Application of diamond-like carbon coatings to elastomers frictional surfaces

Nitrile-butyl rubber-like materials were coated with amorphous hydrogenated diamond-like carbon (DLC) coatings in order to modify their surface and tribological properties. Measurements of water contact angle were performed by the sessile drop method and showed that the coated samples are more hydrophobic with water contact angles up to 116°. The surface free energy of the elastomers was calculated by the acid-base regression method considering polar and dispersive contributions and the results were correlated with changes in the surface chemistry measured by X-ray photoelectron spectroscopy. It has been found that the lower presence of oxygen functional groups on the elastomer surfaces led to lower surface free energies, even though the polar contribution was not predominant. We also found that the DLC coatings led to a significant decrease of the surface free energy (up to 16%) and that there is a good correlation between the surface free energy values and the corresponding water contact angle values. The coefficient of friction was also measured and presented a significant decrease after coating with DLC. © 2008 Elsevier Ltd. All rights reserved.The authors acknowledge the financial support of the EU from the Sixth framework programme in the KRISTAL Project no. 515837-2. L. Martínez and Y. Huttel acknowledge the Spanish “Ministerio de Educación y Ciencia” for the “Juan de la Cierva” and “Ramón y Cajal” programmes, respectively. R. Nevshupa acknowledges the “Marie Curie” programme (MIF1-CT-2006-22067)

Overview of cattle diseases listed under category C, D or E in the animal health law for wich control programmes are in place within Europe

13 páginas, 5 figuras, 3 tablas.The COST action “Standardising output-based surveillance to control non-regulated diseases of cattle in the European Union (SOUND control),” aims to harmonise the results of surveillance and control programmes (CPs) for non-EU regulated cattle diseases to facilitate safe trade and improve overall control of cattle infectious diseases. In this paper we aimed to provide an overview on the diversity of control for these diseases in Europe. A non-EU regulated cattle disease was defined as an infectious disease of cattle with no or limited control at EU level, which is not included in the European Union Animal health law Categories A or B under Commission Implementing Regulation (EU) 2020/2002. A CP was defined as surveillance and/or intervention strategies designed to lower the incidence, prevalence, mortality or prove freedom from a specific disease in a region or country. Passive surveillance, and active surveillance of breeding bulls under Council Directive 88/407/EEC were not considered as CPs. A questionnaire was designed to obtain country-specific information about CPs for each disease. Animal health experts from 33 European countries completed the questionnaire. Overall, there are 23 diseases for which a CP exists in one or more of the countries studied. The diseases for which CPs exist in the highest number of countries are enzootic bovine leukosis, bluetongue, infectious bovine rhinotracheitis, bovine viral diarrhoea and anthrax (CPs reported by between 16 and 31 countries). Every participating country has on average, 6 CPs (min–max: 1–13) in place. Most programmes are implemented at a national level (86%) and are applied to both dairy and non-dairy cattle (75%). Approximately one-third of the CPs are voluntary, and the funding structure is divided between government and private resources. Countries that have eradicated diseases like enzootic bovine leukosis, bluetongue, infectious bovine rhinotracheitis and bovine viral diarrhoea have implemented CPs for other diseases to further improve the health status of cattle in their country. The control of non-EU regulated cattle diseases is very heterogenous in Europe. Therefore, the standardising of the outputs of these programmes to enable comparison represents a challenge.Peer reviewe

Simulation Based Evaluation of Time Series for Syndromic Surveillance of Cattle in Switzerland

Choosing the syndrome time series to monitor in a syndromic surveillance system is not a straight forward process. Defining which syndromes to monitor in order to maximize detection performance has been recently identified as one of the research priorities in Syndromic surveillance. Estimating the minimum size of an epidemic that could potentially be detected in a specific syndrome could be used as a criteria for comparing the performance of different syndrome time series, and could provide some guidance for syndrome selection. The aim of our study was to estimate the potential value of different time series for building a national syndromic surveillance system for cattle in Switzerland. Simulations were used to produce outbreaks of different size and shape and to estimate the ability of each time series and aberration detection algorithm to detect them with high sensitivity, specificity and timeliness. Two temporal aberration detection algorithms were also compared: Holt-Winters generalized exponential smoothing (HW) and Exponential Weighted Moving Average (EWMA). Our results indicated that a specific aberration detection algorithm should be used for each time series. In addition, time series with high counts per unit of time had good overall detection performance, but poor detection performance for small epidemics making them of limited use for an early detection system. Estimating the minimum size of simulated epidemics that could potentially be detected in syndrome TS-event detection pairs can help surveillance system designers choosing the most appropriate syndrome TS to include in their early epidemic surveillance system

Analytical noise modelling of a centrifugal fan validated by experimental data

This study focuses on the understanding and modelling of noise radiated from a mine ventilation fan, with the ultimate aim of designing quiet fan impellers. Experimental measurements are presented that suggest that the main noise sources on mine ventilation fans are related to the impeller and consist of tonal components created by the passage of the blades past the volute tongue and broadband noise associated with turbulent flow interacting with the blades. Two models, one analytical and one semi-empirical, have been developed to predict the broadband components of the radiated noise. Given the assumptions made, the computed far field noise compares well with experimental data. The models are therefore good candidates for use in designing new, quieter mine ventilation fan systems in the future