Low sidelobe level low-cost earth station antennas for the 12 GHz broadcasting satellite service

An experimental investigation of the performance of 1.22 m and 1.83 m diameter paraboloid antennas with an f/D ratio of 0.38 and using a feed developed by Kumar is reported. It is found that sidelobes below 30 dB can be obtained only if the paraboloids are relatively free of surface errors. A theoretical analysis of clam shell distortion shows that this is a limiting factor in achieving low sidelobe levels with many commercially available low cost paraboloids. The use of absorbing pads and small reflecting plates for sidelobe reduction is also considered

Coaxial prime focus feeds for paraboloidal reflectors

A TE11 - TM11 dual mode coaxial feed for use in prime focus paraboloidal antenna systems is investigated. The scattering matrix parameters of the internal bifurcation junction was determined by the residue calculus technique. The scattering parameters and radiation fields of the aperture were found from the Weinstein solution. The optimum modeing ratio for minimum cross-polarization was determined along with the corresponding optimum feed dimensions. A peak cross-polarization level of -58 dB is predicted. The frequency characteristics were also investigated and a bandwidth of 5% is predicted over which the cross-polarization remains below -30 dB, the input VSWR is below 1.15, and the phase error is less than 10 deg. Theoretical radiation patterns and efficiency curves for a paraboloidal reflector illuminated by this feed were computed. The predicted sidelobe level is below -30 dB and aperture efficiencies greater than 70% are possible. Experimental results are also presented that substantiates the theoretical results. In addition, experimental results for a 'short-cup' coaxial feed are given. The report includes extensive design data for the dual-mode feed along with performance curves showing cross-polarization as a function of feed parameters. The feed is useful for low-cost ground based receiving antennas for use in direct television satellite broadcasting service

Landau-Zener-St\"uckelberg Spectroscopy of a Superconducting Flux Qubit

We proposed a new method to measure the energy spectrum of a superconducting flux qubit. Different from the conventional frequency spectroscopy, a short triangle pulse is used to drive the qubit through the anticrossing and generates Landau-Zener-St\"uckelberg interference patterns, from which the information of the energy spectrum can be extracted. Without installing microwave lines one can simplify the experimental setup and reduce the unwanted effects of noise. Moreover, the method can be applied to other quantum systems, opening the possibility of calibrating and manipulating qubits with linear pulses.Comment: 7 pages, 5 figure

Self-Organized Criticality Effect on Stability: Magneto-Thermal Oscillations in a Granular YBCO Superconductor

We show that the self-organized criticality of the Bean's state in each of the grains of a granular superconductor results in magneto-thermal oscillations preceding a series of subsequent flux jumps. We find that the frequency of these oscillations is proportional to the external magnetic field sweep rate and is inversely proportional to the square root of the heat capacity. We demonstrate experimentally and theoretically the universality of this dependence that is mainly influenced by the granularity of the superconductor.Comment: submitted to Physical Review Letters, 4 pages, RevTeX, 4 figures available as uufile

Purcell effect in wire metamaterials

We study theoretically the enhancement of spontaneous emission in wire metamaterials. We analyze the dependence of the Purcell factor dependence on wire dielectric constant for both electric and magnetic dipole sources, and find an optimal value of the dielectric constant for maximizing the Purcell factor for the electric dipole. We obtain analytical expressions for the Purcell factor and also provide estimates for the Purcell factor in realistic structures operating in both microwave and optical spectral range.Comment: 15 pages, 7 figure

The puzzle of the soft X-ray excess in AGN: absorption or reflection?

The 2-10 keV continuum of AGN is generally well represented by a single power law. However, at smaller energies the continuum displays an excess with respect to the extrapolation of this power law, called the ''soft X-ray excess''. Until now this soft X-ray excess was attributed, either to reflection of the hard X-ray source by the accretion disk, or to the presence of an additional comptonizing medium, giving a steep spectrum. An alternative solution proposed by Gierlinski and Done (2004) is that a single power law well represents both the soft and the hard X-ray emission and the impression of the soft X-ray excess is due to absorption of a primary power law by a relativistic wind. We examine the advantages and drawbacks of reflection versus absorption models, and we conclude that the observed spectra can be well modeled, either by absorption (for a strong excess), or by reflection (for a weak excess). However the physical conditions required by the absorption models do not seem very realistic: we would prefer an ''hybrid model''.Comment: 4 pages, 3 figures, abstracts SF2A-2005, published by EDP-Sciences Conference Serie

A modal model for diffraction gratings

A description of an algorithm for a rather general modal grating calculation is presented. Arbitrary profiles, depth, and permittivity are allowed. Gratings built up from sub-gratings are allowed, as are coatings on the sidewalls of lines, and arbitrary complex structure. Conical angles and good conductors are supported

Coupling Impedances of Small Discontinuities: Dependence on Beam Velocity

The beam coupling impedances of small discontinuities of an accelerator vacuum chamber have been calculated [e.g., S.S. Kurennoy, R.L. Gluckstern, and G.V. Stupakov, Phys. Rev. E 52, 4354 (1995)] for ultrarelativistic beams using the Bethe diffraction theory. Here we extend the results to an arbitrary beam velocity. The vacuum chamber is assumed to have an arbitrary, but uniform along the beam path, cross section. The longitudinal and transverse coupling impedances are derived in terms of series over cross-section eigenfunctions, while the discontinuity shape enters via its polarizabilities. Simple explicit formulas for two important particular cases - circular and rectangular chamber cross sections - are presented. The impedance dependence on the beam velocity exhibits some unusual features: for example, the reactive impedance, which dominates in the ultrarelativistic limit, can vanish at a certain beam velocity, or its magnitude can exceed the ultrarelativistic value many times. In addition, we demonstrate that the same technique, the field expansion into a series of cross-section eigenfunctions, is convenient for calculating the space-charge impedance of uniform beam pipes with arbitrary cross section.Comment: REVTeX, 11 pages, 6 figures. Submitted to Phys. Rev. ST - Accel. Beam

Nanowire metamaterials with extreme optical anisotropy

We study perspectives of nanowire metamaterials for negative-refraction waveguides, high-performance polarizers, and polarization-sensitive biosensors. We demonstrate that the behavior of these composites is strongly influenced by the concentration, distribution, and geometry of the nanowires, derive an analytical description of electromagnetism in anisotropic nanowire-based metamaterials, and explore the limitations of our approach via three-dimensional numerical simulations. Finally, we illustrate the developed approach on the examples of nanowire-based high energy-density waveguides and non-magnetic negative index imaging systems with far-field resolution of one-sixth of vacuum wavelength.Comment: Updated version; accepted to Appl.Phys.Let