Velocity-space sensitivity of the time-of-flight neutron spectrometer at JET

The velocity-space sensitivities of fast-ion diagnostics are often described by so-called weight functions. Recently, we formulated weight functions showing the velocity-space sensitivity of the often dominant beam-target part of neutron energy spectra. These weight functions for neutron emission spectrometry (NES) are independent of the particular NES diagnostic. Here we apply these NES weight functions to the time-of-flight spectrometer TOFOR at JET. By taking the instrumental response function of TOFOR into account, we calculate time-of-flight NES weight functions that enable us to directly determine the velocity-space sensitivity of a given part of a measured time-of-flight spectrum from TOFOR

Relationship of edge localized mode burst times with divertor flux loop signal phase in JET

A phase relationship is identified between sequential edge localized modes (ELMs) occurrence times in a set of H-mode tokamak plasmas to the voltage measured in full flux azimuthal loops in the divertor region. We focus on plasmas in the Joint European Torus where a steady H-mode is sustained over several seconds, during which ELMs are observed in the Be II emission at the divertor. The ELMs analysed arise from intrinsic ELMing, in that there is no deliberate intent to control the ELMing process by external means. We use ELM timings derived from the Be II signal to perform direct time domain analysis of the full flux loop VLD2 and VLD3 signals, which provide a high cadence global measurement proportional to the voltage induced by changes in poloidal magnetic flux. Specifically, we examine how the time interval between pairs of successive ELMs is linked to the time-evolving phase of the full flux loop signals. Each ELM produces a clear early pulse in the full flux loop signals, whose peak time is used to condition our analysis. The arrival time of the following ELM, relative to this pulse, is found to fall into one of two categories: (i) prompt ELMs, which are directly paced by the initial response seen in the flux loop signals; and (ii) all other ELMs, which occur after the initial response of the full flux loop signals has decayed in amplitude. The times at which ELMs in category (ii) occur, relative to the first ELM of the pair, are clustered at times when the instantaneous phase of the full flux loop signal is close to its value at the time of the first ELM

Creating Community-Academic Partnerships for Cancer Disparities Research and Health Promotion

Abstract available at publisher's web site

Strategies for Assessing Community Challenges and Strengths for Cancer Disparities Participatory Research and Outreach

Abstract available at publisher's web site

Job uncertainty and personal control during downsizing: A comparison of survivors and victims

This study developed and tested a model of job uncertainty for survivors and victims of downsizing. Data were collected from three samples of employees in a public hospital, each representing three phases of the downsizing process: immediately before the announcement of the redeployment of staff, during the implementation of the downsizing, and towards the end of the official change programme. As predicted, levels of job uncertainty and personal control had a direct relationship with emotional exhaustion and job satisfaction, In addition, there was evidence to suggest that personal control mediated the relationship between job uncertainty and employee adjustment, a pattern of results that varied across each of the three phases of the change event. From the perspective of the organization's overall climate, it was found that levels of job uncertainty, personal control and job satisfaction improved and/or stabilized over the downsizing process. During the implementation phase, survivors experienced higher levels of personal control than victims, but both groups of employees reported similar levels of job uncertainty. We discuss the implications of our results for strategically managing uncertainty during and after organizational change

Impact of nitrogen seeding on confinement and power load control of a high-triangularity JET ELMy H-mode plasma with a metal wall

This paper reports the impact on confinement and power load of the high-shape 2.5MA ELMy H-mode scenario at JET of a change from an all carbon plasma facing components to an all metal wall. In preparation to this change, systematic studies of power load reduction and impact on confinement as a result of fuelling in combination with nitrogen seeding were carried out in JET-C and are compared to their counterpart in JET with a metallic wall. An unexpected and significant change is reported on the decrease of the pedestal confinement but is partially recovered with the injection of nitrogen.Comment: 30 pages, 16 figure