345 research outputs found

    Development and validation of a one-dimensional solver in a CFD platform for boiling flows in bubbly regimes

    Get PDF
    This paper presents a new one-dimensional solver for two-phase flow simulations where boiling is involved. The solver has been implemented within the OpenFOAM® platform. The basic formulation follows the Eulerian description of the Navier–Stokes equations. Different closure equations for one-dimensional simulations are also included, as well as a subcooled boiling model in order to perform accurate computations of the mass and heat transfer between phases. In addition to the fluid, a domain is included in order to represent the solid structure, so the solver is able to solve conjugate heat transfer problems. Two different test cases are presented in this work, first a single-phase test case in order to verify the conjugate heat transfer, and then a case based on the Bartolomej international benchmark, which consists of a vertical pipe where the fluid runs upwards while it is heated. Transient calculation were performed, and the results were compared to the TRACE system code, and to the experimental data in the corresponding case. With this calculations, the capability of this new solver to simulate one-dimensional single-phase and two-phase flows including boiling is demonstrated. This work is a first step of a final objective, which consists in allowing a 1D–3D coupling within the CFD platform, avoiding external links

    Incorporación de residuos derivados de la fabricación cerámica y del vidrio reciclado en el proceso cerámico integral

    Get PDF
    The following research work shows the results of the introduction of waste generated by the ceramic industry, such as the calcined clay from fired porcelain of stoneware and raw biscuit, sludge and cleaning water, as well as waste from other sectors like the recycling glass. In this way, it can be obtained a stoneware porcelain slab, engobe-glaze and satin glaze that contains high percentage of recyclable raw material

    On the One-Dimensional Modeling of Vertical Upward Bubbly Flow

    Get PDF
    [EN] The one-dimensional two-fluid model approach has been traditionally used in thermal-hydraulics codes for the analysis of transients and accidents in water¿cooled nuclear power plants. This paper investigates the performance of RELAP5/MOD3 predicting vertical upward bubbly flow at low velocity conditions. For bubbly flow and vertical pipes, this code applies the drift- velocity approach, showing important discrepancies with the experiments compared. Then, we use a classical formulation of the drag coefficient approach to evaluate the performance of both approaches. This is based on the critical Weber criteria and includes several assumptions for the calculation of the interfacial area and bubble size that are evaluated in this work. A more accurate drag coefficient approach is proposed and implemented in RELAP5/MOD3. Instead of using the Weber criteria, the bubble size distribution is directly considered. This allows the calculation of the interfacial area directly from the definition of Sauter mean diameter of a distribution. The results show that only the proposed approach was able to predict all the flow characteristics, in particular the bubble size and interfacial area concentration. Finally, the computational results are analyzed and validated with cross-section area average measurements of void fraction, dispersed phase velocity, bubble size, and interfacial area concentration.The authors sincerely thank the Plan Nacional de I+D+i for funding the Projects MODEXFLAT ENE2013-48565-C2-1- P, ENE2013-48565-C2-2-P, and NUC-MULTPHYS ENE2012- 34585.Peña-Monferrer, C.; Gómez-Zarzuela, C.; Chiva, S.; Miró Herrero, R.; Verdú Martín, GJ.; Muñoz-Cobo, JL. (2018). On the One-Dimensional Modeling of Vertical Upward Bubbly Flow. Science and Technology of Nuclear Installations. 2018:1-10. https://doi.org/10.1155/2018/2153019S110201

    Trebouxia lynnae sp. nov. (former Trebouxia sp. TR9): biology and biogeography of an epitome lichen symbiotic microalga

    Get PDF
    Two microalgal species, Trebouxia jamesii and Trebouxia sp. TR9, were detected as the main photobionts coexisting in the thalli of the lichen Ramalina farinacea. Trebouxia sp. TR9 emerged as anew taxon in lichen symbioses and was successfully isolated and propagated in in vitro culture andthoroughly investigated. Several years of research have confirmed the taxon Trebouxia sp. TR9 tobe a model/reference organism for studying mycobiont–photobiont association patterns in lichensymbioses. Trebouxia sp. TR9 is the first symbiotic, lichen-forming microalga for which an exhaustivecharacterization of cellular ultrastructure, physiological traits, genetic and genomic diversity is available.The cellular ultrastructure was studied by light, electron and confocal microscopy; physiologicaltraits were studied as responses to different abiotic stresses. The genetic diversity was previouslyanalyzed at both the nuclear and organelle levels by using chloroplast, mitochondrial, and nucleargenome data, and a multiplicity of phylogenetic analyses were carried out to study its intraspecificdiversity at a biogeographical level and its specificity association patterns with the mycobiont.Here, Trebouxia sp. TR9 is formally described by applying an integrative taxonomic approach and ispresented to science as Trebouxia lynnae, in honor of Lynn Margulis, who was the primary modernproponent for the significance of symbiosis in evolution. The complete set of analyses that werecarried out for its characterization is provided

    Characterization of the gas-liquid interfacial waves in vertical upward co-current annular flows

    Full text link
    [EN] For more than fifty years, hundreds of research works have focused on the study of annular flow because of its huge importance in many industrial processes, for instance, chemical, petroleum, etc., being of particular interest in nuclear industry. Specifically, interfacial waves play a vital role in the mass, momentum and energy transference processes between gas and liquid phases. This paper describes the new experimental measurements of vertical upward co-current two-phase gas-liquid flow carried out in a tube with an inner diameter of 44 mm. The liquid film thickness and the major characteristics of the interfacial waves have been measured using a non-intrusive instrument, a conductance probe. The physical phenomenon in which this device is based is the change in the electrical conductivity between air and water, i.e., the electrical signal collected in the sensor receiver depends on the thickness of the liquid film layer. The experimental measurements range from 2000 to 3500 l/min for the gas volumetric flow rate, and from 4 to 10 l/min for the liquid volumetric flow rate. Correlation of the experimental measurements of liquid film thickness and the major properties of the interfacial waves have been analyzed using non-dimensional numbers. An important part of the document focuses on the comparison of the experimental data and the fitting correlations against several of the most widely used expressions. Throughout this paper, in addition to present all the available correlations, the existing scattering found when comparing against other expressions have been also confirmed, underlining the existence of gaps of knowledge even today. Emphasize that the proposed correlations are the ones that better fit the data of all experimental series carried out under the present study for the analyzed variables, with almost all the experimental points covered by the +/- 10% error bands of the new correlations.The authors are indebted to the plan of I+D support of the EXMOTRANSIN project ENE2016-79489-C2-1-P.Cuadros-Orón, JL.; Rivera-Durán, Y.; Berna, C.; Escrivá, A.; Muñoz-Cobo, JL.; Monrós-Andreu, G.; Chiva, S. (2019). Characterization of the gas-liquid interfacial waves in vertical upward co-current annular flows. Nuclear Engineering and Design. 346:112-130. https://doi.org/10.1016/j.nucengdes.2019.03.008S11213034

    MATH APPS UTILIZATION: ITS PERCEIVED EFFECTS TO THE ACADEMIC PERFORMANCE OF MATHEMATICS MAJOR STUDENTS

    Get PDF
    This study aimed to determine the perceived effects of apps utilization to study habits and academic performance. Further, it also sought to determine the views of the participants and respondents on their engagement in math apps and their relationship with study habits and academic performance. This study made use of explanatory-sequential design. The purposive sampling design was used to determine the respondents in quantitative data while the quota sampling design was also used to determine the participants in qualitative data. The study revealed that the mathematical application that is mostly used by the students is the calculator app as it garnered the highest percentage value of 80.85.%. The participants agreed that math applications serve as an aid for math problems, aid for lack of teaching by the teacher, promote learning of specific lessons and increase, and help in improving their academic performance. Respondents’ perception of their utilization of math apps is due to technical problems. The respondents also agreed that math application also affected their study habits in which they become dependent on it which led to laziness and tiredness. In addition, this study also found that there is a significant relationship between respondents’ utilization of math applications and their study habits. Lastly, there is also a significant relationship between the study habits and academic performance of selected math students of Notre Dame of Midsayap College.  Article visualizations

    Perception of Nuclear Energy and Coal in France and the Netherlands

    Get PDF
    This study focuses on the perception of large scale application of nuclear energy and coal in the Netherlands and France. The application of these energy-sources and the risks and benefits are judged differently by various group in society. In Europe, France has the highest density of nuclear power plants and the Netherlands has one of the lowest. In both countries scientists and social scientists completed a questionnaire assessing the perception of the large scale application of both energy sources. Furthermore, a number of variables relating to the socio cultural and political circumstances were measured. The results indicate that the French had a higher risk perception and a more negative attitude toward nuclear power than the Dutch. But they also assess the benefits of the use of nuclear power to be higher. Explanations for these differences are discussed

    Multifunctional silver-coated transparent TiO2 thin films for photocatalytic and antimicrobial applications

    Get PDF
    Transparent TiO2 thin films coated with Ag NPs were synthesized using two industrially applicable techniques, pulsed laser ablation (PLAL) and spray pyrolysis without using high vacuum. These transparent thin films were deposited on glass in order to generate glass materials with photocatalytic and antimicrobial properties and a minimum loss of transparency. The structural, morphological and optical properties of the thin films were examined using Grazing incidence X-ray diffraction (GIXRD), Raman spectroscopy, Scanning electron microscopy (SEM) and ultraviolet–visible spectroscopy. Transmission electron microscopy (TEM) was used to identify the NPs on the TiO2 surface. The transmittance value for the thin films was greater than 80%.The thin films thus synthesized were then assessed to determine their photocatalytic capacity by monitoring the degradation of Rhodamine B (RhB) under UV light irradiation. Ag NPs on the TiO2 surface ensures an improvement in the photocatalytic properties, with a 99% degradation of RhB in 210 min under UV light. In addition, these transparent thin films showed high antimicrobial activity on Gram-negative bacteria when irradiated by UV light for 4 h, killing 93% of these bacteria.Funding for open access charge: CRUE-Universitat Jaume

    Higher socioeconomic status is related to healthier levels of fatness and fitness already at 3 to 5 years of age: The PREFIT project: Relation between socioeconomic status, fatness and fitness in preschoolers

    Get PDF
    This study aimed to analyse the association between socioeconomic status (SES) and fatness and fitness in preschoolers. 2, 638 preschoolers (3–5 years old; 47.2% girls) participated. SES was estimated from the parental educational and occupational levels, and the marital status. Fatness was assessed by body mass index (BMI), waist circumference (WC), and waist-to-height ratio (WHtR). Physical fitness components were assessed using the PREFIT battery. Preschoolers whose parents had higher educational levels had lower fatness (P < 0.05). BMI significantly differed across occupational levels of each parent (P < 0.05) and WHtR across paternal levels (P = 0.004). Musculoskeletal fitness was different across any SES factor (P < 0.05), except handgrip across paternal occupational levels (P = 0.05). Preschoolers with high paternal occupation had higher speed/agility (P = 0.005), and those with high or low maternal education had higher VO2max (P = 0.046). Odds of being obese and having low musculoskeletal fitness was lower as SES was higher (P < 0.05). Those with married parents had higher cardiorespiratory fitness than single-parent ones (P = 0.010). School-based interventions should be aware of that children with low SES are at a higher risk of obesity and low fitness already in the first years of life
    corecore