while the density of states remains unchanged. These results are in agreement, and give a fine-tuned positive confirmation to an existing conjecture on the nature of a-C:H films (1). Ion beam deposited BN films show amorphous behavior with energy gap of 5 eV. These films are nonstoichiometric (B/N approximately 2) and have refractive index, density and/or hardness which are dependent on the deposition conditions. The epitaxially grown CaF2 on GaAs films have optical parameters equal to bulk, but evidence of damage was found in the GaAs at the interface