Network algebra for synchronous dataflow

We develop an algebraic theory of synchronous dataflow networks. First, a basic algebraic theory of networks, called BNA (Basic Network Algebra), is introduced. This theory captures the basic algebraic properties of networks. For synchronous dataflow networks, it is subsequently extended with additional constants for the branching connections that occur between the cells of synchronous dataflow networks and axioms for these additional constants. We also give two models of the resulting theory, the one based on stream transformers and the other based on processes as considered in process algebra.Comment: 24 page

Directional solidification of flake and nodular cast iron during KC-135 low-g maneuvers

Alloys solidified in a low-gravity environment can, due to the elimination of sedimentation and convection, form unique and often desirable microstructures. One method of studying the effects of low-gravity (low-g) on alloy solidification was the use of the NASA KC-135 aircraft flying repetitive low-g maneuvers. Each maneuver gives from 20 to 30 seconds of low-g which is between about 0.1 and 0.001 gravity. A directional solidification furnace was used to study the behavior of off eutectic composition case irons in a low-g environment. The solidification interface of hypereutectic flake and spheroidal graphite case irons was slowly advanced through a rod sample, 5 mm in diameter. Controlled solidification was continued through a number of aircraft parabolas. The known solidification rate of the sample was then correlated with accelerometer data to determine the gravity level during solidification for any location of the sample. The thermal gradient and solidification rate were controlled independently. Samples run on the KC-135 aircraft exhibited bands of coarser graphite or of larger nodules usually corresponding to the regions solidified under low-g. Samples containing high phosphorous (used in order to determine the eutectic cell) exhibited larger eutectic cells in the low-g zone, followed by a band of coarser graphite

Preliminary science report on the directional solidification of hypereutectic cast iron during KC-135 low-G maneuvers

An ADSS-P directional solidification furnace was reconfigured for operation on the KC-135 low-g aircraft. The system offers many advantages over quench ingot methods for study of the effects of sedimentation and convection on alloy formation. The directional sodification furnace system was first flown during the September 1982 series of flights. The microstructure of the hypereutectic cast iron sample solidified on one of these flights suggests a low-g effect on graphite morphology. Further experiments are needed to ascertain that this effect is due to low-gravity and to deduce which of the possible mechanisms is responsible for it

Pricing and revenue management: The value of coordination

Cataloged from PDF version of article.The integration of systems for pricing and revenue management must trade off potential revenue gains against significant practical and technical challenges. This dilemma motivates us to investigate the value of coordinating decisions on prices and capacity allocation in a stylized setting. We propose two pairs of sequential policies for making static decisions-on pricing and revenue management-that differ in their degree of integration (hierarchical versus coordinated) and their pricing inputs (deterministic versus stochastic). For a large class of stochastic, price-dependent demand models, we prove that these four heuristics admit tractable solutions satisfying intuitive sensitivity properties. We further evaluate numerically the performance of these policies relative to a fully coordinated model, which is generally intractable. We find it interesting that near-optimal performance is usually achieved by a simple hierarchical policy that sets prices first, based on a nonnested stochastic model, and then uses these prices to optimize nested capacity allocation. This tractable policy largely outperforms its counterpart based on a deterministic pricing model. Jointly optimizing price and allocation decisions for the high-end segment improves performance, but the largest revenue benefits stem from adjusting prices to account for demand risk

Ovoposición de la mariposa Iphiclides podalirius (Lepidoptera, Papilionidae) en plantas exóticas: ¿ampliación del rango de plantas nutricias utilizadas o errores de puesta?

Iphiclides podalirius is an oligophagous butterfly which feeds on plants of the Rosaceae family. In 2002 and 2005 in NE Spain, we recorded for the first time oviposition on two alien plant species, Cotoneaster franchetii and Spiraea cantoniensis. To ascertain if this unusual behaviour represents a broadening of host range or, alternatively, an oviposition mistake, larval performance on the new plants was investigated in the laboratory and compared with performance on the most common host plants used in the study area. Although larval performance on common hosts differed to some extent, the use of a wide range of plants of different quality at population level may in fact respond to the so-called "spreading of risk" strategy in variable environments. On the other hand, larval performance and survival to adulthood were so low on the two new hosts that our observations probably represent a case of maladaptive oviposition behaviour. This may be due to an evolutionary lag between the newly introduced plants and the insect, although other possible explanations are also taken into account.Iphiclides podalirius es una mariposa oligófaga que se alimenta de plantas de la familia Rosaceae. En 2002 y 2005 se observó, por primera vez en el noreste de España, la puesta sobre dos plantas exóticas, Cotoneaster franchetii y Spiraea cantoniensis. Para poder discernir si este comportamiento inusual representa una ampliación del rango de las plantas nutricias utilizado o, por el contrario, se explica como un error de ovoposición, se investigó el desarrollo larvario sobre estas nuevas plantas en el laboratorio y se comparó con el desarrollo sobre las plantas nutricias más ampliamente utilizadas en la zona de estudio. Aunque se observaron diferencias significativas en el tiempo de desarrollo y el peso pupal entre las plantas nutricias habituales, la utilización de todas ellas por parte de una misma población podría responder a una estrategia de "repartir el riesgo" en un ambiente heterogéneo. Por el contrario, la supervivencia larval, el tiempo de desarrollo y el peso pupal fueron tan bajos en las dos nuevas plantas estudiadas que nuestras observaciones constituyen muy probablemente un ejemplo de comportamiento mal adaptado. Ello podría responder a la existencia de un desajuste evolutivo entre las plantas introducidas y el insecto, si bien otras posibles explicaciones son también consideradas y discutidas

A 10B-based neutron detector with stacked Multiwire Proportional Counters and macrostructured cathodes

We present the results of the measurements of the detection efficiency for a 4.7 \r{A} neutron beam incident upon a detector incorporating a stack of up to five MultiWire Proportional Counters (MWPC) with Boron-coated cathodes. The cathodes were made of Aluminum and had a surface exhibiting millimeter-deep V-shaped grooves of 45{\deg}, upon which the thin Boron film was deposited by DC magnetron sputtering. The incident neutrons interacting with the converter layer deposited on the sidewalls of the grooves have a higher capture probability, owing to the larger effective absorption film thickness. This leads to a higher overall detection efficiency for the grooved cathode when compared to a cathode with a flat surface. Both the experimental results and the predictions of the GEANT4 model suggests that a 5-counter detector stack with coated grooved cathodes has the same efficiency as a 7-counter stack with flat cathodes. The reduction in the number of counters in the stack without altering the detection efficiency will prove highly beneficial for large-area position-sensitive detectors for neutron scattering applications, for which the cost-effective manufacturing of the detector and associated readout electronics is an important objective. The proposed detector concept could be a technological option for one of the new chopper spectrometers and other instruments planned to be built at the future European Spallation Source in Sweden. These results with macrostructured cathodes generally apply not just to MWPCs but to other gaseous detectors as well.Comment: 14 pages, 9 figure

Environmental factors influencing butterfly abundance after a severe wildfire in Mediterranean vegetation

Factores ambientales que influyen en la abundancia de mariposas después de un gran incendio forestal en la vegetación mediterráneaA pesar de la atención prestada a la ecología de los lepidópteros, en la región mediterránea poco se sabe acerca de las respuestas de sus comunidades a los incendios forestales. Aquí, evaluamos la comunidad de mariposas dos años después de un gran incendio forestal que afectó 13.000 ha en Cataluña (NE de España) en relación con el hábitat circundante no quemado, mediante transectos para censos visuales. Se examinaron varios parámetros de la comunidad, como la abundancia, la diversidad, la riqueza de especies y equitatividad, comparando las áreas quemadas y no quemadas. Se utilizó el análisis de correspondencias para analizar la composición específica y abundancia relativa de las especies en la comunidad. La influencia de las variables ambientales sobre la abundancia de algunas especies comunes se analizó con modelos mixtos lineales generalizados, teniendo en cuenta los efectos espaciales. No se encontraron diferencias significativas entre los tratamientos en los parámetros de la comunidad y no se detectó dominancia en la zona quemada. La estructura de la vegetación y la distribución geográfica de los transectos influyó en la ordenación de las especies y los transectos en el análisis de correpondencias, peró no se encontró ningún efecto evidente del fuego. Los resultados de los modelos lineales generalizados mixtos (GLMM) señalaron la importancia de la disponibilidad de néctar, el fuego y estructura de la vegetación para explicar la abundancia poblacional de la mayoría de las especies modelizadas.Despite the attention given to the ecology of butterflies, little is known about their community response to wildfires in the Mediterranean region. Here, we evaluated the butterfly assemblage two years after a severe, 13,000 ha wildfire in Catalonia (NE Spain) in relation to the surrounding unburned habitat. Using visual transect censuses we assessed community parameters such as abundance, diversity, species richness and equitability in burned and unburned areas. Correspondence analysis was used to analyse specific composition and relative abundance of species in the community. The influence of environmental variables on the abundance of some common species was analysed using generalized linear mixed models, taking spatial effects into account. No significant differences were found between areas for any of the community parameters, and no dominance was detected in the burned area. The structure of the vegetation and the geographical distribution of transects influenced the ordination of species and transects on the correspondence analysis plot. Generalized linear mixed models (GLMM) results underscored the role of nectar availability, fire and vegetation structure on the abundance of most species studied.Factores ambientales que influyen en la abundancia de mariposas después de un gran incendio forestal en la vegetación mediterráneaA pesar de la atención prestada a la ecología de los lepidópteros, en la región mediterránea poco se sabe acerca de las respuestas de sus comunidades a los incendios forestales. Aquí, evaluamos la comunidad de mariposas dos años después de un gran incendio forestal que afectó 13.000 ha en Cataluña (NE de España) en relación con el hábitat circundante no quemado, mediante transectos para censos visuales. Se examinaron varios parámetros de la comunidad, como la abundancia, la diversidad, la riqueza de especies y equitatividad, comparando las áreas quemadas y no quemadas. Se utilizó el análisis de correspondencias para analizar la composición específica y abundancia relativa de las especies en la comunidad. La influencia de las variables ambientales sobre la abundancia de algunas especies comunes se analizó con modelos mixtos lineales generalizados, teniendo en cuenta los efectos espaciales. No se encontraron diferencias significativas entre los tratamientos en los parámetros de la comunidad y no se detectó dominancia en la zona quemada. La estructura de la vegetación y la distribución geográfica de los transectos influyó en la ordenación de las especies y los transectos en el análisis de correpondencias, peró no se encontró ningún efecto evidente del fuego. Los resultados de los modelos lineales generalizados mixtos (GLMM) señalaron la importancia de la disponibilidad de néctar, el fuego y estructura de la vegetación para explicar la abundancia poblacional de la mayoría de las especies modelizadas