116 research outputs found
Tempi beati. Arrigo Frusta (1875-1965). Dagli anni della bohème di fine Ottocento e dalla stagione d’oro della Hollywood sul Po ai “Brandé”
Measuring pandemic-related anxiety and confidence in care in chronic patients using the Psychological Consequences of a Pandemic Event (PCPE) questionnaire
: The COVID-19 pandemic has determined a considerable increase in psychological distress worldwide. Compared with the general population, patients with chronic conditions experience higher stress levels due to the increased risk of worse health outcomes from COVID-19 infection. Worries and fear of contagion could cause them to avoid going to their health facilities for medical examinations, which results in higher risks of morbidity and mortality. The present study aimed to develop and validate the Psychological Consequences of a Pandemic Event (PCPE) self-report questionnaire, and to assess the psychological effects of exposure to a pandemic on mood and on treatment adherence appropriate for patients with chronic diseases. Data were analysed with Rasch analysis after an Exploratory Factor Analysis and a Confirmatory Factor Analysis. We identified a final set of 10 items, divided into two independent factors labelled "pandemic-related anxiety" and "confidence in care". Finally, we transformed the raw scores of both factors into two interval scales (two rulers) that met the requirements of the fundamental measurement. The PCPE questionnaire has demonstrated to be a short and easy-to-administer measure, with valid and reliable psychometric properties, capable of assessing pandemic-related anxiety and confidence in care in patients with chronic clinical conditions
Small atom doping: a synergistic strategy to reduce SnZn recombination center concentration in Cu2ZnSnSe4
Kesterite Cu2ZnSnS x Se4-x (CZTSSe) is among the most promising inorganic Earth-abundant thin-film photovoltaic technologies, although currently, the larger voltage deficit compared with more mature chalcogenide technologies is hampering solar-to-electricity conversion efficiency progress in these materials. Most of the latest reports agree on the CZTSSe defect structure as the main limitation for the open-circuit voltage. Small atom doping is suggested as an interesting strategy to reduce the concentration of defects without affecting secondary phase formation. Herein, an innovative approach based on the introduction of LiAlH4 and its further decomposition during the selenization process of CZTSe precursors, as a pathway for hydrogen and lithium/alkali transient doping, is explored. This process shows a strong beneficial influence on the crystal growth and solar cell device performance, especially with a significant improvement in V oc and fill factor. A reduction of nonradiative recombination and a remarkable fourfold increase in the carrier lifetime correlating with the reduction of the open-circuit voltage (V oc) deficit below 330¿mV is demonstrated. A mechanism on how small atoms (Li and H) interact to reduce the concentration of SnZn recombination centers while keeping doping relatively unchanged is proposed, opening fundamental perspectives for the simple and universal transient doping of thin-film chalcogenide compounds.Peer ReviewedPostprint (published version
Study and optimization of alternative MBE‐deposited metallic precursors for highly efficient kesterite CZTSe:Ge solar cells
n/
A new approach for alkali incorporation in Cu2ZnSnS4 solar cells
The addition of alkali elements has become mandatory for boosting solar cell performance in chalcogenide thin films based on kesterites (Cu2ZnSnS4, CZTS). A novel doping process is presented here, that consists in the incorporation of sodium or lithium during the deposition of the CdS buffer layer, followed by a post-deposition annealing (PDA). As the doping route leads to more efficient devices in comparison with the undoped reference sample, the influence of PDA temperature was also investigated. Compositional profiling techniques, time-of-flight secondary ion mass spectrometry (TOF-SIMS) and glow discharge optical mission spectroscopy (GDOES), revealed a dependence of the alkaline distribution in kesterites with the PDA temperature. Although the doping process is effective in that it increases the alkaline concentration compared to the undoped sample, the compositional profiles indicate that a significant proportion of Li and Na remains 'trapped' within the CdS layer. In the 200 °C–300 °C range the alkali profiles registered the higher concentration inside the kesterite. Despite this, an additional alkali accumulation close to the molybdenum/fluorine doped tin oxide substrate was found for all the samples, which is frequently related to alkali segregation at interfaces. The addition of both, lithium and sodium, improves the photovoltaic response compared to the undoped reference device. This is mainly explained by a substantial improvement in the open-circuit potential (Voc) of the cells, with best devices achieving efficiencies of 4.5% and 3% for lithium and sodium, respectively. Scanning-electron microscopy images depicted a 'bilayer structure' with larger grains at the top and small grains at the bottom in all samples. Moreover, the calculated bandgap energies of the CZTS films account for changes in the crystallographic order-disorder of the kesterites, more related to the PDA treatment rather than alkali incorporation. Even if further optimization of the absorber synthesis and doping process will be required, this investigation allowed the evaluation of a novel strategy for alkali incorporation in kesterite based solar cells.Peer ReviewedPostprint (published version
Over 10% efficient wide bandgap CIGSe solar cells on transparent substrate with Na predeposition treatment
With the recent rise of new photovoltaic applications, it has become necessary to develop specific optoelectronic properties for thin‐film technologies such as Cu(In,Ga)Se2 and to take advantage of their high degree of tunability. The feasibility of efficient wide bandgap absorbers on transparent conductive oxide substrates is, in that context, of critical importance. Using an original approach based on a predeposition sodium treatment, Cu(In,Ga)Se2 absorbers fabricated by sputtering and reactive annealing with a Ga to (Ga + In) content over 0.7 and an optical bandgap above 1.4 eV are deposited on transparent fluorine‐doped tin oxide films, with the insertion of an ultrathin MoSe2 layer preserving the contact's ohmicity. Different material characterizations are carried out, and a thorough Raman analysis of the absorber reveals that the sodium pretreatment significantly enhances the Ga incorporation into the chalcopyrite matrix, along with markedly improving the film's morphology and crystalline quality. This translates to a spectacular boost of the photovoltaic performance for the resulting solar cell as compared with a reference device without Na, specifically in the voltage and fill factor. Eventually, an efficiency exceeding 10% is obtained without antireflection coating, a record value bridging the gap with the state of the art on nontransparent substrates
Challenges and improvement pathways to develop quasi-1D (Sb1-xBix)2Se3-based materials for optically tuneable photovoltaic applications. Towards chalcogenide narrow-bandgap devices
Quasi-1D chalcogenides have shown great promises in the development of emerging photovoltaic technologies. However, most quasi-1D semiconductors other than Sb2Se3 and Sb2S3 have been seldom investigated for energy generation applications. Indeed, cationic or anionic alloying strategies allow changing the bandgap of these materials, opening the door to the development of an extended range of chalcogenides with tuneable optical and electrical properties. In this work, Bi incorporation into the Sb2Se3 structure has been proved as an effective approach to modulate the bandgap between 0.1. In order to better understand the underlying mechanisms leading to the formation of (Sb1-xBix)2Se3, and thus design specific strategies to enhance its properties, thin films with different annealing time and temperature have been synthesized and characterized. Interestingly, it has been observed that Sb2Se3 and Bi2Se3 are formed first, with Bi melting at 300 ¿C and diffusing rapidly towards the surface of the film. At higher temperature, the binary compounds combine to form the solid solution, however as the dwell time increases, (Sb1-xBix)2Se3 decomposes again into Bi2Se3 and Sb. This study has shown that the material is essentially limited by compositional disorder and recombination via defects. Likewise, routes have been proposed to improve morphology and uniformity of the layer, achieving efficiencies higher than 1% for x > 0.2Postprint (published version
Influence of FADS Polymorphisms on Tracking of Serum Glycerophospholipid Fatty Acid Concentrations and Percentage Composition in Children
Tracking of fatty acid (FA) contribution to plasma or serum lipids over time was shown in children and adults. However, the potential role of FADS gene variants has not been investigated.
Serum GP FA composition of 331 children aged 2 and 6 years, participating in an ongoing birth cohort study, was analyzed. Correlation coefficients were estimated to describe FA tracking over 4 years and to assess the influence of FADS variants on tracking. We found low to moderate tracking (r = 0.12-0.49) of FA compositions and concentration between 2 and 6 years. Concentration changes of total monounsaturated FA and total saturated FA over time correlated closely (r = 0.79) but percentage values were unrelated (r = -0.02). Tracking for n-6 long chain polyunsaturated fatty acid (LC-PUFA) concentrations was lower in subjects homozygous for the major allele of FADS variants and higher in carriers of at least one minor allele, whereas for total n-3 LC-PUFA concentrations and compositions this was vice versa. For individual n-3 PUFA inconsistent results were found.
Serum GP FA composition shows low to moderate tracking over 4 years with a higher tracking for LC-PUFA metabolites than for their precursor FA. Serum PUFA levels and their tracking seem to be more influenced by lipid and lipoprotein metabolism than by FA specific pathways
Influence of FADS Polymorphisms on Tracking of Serum Glycerophospholipid Fatty Acid Concentrations and Percentage Composition in Children
BACKGROUND: Tracking of fatty acid (FA) contribution to plasma or serum lipids over time was shown in children and adults. However, the potential role of FADS gene variants has not been investigated. METHODS AND PRINCIPAL FINDINGS: Serum GP FA composition of 331 children aged 2 and 6 years, participating in an ongoing birth cohort study, was analyzed. Correlation coefficients were estimated to describe FA tracking over 4 years and to assess the influence of FADS variants on tracking. We found low to moderate tracking (r = 0.12-0.49) of FA compositions and concentration between 2 and 6 years. Concentration changes of total monounsaturated FA and total saturated FA over time correlated closely (r = 0.79) but percentage values were unrelated (r = -0.02). Tracking for n-6 long chain polyunsaturated fatty acid (LC-PUFA) concentrations was lower in subjects homozygous for the major allele of FADS variants and higher in carriers of at least one minor allele, whereas for total n-3 LC-PUFA concentrations and compositions this was vice versa. For individual n-3 PUFA inconsistent results were found. CONCLUSIONS AND SIGNIFICANCE: Serum GP FA composition shows low to moderate tracking over 4 years with a higher tracking for LC-PUFA metabolites than for their precursor FA. Serum PUFA levels and their tracking seem to be more influenced by lipid and lipoprotein metabolism than by FA specific pathways
- …