7,451 research outputs found
Pressure and velocity measurements in a three-dimensional wall jet
The effects on the flow fields of varying the ratio of the velocity at the exit plane of the nozzle to the outer tunnel flow are reported. The pressure-velocity correlations are taken and some trends are discussed. Emphasis is placed on comparing the coherence between the fluctuating pressure and velocity fields at various locations in the different flow configurations
An experimental investigation of an axisymmetric jet in a coflowing airstream
The flow development of an axisymmetric jet exhausting into a moving airstream has been studied. The jet has a Reynolds number of 22,600, and the ratio of the jet velocity to the wind tunnel velocity is 5.1 to 1. The flow field of the axisymmetric jet was examined at locations varying from approximately zero to eight diameters downstream of the orifice. Of primary concern at each downstream location was the mapping of the one point statistical properties of the flow, including mean velocity, turbulent intensity, and intermittency. Autocorrelations and power spectral density curves were determined for both the fluctuating velocity field and the concentration signal at various distances from the jet's center line for different downstream locations. A laser Doppler velocimeter, using a phase locked loop processor, was used to make the desired velocity field measurements which were compared with hot wire anemometer and pressure probe data
Investigations of scaling laws for jet impingement
The statistical properties of tangential flows over surfaces were investigated by two techniques. In one, a laser-Doppler velocimeter was used in a smoke-laden jet to measure one-point statistical properties, including mean velocities, turbulent intensities, intermittencies, autocorrelations, and power spectral densities. In the other technique, free stream and surface pressure probes connected to 1/8 inch microphones were used to obtain single point rms and 1/3 octave pressures, as well as two point cross correlations, the latter being converted to auto spectra, amplitude ratios, phase lags, and coherences. The results of these studies support the vortex model of jets, give some insights into the effects of surface impingement, and confirm that jet diameter and velocity are the scaling parameters for circular jets, while Reynolds number is relatively unimportant
Low radiation dose in computed tomography: the role of iodine
Recent approaches to reducing radiation exposure during CT examinations typically utilize automated dose modulation strategies on the basis of lower tube voltage combined with iterative reconstruction and other dose-saving techniques. Less clearly appreciated is the potentially substantial role that iodinated contrast media (CM) can play in low-radiation-dose CT examinations. Herein we discuss the role of iodinated CM in low-radiation-dose examinations and describe approaches for the optimization of CM administration protocols to further reduce radiation dose and/or CM dose while maintaining image quality for accurate diagnosis. Similar to the higher iodine attenuation obtained at low-tube-voltage settings, high-iodine-signal protocols may permit radiation dose reduction by permitting a lowering of mAs while maintaining the signal-to-noise ratio. This is particularly feasible in first pass examinations where high iodine signal can be achieved by injecting iodine more rapidly. The combination of low kV and IR can also be used to reduce the iodine dose. Here, in optimum contrast injection protocols, the volume of CM administered rather than the iodine concentration should be reduced, since with high-iodine-concentration CM further reductions of iodine dose are achievable for modern first pass examinations. Moreover, higher concentrations of CM more readily allow reductions of both flow rate and volume, thereby improving the tolerability of contrast administration
Recommended from our members
Welcome to Guyland: Experiences of Trans* Men in College
Trans* identified men have emerged as a growing college and university population in higher education who have not as yet received specific research attention. I studied the experiences of trans* men in higher education and focused on their descriptions of gender identity and the advice they would offer to trans* men (or potential) trans* men about navigating college. With my focus on gender identity I hope to understand the experiences of those men who had, at one time, self-identified or been identified by others as a woman and/or female and who currently identity as man, male, masculine, or trans man. My data came from intensive interviews with 25 trans men who were, at the time of interviews, enrolled in colleges or universities in New England
Optical spectroscopy and the nature of the insulating state of rare-earth nickelates
Using a combination of spectroscopic ellipsometry and DC transport
measurements, we determine the temperature dependence of the optical
conductivity of NdNiO and SmNiO films. The optical spectra show the
appearance of a characteristic two-peak structure in the near-infrared when the
material passes from the metal to the insulator phase. Dynamical mean-field
theory calculations confirm this two-peak structure, and allow to identify
these spectral changes and the associated changes in the electronic structure.
We demonstrate that the insulating phase in these compounds and the associated
characteristic two-peak structure are due to the combined effect of
bond-disproportionation and Mott physics associated with half of the
disproportionated sites. We also provide insights into the structure of excited
states above the gap.Comment: 12 pages, 13 figure
Lumped element kinetic inductance detectors maturity for space-borne instruments in the range between 80 and 180 GHz
This work intends to give the state-of-the-art of our knowledge of the
performance of LEKIDs at millimetre wavelengths (from 80 to 180~GHz). We
evaluate their optical sensitivity under typical background conditions and
their interaction with ionising particles. Two LEKID arrays, originally
designed for ground-based applications and composed of a few hundred pixels
each, operate at a central frequency of 100, and 150~GHz (
about 0.3). Their sensitivities have been characterised in the laboratory using
a dedicated closed-circle 100~mK dilution cryostat and a sky simulator,
allowing for the reproduction of realistic, space-like observation conditions.
The impact of cosmic rays has been evaluated by exposing the LEKID arrays to
alpha particles (Am) and X sources (Cd) with a readout sampling
frequency similar to the ones used for Planck HFI (about 200~Hz), and also with
a high resolution sampling level (up to 2~MHz) in order to better characterise
and interpret the observed glitches. In parallel, we have developed an
analytical model to rescale the results to what would be observed by such a
LEKID array at the second Lagrangian point.Comment: 7 pages, 2 tables, 13 figure
Beyond and beneath the hierarchical market economy: global production and working-class conflict in Argentina's automobile industry
This paper argues that the hierarchical market economy (HME) category does not provide an adequate starting point for addressing capitalist diversity in Latin America. Building from a critical perspective on the global commodity chain (GCC) and global production network (GPN) approaches, it instead considers the impact of firms’ transnational relations and the often neglected role of working-class struggles. It will argue that capitalist diversity can only be understood at the nexus of these ostensibly global and local phenomena; and by specifying the strategic decisions taken by firms in Argentina’s automobile industry, it will account for the failure of that sector. Finally, it examines the role of working-class struggles in the industry in Córdoba, Argentina, arguing that these were vital in shaping the specific and unstable form of capitalist diversity in Argentina, as well as potential alternatives to it
Uniform non-stoichiometric titanium nitride thin films for improved kinetic inductance detector array
We describe the fabrication of homogeneous sub-stoichiometric titanium
nitride films for microwave kinetic inductance detector (mKID) arrays. Using a
6 inch sputtering target and a homogeneous nitrogen inlet, the variation of the
critical temperature over a 2 inch wafer was reduced to <25 %. Measurements of
a 132-pixel mKID array from these films reveal a sensitivity of 16 kHz/pW in
the 100 GHz band, comparable to the best aluminium mKIDs. We measured a noise
equivalent power of NEP = 3.6e-15 W/Hz^(1/2). Finally, we describe possible
routes to further improve the performance of these TiN mKID arrays.Comment: 7 pages, 4 figures, submitted to Journal of low temperature physics,
Proceedings of LTD-1
- …