134 research outputs found
Injection and combustion analysis of pure rapeseed oil methyl ester (Rme) in a pump-line-nozzle fuel injection system
none3noThis work suggests an interpretation to the quantitatively higher formation of NOx in a compression ignition (CI) engine when fueled with pure biodiesel (B100). A comparative study about the use of rapeseed oil methyl ester (RME) and diesel fuel mixtures on injection timing, in-chamber pressure, heat release rate, and NOx emissions were carried out using a diesel engine equipped with a pump-line-nozzle injection system. Such engines are still widely adopted mainly in agriculture, as the fleet of agricultural machinery is particularly old (often over 20 years) and the use of biofuels can reduce the environmental footprint of the sector. This work aims to supply some general explanations and figures useful to interpret the phenomena occurring within the fuel line and in the combustion process when using biodiesel, as well as in engines with different construction characteristics and fueling systems. Given the contradictory results available in the literature, the so-called “biodiesel NOx effect” cannot be explained solely by the different physical properties of biodiesel (in particular, a higher bulk modulus). Experimental results show that, with the same pump settings, the start of injection with the RME is slightly advanced while the injection pressure values remain almost the same. With the RME, the pressure in the injection line increases faster due to its greater bulk modulus but the pressure rise starts from a lower residual pressure. The start of combustion takes place earlier, the heat release during the premixed phase is steeper, and a higher peak is reached. The NOx emissions with the RME are at least 9% higher when compared to mineral diesel fuel. The greater amount of the RME injected per cycle compensates for its minor lower heating value, and the brake torque at full load is similar to the two analyzed fuels. Finally, a variation of the pump line timing is evaluated in order to assess the effect of the delay and the advance of the injection on the performance of the engine and on the emissions. A viable and simple solution in the variation of the injection strategy is suggested to counterbalance the biodiesel NOx effect.openCaresana F.; Bietresato M.; Renzi M.Caresana, F.; Bietresato, M.; Renzi, M
LCA Analysis of Renewable Domestic Hot Water Systems with Unglazed and Glazed Solar Thermal Panels
Abstract The paper presents a from-cradle-to-grave LCA (Eco-Indicator 99, Egalitarian Approach) study for two domestic solar hot water systems (DSHWS): a traditional one with glazed panels and a system with unglazed solar collectors. Both systems are coupled with a 300-liters storage tank. The performed LCA returns an EI99 equal to 198.19 for the traditional glazed DSHWS and equal to 18.28 for the unglazed one. For each DSHWS the energy, CO 2 and economic pay-back times were calculated for three different locations (Rome, Madrid and Munich) in order to take into account the influence of local climate on the solar panels yields. The payback times took as basis of comparison two competitive technologies: the natural gas and the electrical boiler
Neutron personal dosimetry using polyallyl diglycol carbonate (PADC): Current status, best practices and proposed research
The objective of this paper is to provide an overview of the current status in neutron personal
dosimetry based on poly allyl diglycol carbonate (PADC), also commonly known by the commercial
name CR-39, to summarize the best practices in the field, and to point future research directions.
An overview of the fundamentals of the technique is given, including a discussion on the PADC
material, main parameters and characteristics, practical considerations, dosimetry approaches,
and relevant standards. This work also summarizes the best practices adopted by individual
monitoring services (IMSs) and discusses the research needed to improve the performance of this type of neutron dosimetry technique, as well as the challenges that make progress difficult. This
work is based on the knowledge and experience of several laboratories and investigators and is
part of the activities of the European Radiation Dosimetry Group (EURADOS) Working Group 2 –
Harmonization of Individual Monitoring in Europe (WG2)
Multicentre investigation of neutron contamination at cardiac implantable electronic device (CIED) location due to high-energy photon beams using passive detectors and Monte Carlo simulations
Radiotherapy treatments involving LINACs operating at accelerating potentials >10 MV generate (photo)neutrons which deliver dose to patients also outside the target volume. This effect is particularly relevant for patients with cardiac implantable electronic devices (CIEDs), which can be damaged by the therapeutic irradiation. In the last few years, there has been a rising interest in this issue, and it seems that damage to CIEDs is primarily associated with the thermal component of the photoneutron field. In particular, a recent study led by Politecnico di Milano considered CIEDs from various manufacturers and showed that some of these devices can be damaged after an irradiation with a thermal neutron fluence of about 10^9 cm^-2. The present work results from a collaboration among Politecnico di Milano, the University of Pisa, the University of Trieste and three Italian hospitals located in Lucca, Trieste and Varese, respectively, and it is primarily aimed at evaluating the thermal neutron fluence in CIED region for some high-energy treatments delivered at 15 and 18 MV and to determine whether it is comparable to the critical value given above, which has been experimentally determined to be potentially harmful for CIEDs. Thermal neutron fluence was measured through CR-39 detectors and TLDs, which were housed inside a BOMAB-like phantom mimicking the patient’s trunk. The experimental sessions involved two models of LINAC, Varian Clinac DHX (Varese hospital) and Elekta Synergy (Lucca and Trieste hospitals). The experimental results show that the treatments considered in this study can lead to a thermal neutron fluence in the cardiac region comparable to the critical value. Furthermore, detailed Monte Carlo geometries for the facilities involved in this project were developed with the MCNP code (v. 6.2), and they were tested by comparing simulation results to measurements considering some benchmark irradiation plans. Bubble detectors were also employed for fast neutron fluence measurements to be compared to simulation outputs. These computational models stand out as promising tools for the investigations required in this work, and they can be used for further studies also extending their use to analogous facilities hosting the same models of LINACs
A comparison of the response of PADC neutron dosemeters in high-energy neutron fields
Within the framework of the EURADOS Working Group 11, a comparison of passive neutron dosemeters in high-energy neutron fields was organised in 2011. The aim of the exercise was to evaluate the response of poly-allyl-glycol-carbonate neutron dosemeters from various European dosimetry laboratories to high-energy neutron fields. Irradiations were performed at the iThemba LABS facility in South Africa with neutrons having energies up to 66 and 100 Me
FLASH Modalities Track (Oral Presentations) OVERVIEW AND CURRENT STATUS OF THE JOINT RESEARCH PROJECT UHDPULSE: “METROLOGY FOR ADVANCED RADIOTHERAPY USING PARTICLE BEAMS WITH ULTRA-HIGH PULSE DOSE RATES”
Analysis of Sentinel Node Biopsy and Clinicopathologic Features as Prognostic Factors in Patients With Atypical Melanocytic Tumors.
BACKGROUND: Atypical melanocytic tumors (AMTs) include a wide spectrum of melanocytic neoplasms that represent a challenge for clinicians due to the lack of a definitive diagnosis and the related uncertainty about their management. This study analyzed clinicopathologic features and sentinel node status as potential prognostic factors in patients with AMTs. PATIENTS AND METHODS: Clinicopathologic and follow-up data of 238 children, adolescents, and adults with histologically proved AMTs consecutively treated at 12 European centers from 2000 through 2010 were retrieved from prospectively maintained databases. The binary association between all investigated covariates was studied by evaluating the Spearman correlation coefficients, and the association between progression-free survival and all investigated covariates was evaluated using univariable Cox models. The overall survival and progression-free survival curves were established using the Kaplan-Meier method. RESULTS: Median follow-up was 126 months (interquartile range, 104-157 months). All patients received an initial diagnostic biopsy followed by wide (1 cm) excision. Sentinel node biopsy was performed in 139 patients (58.4%), 37 (26.6%) of whom had sentinel node positivity. There were 4 local recurrences, 43 regional relapses, and 8 distant metastases as first events. Six patients (2.5%) died of disease progression. Five patients who were sentinel node-negative and 3 patients who were sentinel node-positive developed distant metastases. Ten-year overall and progression-free survival rates were 97% (95% CI, 94.9%-99.2%) and 82.2% (95% CI, 77.3%-87.3%), respectively. Age, mitotic rate/mm2, mitoses at the base of the lesion, lymphovascular invasion, and 9p21 loss were factors affecting prognosis in the whole series and the sentinel node biopsy subgroup. CONCLUSIONS: Age >20 years, mitotic rate >4/mm2, mitoses at the base of the lesion, lymphovascular invasion, and 9p21 loss proved to be worse prognostic factors in patients with ATMs. Sentinel node status was not a clear prognostic predictor
EURADOS education and training activities
This paper provides a summary of the Education and Training (E&amp ; T) activities that have been developed and organized by the European Radiation Dosimetry Group (EURADOS) in recent years and in the case of Training Courses over the last decade. These E&amp ; T actions include short duration Training Courses on well-established topics organized within the activity of EURADOS Working Groups (WGs), or one-day events integrated in the EURADOS Annual Meeting (workshops, winter schools, the intercomparison participants' sessions and the learning network, among others). Moreover, EURADOS has recently established a Young Scientist Grant and a Young Scientist Award. The Grant supports young scientists by encouraging them to perform research projects at other laboratories of the EURADOS network. The Award is given in recognition of excellent work developed within the WGs' work programme. Additionally, EURADOS supports the dissemination of knowledge in radiation dosimetry by promoting and endorsing conferences such as the individual monitoring (IM) series, the neutron and ion dosimetry symposia (NEUDOS) and contributions to E&amp ; T sessions at specific events
Air-Cooling Open Cycle with Peripheral Machines
Proceedings of the 1992 International Refrigeration Conference / Energy Efficiency and New Refrigerants, Purdue, July 199
- …