Determination of bone mineral mass in vivo

Radiographic equipment incorporates two radiation sources, generating high-energy and low-energy beams. Recording equipment measures amount of radiation that has penetrated limb. Data are fed into computer that determines mass of the examined bone

Skeletal status and soft tissue composition in astronauts. Tissue and fluid changes by radionuclide absorptiometry in vivo

A device has been constructed and tested which provides immediate readout of bone mineral content and bone width from absorptiometric scans with low energy radionuclides. The basis of this analog system is a logarithmic converter-integrator coupled with a precision linear ratemeter. The system provided accurate and reliable results on standards and ashed bone sections. Clinical measurements were made on about 100 patients with the direct readout system, and these were highly correlated with the results from digital scan data on the same patients. The direct readout system has been used successfully in field studies and surveys as well as for clinical observations

An analogue of Ryser's Theorem for partial Sudoku squares

In 1956 Ryser gave a necessary and sufficient condition for a partial latin rectangle to be completable to a latin square. In 1990 Hilton and Johnson showed that Ryser's condition could be reformulated in terms of Hall's Condition for partial latin squares. Thus Ryser's Theorem can be interpreted as saying that any partial latin rectangle $R$ can be completed if and only if $R$ satisfies Hall's Condition for partial latin squares. We define Hall's Condition for partial Sudoku squares and show that Hall's Condition for partial Sudoku squares gives a criterion for the completion of partial Sudoku rectangles that is both necessary and sufficient. In the particular case where $n=pq$, $p|r$, $q|s$, the result is especially simple, as we show that any $r \times s$ partial $(p,q)$-Sudoku rectangle can be completed (no further condition being necessary).Comment: 19 pages, 10 figure

Simulation and measurement of hts josephson heterodyne oscillator

We report continuing investigations into practical applications of the ac Josephson effect as the basis for a voltage-tunable radio-frequency oscillator. We have previously demonstrated experimentally that useful power levels (10 s of nW) and linewidths of a few kHz can be achieved in the heterodyne output from a High-Temperature-Superconducting Resistive SQUID (HTS-RSQUID) operating in the frequency range 1-50 MHz. Those results were achieved with 2-junction R-SQUIDs incorporating current-biased shunt resistors of a few micro-ohms. We have now modified the fabrication procedures, and adjusted the shunt resistors and bias current values so that higher frequencies can be achieved. The Josephson junctions are of step-edge type, rather than the bi-crystal type used in our earlier work. The step-edge technique permits much more flexibility in the geometrical lay-out and utilizes the more cost-effective single-crystal MgO substrates. In the present paper, we report numerical simulations and experimental measurements on these devices in the frequency range up to 2 GHz

Moving to Extremal Graph Parameters

Which graphs, in the class of all graphs with given numbers n and m of edges and vertices respectively, minimizes or maximizes the value of some graph parameter? In this paper we develop a technique which provides answers for several different parameters: the numbers of edges in the line graph, acyclic orientations, cliques, and forests. (We minimize the first two and maximize the third and fourth.) Our technique involves two moves on the class of graphs. A compression move converts any graph to a form we call fully compressed: the fully compressed graphs are split graphs in which the neighbourhoods of points in the independent set are nested. A second consolidation move takes each fully compressed graph to one particular graph which we call H(n,m). We show monotonicity of the parameters listed for these moves in many cases, which enables us to obtain our results fairly simply. The paper concludes with some open problems and future directions

Surface flux transport modeling for solar cycles 15--21: effects of cycle-dependent tilt angles of sunspot groups

We model the surface magnetic field and open flux of the Sun from 1913 to 1986 using a surface flux transport model, which includes the observed cycle-to-cycle variation of sunspot group tilts. The model reproduces the empirically derived time evolution of the solar open magnetic flux, and the reversal times of the polar fields. We find that both the polar field and the axial dipole moment resulting from this model around cycle minimum correlate with the strength of the following cycle.Comment: Accepted for publication by Ap

MHD Simulation of the Inner-Heliospheric Magnetic Field

Maps of the radial magnetic field at a heliocentric distance of ten solar radii are used as boundary conditions in the MHD code CRONOS to simulate a 3D inner-heliospheric solar wind emanating from the rotating Sun out to 1 AU. The input data for the magnetic field are the result of solar surface flux transport modelling using observational data of sunspot groups coupled with a current sheet source surface model. Amongst several advancements, this allows for higher angular resolution than that of comparable observational data from synoptic magnetograms. The required initial conditions for the other MHD quantities are obtained following an empirical approach using an inverse relation between flux tube expansion and radial solar wind speed. The computations are performed for representative solar minimum and maximum conditions, and the corresponding state of the solar wind up to the Earths orbit is obtained. After a successful comparison of the latter with observational data, they can be used to drive outer-heliospheric models.Comment: for associated wmv movie files accompanying Figure 7, see http://www.tp4.rub.de/~tow/max.wmv and http://www.tp4.rub.de/~tow/min.wm

Supporting arts and science communities on-line

This paper examines the use of the Web to support continuing professional development (CPD). It outlines the factors driving the adoption of CPD and highlights areas where the Web can aid in the development of successful professional communities. A survey examining the use of the Internet to support professionals working in the domains of the Arts and Science is presented. The study reviews twenty four sites for the presence and degree of adoption of several key features including: - community building, range and value of content, user friendliness and guidance, sophistication of employed Web technology