759 research outputs found
An Asymmetric Cone Model for Halo Coronal Mass Ejections
Due to projection effects, coronagraphic observations cannot uniquely
determine parameters relevant to the geoeffectiveness of CMEs, such as the true
propagation speed, width, or source location. The Cone Model for Coronal Mass
Ejections (CMEs) has been studied in this respect and it could be used to
obtain these parameters. There are evidences that some CMEs initiate from a
flux-rope topology. It seems that these CMEs should be elongated along the
flux-rope axis and the cross section of the cone base should be rather
elliptical than circular. In the present paper we applied an asymmetric cone
model to get the real space parameters of frontsided halo CMEs (HCMEs) recorded
by SOHO/LASCO coronagraphs in 2002. The cone model parameters are generated
through a fitting procedure to the projected speeds measured at different
position angles on the plane of the sky. We consider models with the apex of
the cone located at the center and surface of the Sun. The results are compared
to the standard symmetric cone model
Current distribution and giant magnetoimpedance in composite wires with helical magnetic anisotropy
The giant magnetoimpedance effect in composite wires consising of a
non-magnetic inner core and soft magnetic shell is studied theoretically. It is
assumed that the magnetic shell has a helical anisotropy. The current and field
distributions in the composite wire are found by means of a simultaneous
solution of Maxwell equations and the Landau-Lifshitz equation. The expressions
for the diagonal and off-diagonal impedance are obtained for low and high
frequencies. The dependences of the impedance on the anisotropy axis angle and
the shell thickness are analyzed. Maximum field sensitivity is shown to
correspond to the case of the circular anisotropy in the magnetic shell. It is
demonstrated that the optimum shell thickness to obtain maximum impedance ratio
is equal to the effective skin depth in the mahnetic material.Comment: 23 pages, 7 figure
Prediction Space Weather Using an Asymmetric Cone Model for Halo CMEs
Halo coronal mass ejections (HCMEs) are responsible of the most severe
geomagnetic storms. A prediction of their geoeffectiveness and travel time to
Earth's vicinity is crucial to forecast space weather.
Unfortunately coronagraphic observations are subjected to projection effects
and do not provide true characteristics of CMEs. Recently, Michalek (2006, {\it
Solar Phys.}, {\bf237}, 101) developed an asymmetric cone model to obtain the
space speed, width and source location of HCMEs. We applied this technique to
obtain the parameters of all front-sided HCMEs observed by the SOHO/LASCO
experiment during a period from the beginning of 2001 until the end of 2002
(solar cycle 23). These parameters were applied for the space weather forecast.
Our study determined that the space speeds are strongly correlated with the
travel times of HCMEs within Earth's vicinity and with the magnitudes related
to geomagnetic disturbances
Comparison of Soil Respiration in Typical Conventional and New Alternative Cereal Cropping Systems on the North China Plain
We monitored soil respiration (Rs), soil temperature (T) and volumetric water content (VWC%) over four years in one typical conventional and four alternative cropping systems to understand Rs in different cropping systems with their respective management practices and environmental conditions. The control was conventional double-cropping system (winter wheat and summer maize in one year - Con. W/M). Four alternative cropping systems were designed with optimum water and N management, i.e. optimized winter wheat and summer maize (Opt. W/M), three harvests every two years (first year, winter wheat and summer maize or soybean; second year, fallow then spring maize - W/M-M and W/S-M), and single spring maize per year (M). Our results show that Rs responded mainly to the seasonal variation in T but was also greatly affected by straw return, root growth and soil moisture changes under different cropping systems. The mean seasonal CO2 emissions in Con. W/M were 16.8 and 15.1 Mg CO2 ha(-1) for summer maize and winter wheat, respectively, without straw return. They increased significantly by 26 and 35% in Opt. W/M, respectively, with straw return. Under the new alternative cropping systems with straw return, W/M-M showed similar Rs to Opt. W/M, but total CO2 emissions of W/S-M decreased sharply relative to Opt. W/M when soybean was planted to replace summer maize. Total CO2 emissions expressed as the complete rotation cycles of W/S-M, Con. W/M and M treatments were not significantly different. Seasonal CO2 emissions were significantly correlated with the sum of carbon inputs of straw return from the previous season and the aboveground biomass in the current season, which explained 60% of seasonal CO2 emissions. T and VWC% explained up to 65% of Rs using the exponential-power and double exponential models, and the impacts of tillage and straw return must therefore be considered for accurate modeling of Rs in this geographical region
Basis Functions for Linear-Scaling First-Principles Calculations
In the framework of a recently reported linear-scaling method for
density-functional-pseudopotential calculations, we investigate the use of
localized basis functions for such work. We propose a basis set in which each
local orbital is represented in terms of an array of `blip functions'' on the
points of a grid. We analyze the relation between blip-function basis sets and
the plane-wave basis used in standard pseudopotential methods, derive criteria
for the approximate equivalence of the two, and describe practical tests of
these criteria. Techniques are presented for using blip-function basis sets in
linear-scaling calculations, and numerical tests of these techniques are
reported for Si crystal using both local and non-local pseudopotentials. We
find rapid convergence of the total energy to the values given by standard
plane-wave calculations as the radius of the linear-scaling localized orbitals
is increased.Comment: revtex file, with two encapsulated postscript figures, uses epsf.sty,
submitted to Phys. Rev.
The CDF dijet excess from intrinsic quarks
The CDF collaboration reported an excess in the production of two jets in
association with a . We discuss constraints on possible new particle state
interpretations of this excess. The fact of no statistically significant
deviation from the SM expectation for {+dijet} events in CDF data disfavors
the new particle explanation. We show that the nucleon intrinsic strange quarks
provide an important contribution to the boson production in association
with a single top quark production. Such {+t} single top quark production
can contribute to the CDF {+dijet} excess, thus the nucleon intrinsic quarks
can provide a possible explanation to the CDF excess in {+dijet} but not in
{+dijet} events.Comment: 4 latex pages, 1 figure. Version for journal publicatio
- …