Fracture liaison programs

In view of the high imminent risk of having subsequent fractures after a fracture, early evaluation and treatment decisions to prevent subsequent fractures are advocated. After a hip fracture, the fracture liaison service (FLS) and orthogeriatric care are considered the most appropriate organisational approaches for secondary fracture prevention following a recent fracture.Their introduction and implementation have been shown to increase evaluation and treatment of patients at high risk for subsequent fracture. Of real-world cohort studies, most, but not all studies, indicate a lower incidence of fracture and longer survival after treatment with nitrogen-containing bisphosphonates. (C) 2019 Elsevier Ltd. All rights reserved.</p

Quantification of human bone microarchitecture damage in press-fit femoral knee implantation using HR-pQCT and digital volume correlation

Item does not contain fulltex

Quantification of 3D microstructural parameters of trabecular bone is affected by the analysis software

Over the last decades, the use of high-resolution imaging systems to assess bone microstructural parameters has grown immensely. Yet, no standard defining the quantification of these parameters exists. It has been reported that different voxel size and/or segmentation techniques lead to different results. However, the effect of the evaluation software has not been investigated so far. Therefore, the aim of this study was to compare the bone microstructural parameters obtained with two commonly used commercial software packages, namely IPL (Scanco, Switzerland) and CTan (Bruker, Belgium). We hypothesized that even when starting from the same segmented scans, different software packages will report different results. Nineteen trapezia and nineteen distal radii were scanned at two resolutions (20 mu m voxel size with microCT and HR-pQCT 60 mu m). The scans were segmented using the scanners' default protocol. The segmented images were analyzed twice, once with IPL and once with CTan, to quantify bone volume fraction (BV/TV), trabecular thickness (Tb.Th), trabecular separation (Tb.Sp), trabecular number (Tb.N) and specific bone surface (BS/BV). Only small differences between IPL and CTan were found for BV/TV. For Tb.Th, Tb.Sp and BS/BV high correlations (R-2 >= 0.99) were observed between the two software packages, but important relative offsets were observed. For microCT scans, the offsets were relative constant, e.g., around 15% for Tb.Th. However, for the HR-pQCT scans the mean relative offsets ranged over the different bone samples (e.g., for Tb.Th from 14.5% to 19.8%). For Tb.N, poor correlations (0.43 We conclude that trabecular bone microstructural parameters obtained with IPL and CTan cannot be directly compared except for BV/TV. For Tb.Th, Tb.Sp and BS/BV, correction factors can be determined, but these depend on both the image voxel size and specific anatomic location. The two software packages did not produce consistent data on Tb.N. The development of a universal standard seems desirable

High-Resolution Cone-Beam Computed Tomography is a Fast and Promising Technique to Quantify Bone Microstructure and Mechanics of the Distal Radius

Obtaining high-resolution scans of bones and joints for clinical applications is challenging. HR-pQCT is considered the best technology to acquire high-resolution images of the peripheral skeleton in vivo, but a breakthrough for widespread clinical applications is still lacking. Recently, we showed on trapezia that CBCT is a promising alternative providing a larger FOV at a shorter scanning time. The goals of this study were to evaluate the accuracy of CBCT in quantifying trabecular bone microstructural and predicted mechanical parameters of the distal radius, the most often investigated skeletal site with HR-pQCT, and to compare it with HR-pQCT. Nineteen radii were scanned with four scanners: (1) HR-pQCT (XtremeCT, Scanco Medical AG, @ (voxel size) 82 mu m), (2) HR-pQCT (XtremeCT-II, Scanco, @60.7 mu m), (3) CBCT (NewTom 5G, Cefla, @75 mu m) reconstructed and segmented using in-house developed software and (4) microCT (VivaCT40, Scanco, @19 mu m-gold standard). The following parameters were evaluated: predicted stiffness, strength, bone volume fraction (BV/TV) and trabecular thickness (Tb.Th), separation (Tb.Sp) and number (Tb.N). The overall accuracy of CBCT with in-house optimized algorithms in quantifying bone microstructural parameters was comparable (R-2 = 0.79) to XtremeCT (R-2 = 0.76) and slightly worse than XtremeCT-II (R-2 = 0.86) which were both processed with the standard manufacturer's technique. CBCT had higher accuracy for BV/TV and Tb.Th but lower for Tb.Sp and Tb.N compared to XtremeCT. Regarding the mechanical parameters, all scanners had high accuracy (R-2 >= 0.96). While HR-pQCT is optimized for research, the fast scanning time and good accuracy renders CBCT a promising technique for high-resolution clinical scanning

BMD-based assessment of local porosity in human femoral cortical bone

Cortical pores are determinants of the elastic properties and of the ultimate strength of bone tissue. An increase of the overall cortical porosity (Ct.Po) as well as the local coalescence of large pores cause an impairment of the mechanical competence of bone Therefore, Ct Po represents a relevant target for identifying patients with high fracture risk. However, given their small size, the in vivo imaging of cortical pores remains challenging. The advent of modern high-resolution peripheral quantitative computed tomography (HR-pQCT) triggered new methods for the clinical assessment of Ct Po at the peripheral skeleton, either by pore segmentation or by exploiting local bone mineral density (BMD) In this work, we compared BMD-based Ct.Po estimates with highresolution reference values measured by scanning acoustic microscopy. A calibration rule to estimate local Ct.Po from BMD as assessed by HR-pQCT was derived experimentally. Within areas of interest smaller than 0.5 mm(2), our model was able to estimate the local Ct.Po with an error of 3.4%. The incorporation of the BMD mhomogeneity and of one parameter from the BMD distribution of the entire scan volume led to a relative reduction of the estimate error of 30%, if compared to an estimate based on the average BMD. When applied to the assessment of Ct.Po within entire cortical bone cross-sections, the proposed BMD-based method had better accuracy than measurements performed with a conventional threshold-based approach.</p

Integrated nutritional intervention in the elderly after hip fracture. A process evaluation

SummaryBackground & aimsWithin a multicentre randomized controlled trial aimed at improving the nutritional status and increase the speed of recovery of elderly hip fracture patients, we performed a process evaluation to investigate the feasibility of the intervention within the present Dutch health care system.MethodsPatients in the intervention group received nutritional counseling during 10 contacts. Oral nutritional supplements were advised as needed until three months after hip fracture surgery. The intervention was evaluated with respect to dieticians’ adherence to the study protocol, content of nutritional counseling, and patients’ adherence to recommendations given.ResultsWe included 66 patients (mean age of 76, range 55–92 years); 74% women. Eighty-three percent of patients received all 10 contacts as planned, but in 62% of the patients one or more telephone calls had to be replaced by face to face contacts. Nutritional counseling was complete in 91% of contacts. Oral nutritional supplementation was needed for a median period of 76 days; 75% of the patients took the oral nutritional supplements as recommended.ConclusionsNutritional counseling in elderly hip fracture patients through face to face contacts and telephone calls is feasible. However, individual tailoring of the intervention is recommended. The majority of hip fracture patients needed >2 months oral nutritional supplements to meet their nutritional requirements.The trial was registered at clincialtrails.gov as NCT00523575

Correction: Large cortical bone pores in the tibia are associated with proximal femur strength

[This corrects the article DOI: 10.1371/journal.pone.0215405.

Imminent fall risk after fracture

Rationale: Adults with a recent fracture have a high imminent risk of a subsequent fracture. We hypothesise that, like subsequent fracture risk, fall risk is also highest immediately after a fracture. This study aims to assess if fall risk is time-dependent in subjects with a recent fracture compared to subjects without a fracture. Methods: This retrospective matched cohort study used data from the UK Clinical Practice Research Datalink GOLD. All subjects ≥50 years with a fracture between 1993 and 2015 were identified and matched one-to-one to fracture-free controls based on year of birth, sex and practice. The cumulative incidence and relative risk (RR) of a first fall was calculated at various time intervals, with mortality as competing risk. Subsequently, analyses were stratified according to age, sex and type of index fracture. Results: A total of 624,460 subjects were included; 312,230 subjects with an index fracture, matched to 312,230 fracture-free controls (71% females, mean age 70 ± 12, mean follow-up 6.5 ± 5 years). The RR of falls was highest in the first year after fracture compared to fracture-free controls; males had a 3-fold and females a 2-fold higher risk. This imminent fall risk was present in all age and fracture types and declined over time. A concurrent imminent fracture and mortality risk were confirmed. Conclusion/Discussion: This study demonstrates an imminent fall risk in the first years after a fracture in all age and fracture types. This underlines the need for early fall risk assessment and prevention strategies in 50+ adults with a recent fracture

Efficacy and cost-effectiveness of nutritional intervention in elderly after hip fracture: design of a randomized controlled trial

Background: Hip fracture patients often have an impaired nutritional status at the time of fracture, which can result in a higher complication rate, prolonged rehabilitation time and increased mortality. A study was designed to evaluate the effect of nutritional intervention on nutritional status, functional status, total length of stay, postoperative complications and cost-effectiveness. Methods: Open-labelled, multi-centre, randomized controlled trial in hip fracture patients aged 55 years and above. The intervention group receives dietetic counselling (by regular home visits and telephone calls) and oral nutritional supplementation for three months after surgery. The control group receives usual dietetic care as provided by the hospital. Outcome assessment is performed at three and six months after hip fracture. Discussion: Patient recruitment has started in July 2007 and has ended in December 2009. First results are expected in 2011. Trial registration: ClinicalTrials.gov NCT00523575Mechanical, Maritime and Materials Engineerin

Evaluation of patients with a recent clinical fracture and osteoporosis, a multidisciplinary approach

The aetiology of osteoporotic fractures is multifactorial, but little is known about the way to evaluate patients with a recent clinical fracture for the presence of secondary osteoporosis