220 research outputs found
Cross-correlating Carbon Monoxide Line-intensity Maps with Spectroscopic and Photometric Galaxy Surveys
Line-intensity mapping (LIM or IM) is an emerging field of observational
work, with strong potential to fit into a larger effort to probe large-scale
structure and small-scale astrophysical phenomena using multiple complementary
tracers. Taking full advantage of such complementarity means, in part,
undertaking line-intensity surveys with galaxy surveys in mind. We consider the
potential for detection of a cross-correlation signal between COMAP and blind
surveys based on photometric redshifts (as in COSMOS) or based on spectroscopic
data (as with the HETDEX survey of Lyman- emitters). We find that
obtaining accuracy in redshifts and
sources per Mpc with spectroscopic redshift determination
should enable a CO-galaxy cross spectrum detection significance at least twice
that of the CO auto spectrum. Either a future targeted spectroscopic survey or
a blind survey like HETDEX may be able to meet both of these requirements.Comment: 19 pages + appendix (31 pages total), 16 figures, 6 tables; accepted
for publication in Ap
Cryogenic 160-GHz MMIC Heterodyne Receiver Module
A cryogenic 160-GHz MMIC heterodyne receiver module has demonstrated a system noise temperature of 100 K or less at 166 GHz. This module builds upon work previously described in Development of a 150-GHz MMIC Module Prototype for Large-Scale CMB Radiation (NPO-47664), NASA Tech Briefs, Vol. 35, No. 8 (August 2011), p. 27. In the original module, the local oscillator signal was saturating the MMIC low-noise amplifiers (LNAs) with power. In order to suppress the local oscillator signal from reaching the MMIC LNAs, the W-band (75 110 GHz) signal had to be filtered out before reaching 140 170 GHz. A bandpass filter was developed to cover 120 170 GHz, using microstrip parallel-coupled lines to achieve the desired filter bandwidth, and ensure that the unwanted W-band local oscillator signal would be sufficiently suppressed. With the new bandpass filter, the entire receiver can work over the 140 180-GHz band, with a minimum system noise temperature of 460 K at 166 GHz. The module was tested cryogenically at 20 K ambient temperature, and it was found that the receiver had a noise temperature of 100 K over an 8-GHz bandwidth. The receiver module now includes a microstrip bandpass filter, which was designed to have a 3-dB bandwidth of approximately 120-170 GHz. The filter was fabricated on a 3-mil-thick alumina substrate. The filter design was based on a W-band filter design made at JPL and used in the QUIET (Q/U Imaging ExperimenT) radiometer modules. The W-band filter was scaled for a new center frequency of 150 GHz, and the microstrip segments were changed accordingly. Also, to decrease the bandwidth of the resulting scaled design, the center gaps between the microstrip lines were increased (by four micrometers in length) compared to the gaps near the edges. The use of the 150-GHz bandpass filter has enabled the receiver module to function well at room temperature. The system noise temperature was measured to be less than 600 K (at room temperature) from 154 to 168 GHz. Additionally, the use of a W-band isolator between the receiver module and the local oscillator source also improved the noise temperature substantially. This may be because the mixer was presented with a better impedance match with the use of the isolator. Cryogenic testing indicates a system noise temperature of 100 K or less at 166 GHz. Prior tests of the MMIC amplifiers alone have resulted in a system noise temperature of 65.70 K in the same frequency range (.160 GHz) when cooled to an ambient temperature of 20 K. While other detector systems may be slightly more sensitive (such as SIS mixers), they require more cooling (to 4 K ambient) and are not as easily scalable to build a large array, due to the need for large magnets and other equipment. When cooled to 20 K, this receiver module achieves approximately 100 K system noise temperature, which is slightly higher than single-amplifier module results obtained at JPL (65.70 K when an amplifier is corrected for back-end noise contributions). If this performance can be realized in practice, and a scalable array can be produced, the impact on cosmic microwave background experiments, astronomical and Earth spectroscopy, interferometry, and radio astronomy in general will be dramatic
Ultra-Low-Noise W-Band MMIC Detector Modules
A monolithic microwave integrated circuit (MMIC) receiver can be used as a building block for next-generation radio astronomy instruments that are scalable to hundreds or thousands of pixels. W-band (75-110 GHz) low-noise receivers are needed for radio astronomy interferometers and spectrometers, and can be used in missile radar and security imagers. These receivers need to be designed to be mass-producible to increase the sensitivity of the instrument. This innovation is a prototyped single-sideband MMIC receiver that has all the receiver front-end functionality in one small and planar module. The planar module is easy to assemble in volume and does not require tuning of individual receivers. This makes this design low-cost in large volumes
Recommended from our members
The QUaD Galactic Plane Survey. I. Maps and Analysis of Diffuse Emission
We present a survey of ~800 deg of the galactic plane observed with the QUaD telescope. The primary products of the survey are maps of Stokes I, Q, and U parameters at 100 and 150 GHz, with spatial resolution of 5' and 3'.5, respectively. Two regions are covered, spanning approximately 245°-295° and 315°-5° in the galactic longitude l and –4° < b < +4° in the galactic latitude b. At 0°.02 square pixel size, the median sensitivity is 74 and 107 kJy sr at 100 GHz and 150 GHz respectively in I, and 98 and 120 kJy sr for Q and U. In total intensity, we find an average spectral index of α = 2.35 ± 0.01(stat) ± 0.02(sys) for |b| ≤ 1°, indicative of emission components other than thermal dust. A comparison to published dust, synchrotron, and free-free models implies an excess of emission in the 100 GHz QUaD band, while better agreement is found at 150 GHz. A smaller excess is observed when comparing QUaD 100 GHz data to the WMAP five-year W band; in this case, the excess is likely due to the wider bandwidth of QUaD. Combining the QUaD and WMAP data, a two-component spectral fit to the inner galactic plane (|b| ≤ 1°) yields mean spectral indices of α s = –0.32 ± 0.03 and α = 2.84 ± 0.03; the former is interpreted as a combination of the spectral indices of synchrotron, free-free, and dust, while the second is largely attributed to the thermal dust continuum. In the same galactic latitude range, the polarization data show a high degree of alignment perpendicular to the expected galactic magnetic field direction, and exhibit mean polarization fraction 1.38 ± 0.08(stat) ± 0.1(sys)% at 100 GHz and 1.70 ± 0.06(stat) ± 0.1(sys)% at 150 GHz. We find agreement in polarization fraction between QUaD 100 GHz and the WMAP W band, the latter giving 1.1% ± 0.4%.Astronom
- …