A global assessment of the impact of climate change on water scarcity

This paper presents a global scale assessment of the impact of climate change on water scarcity. Patterns of climate change from 21 Global Climate Models (GCMs) under four SRES scenarios are applied to a global hydrological model to estimate water resources across 1339 watersheds. The Water Crowding Index (WCI) and the Water Stress Index (WSI) are used to calculate exposure to increases and decreases in global water scarcity due to climate change. 1.6 (WCI) and 2.4 (WSI) billion people are estimated to be currently living within watersheds exposed to water scarcity. Using the WCI, by 2050 under the A1B scenario, 0.5 to 3.1 billion people are exposed to an increase in water scarcity due to climate change (range across 21 GCMs). This represents a higher upper-estimate than previous assessments because scenarios are constructed from a wider range of GCMs. A substantial proportion of the uncertainty in the global-scale effect of climate change on water scarcity is due to uncertainty in the estimates for South Asia and East Asia. Sensitivity to the WCI and WSI thresholds that define water scarcity can be comparable to the sensitivity to climate change pattern. More of the world will see an increase in exposure to water scarcity than a decrease due to climate change but this is not consistent across all climate change patterns. Additionally, investigation of the effects of a set of prescribed global mean temperature change scenarios show rapid increases in water scarcity due to climate change across many regions of the globe, up to 2°C, followed by stabilisation to 4°C

Estimating ecosystem maximum light use efficiency based on the water use efficiency principle

Light use efficiency (LUE) defines the vegetation efficiency of converting radiative energy into biochemical energy through photosynthesis. Estimating the maximum LUE (ϵ max) is critical yet challenging for quantifying gross primary production (GPP) using LUE-based models. This study describes an analytical method for estimating ϵ max based on water use efficiency (WUE) as determined by plant water use and carbon gain. Unlike other complex parameterization schemes, this WUE-based method is simple and requires four variables relatively easy to acquire. The WUE-based ϵ max estimates compare favorably well with values based on traditional curve fitting method and that reported in the literature, and clearly distinguished ϵ max between C3 (1.48 0.33 {g C M}}{J}}{ - 1}) and C4 (2.63 0.21 {g C M}}{J}}{-1}}) dominated ecosystems. The range in ϵ max estimates was narrow across different years and sites within a biome. The WUE-based ϵ max estimate is theoretically constrained by vegetation water use and can be directly incorporated into LUE models for GPP estimation across ecosystems

Theory of continuum percolation III. Low density expansion

We use a previously introduced mapping between the continuum percolation model and the Potts fluid (a system of interacting s-states spins which are free to move in the continuum) to derive the low density expansion of the pair connectedness and the mean cluster size. We prove that given an adequate identification of functions, the result is equivalent to the density expansion derived from a completely different point of view by Coniglio et al. [J. Phys A 10, 1123 (1977)] to describe physical clustering in a gas. We then apply our expansion to a system of hypercubes with a hard core interaction. The calculated critical density is within approximately 5% of the results of simulations, and is thus much more precise than previous theoretical results which were based on integral equations. We suggest that this is because integral equations smooth out overly the partition function (i.e., they describe predominantly its analytical part), while our method targets instead the part which describes the phase transition (i.e., the singular part).Comment: 42 pages, Revtex, includes 5 EncapsulatedPostscript figures, submitted to Phys Rev

A robust Gauss-Newton algorithm for the optimization of hydrological models: benchmarking against industry-standard algorithms

Optimization of model parameters is a ubiquitous task in hydrological and environmental modeling. Currently, the environmental modeling community tends to favor evolutionary techniques over classical Newton‐type methods, in the light of the geometrically problematic features of objective functions, such as multiple optima and general nonsmoothness. The companion paper (Qin et al., 2018, https://doi.org/10.1029/2017WR022488) introduced the robust Gauss‐Newton (RGN) algorithm, an enhanced version of the standard Gauss‐Newton algorithm that employs several heuristics to enhance its explorative abilities and perform robustly even for problematic objective functions. This paper focuses on benchmarking the RGN algorithm against three optimization algorithms generally accepted as “best practice” in the hydrological community, namely, the Levenberg‐Marquardt algorithm, the shuffled complex evolution (SCE) search (with 2 and 10 complexes), and the dynamically dimensioned search (DDS). The empirical case studies include four conceptual hydrological models and three catchments. Empirical results indicate that, on average, RGN is 2–3 times more efficient than SCE (2 complexes) by achieving comparable robustness at a lower cost, 7–9 times more efficient than SCE (10 complexes) by trading off some speed to more than compensate for a somewhat lower robustness, 5–7 times more efficient than Levenberg‐Marquardt by achieving higher robustness at a moderate additional cost, and 12–26 times more efficient than DDS in terms of robustness‐per‐fixed‐cost. A detailed analysis of performance in terms of reliability and cost is provided. Overall, the RGN algorithm is an attractive option for the calibration of hydrological models, and we recommend further investigation of its benefits for broader types of optimization problems.Youwei Qin, Dmitri Kavetski, George Kuczer

Analysis of equations of state for polymers

AbstractIn the literature there are several studies comparing the accuracy of various models in describing the PvT behavior of polymers. However, most of these studies do not provide information about the quality of the estimated parameters or the sensitivity of the prediction of thermodynamic properties to the parameters of the equations. Furthermore, there are few studies exploring the prediction of thermal expansion and compression coefficients. Based on these observations, the objective of this study is to deepen the analysis of Tait, HH (Hartmann-Haque), MCM (modified cell model) and SHT (simplified hole theory) equations of state in predicting the PvT behavior of polymers, for both molten and solid states. The results showed that all equations of state provide an adequate description of the PvT behavior in the molten state, with low standard deviations in the estimation of parameters, adequate sensitivity of their parameters and plausible prediction of specific volume, thermal expansion and isothermal compression coefficients. In the solid state the Tait equation exhibited similar performance to the molten state, while HH showed satisfactory results for amorphous polymers and difficulty in adjusting the PvT curve for semicrystalline polymers.</p

Test of the Kolmogorov-Johnson-Mehl-Avrami picture of metastable decay in a model with microscopic dynamics

The Kolmogorov-Johnson-Mehl-Avrami (KJMA) theory for the time evolution of the order parameter in systems undergoing first-order phase transformations has been extended by Sekimoto to the level of two-point correlation functions. Here, this extended KJMA theory is applied to a kinetic Ising lattice-gas model, in which the elementary kinetic processes act on microscopic length and time scales. The theoretical framework is used to analyze data from extensive Monte Carlo simulations. The theory is inherently a mesoscopic continuum picture, and in principle it requires a large separation between the microscopic scales and the mesoscopic scales characteristic of the evolving two-phase structure. Nevertheless, we find excellent quantitative agreement with the simulations in a large parameter regime, extending remarkably far towards strong fields (large supersaturations) and correspondingly small nucleation barriers. The original KJMA theory permits direct measurement of the order parameter in the metastable phase, and using the extension to correlation functions one can also perform separate measurements of the nucleation rate and the average velocity of the convoluted interface between the metastable and stable phase regions. The values obtained for all three quantities are verified by other theoretical and computational methods. As these quantities are often difficult to measure directly during a process of phase transformation, data analysis using the extended KJMA theory may provide a useful experimental alternative.Comment: RevTex, 21 pages including 14 ps figures. Submitted to Phys. Rev. B. One misprint corrected in Eq.(C1

Digenic inheritance involving a muscle-specific protein kinase and the giant titin protein causes a skeletal muscle myopathy

\ua9 The Author(s) 2024.In digenic inheritance, pathogenic variants in two genes must be inherited together to cause disease. Only very few examples of digenic inheritance have been described in the neuromuscular disease field. Here we show that predicted deleterious variants in SRPK3, encoding the X-linked serine/argenine protein kinase 3, lead to a progressive early onset skeletal muscle myopathy only when in combination with heterozygous variants in the TTN gene. The co-occurrence of predicted deleterious SRPK3/TTN variants was not seen among 76,702 healthy male individuals, and statistical modeling strongly supported digenic inheritance as the best-fitting model. Furthermore, double-mutant zebrafish (srpk3−/−; ttn.1+/−) replicated the myopathic phenotype and showed myofibrillar disorganization. Transcriptome data suggest that the interaction of srpk3 and ttn.1 in zebrafish occurs at a post-transcriptional level. We propose that digenic inheritance of deleterious changes impacting both the protein kinase SRPK3 and the giant muscle protein titin causes a skeletal myopathy and might serve as a model for other genetic diseases

Digenic inheritance involving a muscle-specific protein kinase and the giant titin protein causes a skeletal muscle myopathy.

In digenic inheritance, pathogenic variants in two genes must be inherited together to cause disease. Only very few examples of digenic inheritance have been described in the neuromuscular disease field. Here we show that predicted deleterious variants in SRPK3, encoding the X-linked serine/argenine protein kinase 3, lead to a progressive early onset skeletal muscle myopathy only when in combination with heterozygous variants in the TTN gene. The co-occurrence of predicted deleterious SRPK3/TTN variants was not seen among 76,702 healthy male individuals, and statistical modeling strongly supported digenic inheritance as the best-fitting model. Furthermore, double-mutant zebrafish (srpk3-/-; ttn.1+/-) replicated the myopathic phenotype and showed myofibrillar disorganization. Transcriptome data suggest that the interaction of srpk3 and ttn.1 in zebrafish occurs at a post-transcriptional level. We propose that digenic inheritance of deleterious changes impacting both the protein kinase SRPK3 and the giant muscle protein titin causes a skeletal myopathy and might serve as a model for other genetic diseases

Structure-property correlations in model composite materials

We investigate the effective properties (conductivity, diffusivity and elastic moduli) of model random composite media derived from Gaussian random fields and overlapping hollow spheres. The morphologies generated in the models exhibit low percolation thresholds and give a realistic representation of the complex microstructure observed in many classes of composites. The statistical correlation functions of the models are derived and used to evaluate rigorous bounds on each property. Simulation of the effective conductivity is used to demonstrate the applicability of the bounds. The key morphological features which effect composite properties are discussed