254 research outputs found
The development of the physical fundamentals of contact soldering as a factor for reducing the number of defects in electronic devices
Automated control systems employ electronic components that are connected with a printed circuit board (PCB) by soldered joints. At elevated temperatures and with high vibration levels, soldering defects may occur that are characterized by the deterioration or complete loss of contact with the PCB, which can lead to the failure of the system. In this work, an approach is proposed to considerably improve the reliability of soldered joints. © 2013 Pleiades Publishing, Ltd
The reliability of soldered joints produced at a low temperature
Under severe service conditions of electronic instruments (at elevated temperatures and vibrations in electronic systems), failures in their operation frequently occur. Severe intrinsic thermal conditions of operating instruments may cause such failures. However, malfunctions in electronic devices may often be due to defects in soldered joints that were made at lowered temperatures. An approach is proposed that makes it possible to considerably improve the reliability of soldered joints. © 2013 Pleiades Publishing, Ltd
Quasi-linear analysis of the extraordinary electron wave destabilized by runaway electrons
Runaway electrons with strongly anisotropic distributions present in
post-disruption tokamak plasmas can destabilize the extraordinary electron
(EXEL) wave. The present work investigates the dynamics of the quasi-linear
evolution of the EXEL instability for a range of different plasma parameters
using a model runaway distribution function valid for highly relativistic
runaway electron beams produced primarily by the avalanche process. Simulations
show a rapid pitch-angle scattering of the runaway electrons in the high energy
tail on the time scale. Due to the wave-particle
interaction, a modification to the synchrotron radiation spectrum emitted by
the runaway electron population is foreseen, exposing a possible experimental
detection method for such an interaction
On the Possibility of Reducing the Objective Lens Diameter in the Optoelectronic System
AbstractWhen optoelectronic systems (OES) are used for control purposes in mechanical engineering, there is a risk of objective cracking caused by collision with hard particles of the environment. The article shows that it is possible to reduce the objective lens diameter two times without loss of resolution, and thus to improve impact resistance by reducing the probability of collision and objective lens cracking
Defining of the Power of a Control Loop Actuator
AbstractThe input harmonical signal is usually used to define the power consumed by actuators of control loops of regulative systems. It's shown that if there are no limits imposed on the type of input disturbance, the power consumption may increase up to two times
Similarities and differences in the dolomitization history of two coeval Middle Triassic carbonate platforms, Balaton Highland, Hungary
Dolomitization of platform carbonates is commonly the result of multiphase processes. Documentation of the complex dolomitization history is difficult if completely dolomitized sections are studied. Two Middle Anisian sections representing two coeval carbonate platforms were investigated and compared in the present study. Both sections are made up of meter-scale peritidal–lagoonal cycles with significant pedogenic overprint. One of the sections contains non-dolomitized, partially dolomitized, and completely dolomitized intervals, whereas the other is completely dolomitized. Based on investigations of the partially dolomitized section, penecontemporaneous dolomite formation and/or very early post-depositional dolomitization were identified in various lithofacies types. In shallow subtidal facies, porphyrotopic dolomite was found preferentially in microbial micritic fabrics. Microbially induced dolomite precipitation and/or progressive replacement of carbonate sediments could be interpreted for stromatolites. Cryptocrystalline to very finely crystalline dolomite, probably of pedogenic origin, was encountered in paleosoil horizons. Fabric-destructive dolomite commonly found below these horizons was likely formed via reflux of evaporated seawater. As a result of the different paleogeographic settings of the two platforms, their shallow-burial conditions were significantly different. One of the studied sections was located at the basinward platform margin where pervasive fabric-retentive dolomitization took place in a shallow-burial setting, probably via thermal convection. In contrast, in the area of the other, smaller platform shallow-water carbonates were covered by basinal deposits, preventing fluid circulation and accordingly pervasive shallow-burial dolomitization. In the intermediate to deep burial zone, recrystallization of partially dolomitized limestone and occlusion of newly opened fractures and pores by coarsely crystalline dolomite took place
Spatially Resolved Mapping of Local Polarization Dynamics in an Ergodic Phase of Ferroelectric Relaxor
Spatial variability of polarization relaxation kinetics in relaxor
ferroelectric 0.9Pb(Mg1/3Nb2/3)O3-0.1PbTiO3 is studied using time-resolved
Piezoresponse Force Microscopy. Local relaxation attributed to the
reorientation of polar nanoregions is shown to follow stretched exponential
dependence, exp(-(t/tau)^beta), with beta~~0.4, much larger than the
macroscopic value determined from dielectric spectra (beta~~0.09). The spatial
inhomogeneity of relaxation time distributions with the presence of 100-200 nm
"fast" and "slow" regions is observed. The results are analyzed to map the
Vogel-Fulcher temperatures on the nanoscale.Comment: 23 pages, 4 figures, supplementary materials attached; to be
submitted to Phys. Rev. Let
Predictors of postoperative seizure outcome in low grade glioma: From volumetric analysis to molecular stratification
The importance of the extent of resection (EOR) has been widely demonstrated as the main predictor for survival, nevertheless its effect on tumor related epilepsy is less investigated. A total of 155 patients were enrolled after a first-line surgery for supratentorial Diffuse Low Grade Gliomas (DLGGs). Postoperative seizure outcome was analyzed stratifying the results by tumor volumetric data and molecular markers according to 2016 WHO classification. Receiver operating characteristic (ROC) curves were computed to asses EOR, residual tumor volume, and 06T2T1 MRI index (expressing the tumor growing pattern) corresponding to optimal seizure outcome. A total of 70.97% of patients were seizure-free 18 months after surgery. Better seizure outcome was observed in IDH1/2 mutated and 1p/19q codeleted subgroup. At multivariate analysis, age (p = 0.014), EOR (p = 0.030), 06T2T1 MRI index (p = 0.016) resulted as independent predictors of postoperative seizure control. Optimal parameters to improve postoperative seizure outcome were EOR 65 85%, 06T2T1 MRI index 64 18 cm3, residual tumor volume 64 15 cm3. This study confirms the role of EOR and tumor growing pattern on postoperative seizure outcome independently from the molecular class. Higher 06T2T1 MRI index, representing the infiltrative component of the tumor, is associated with worse seizure outcome and strengthens the evidence of common pathogenic mechanisms underlying tumor growth and postoperative seizure outcome
Model field study of Sumithion 50 EC and Fusilade S on pheasants
Toxicological studies on wild animals play an important role in the ecotoxicological examination of pesticides. The applied model tests enable the assessment of toxicological consequences with particular regard to the life and nutrition of wild animals in the ploughed field among plants treated with pesticides. The application of different pesticide formulations on plough-land may pose a simultaneous chemical burden to wild birds. In this model study, manifestations of the interaction between an insecticide and a herbicide were studied in pheasants. The birds were placed on lucerne in cages (48 m2) and sprayed once. The applied doses were: Sumithion 50 EC 1 litre/ha + Fusilade S 6 litres/ha (practical doses) and Sumithion 50 EC 5 litres/ha + Fusilade S 30 litres/ha. The analytically determined pesticide concentration of the lucerne was taken as a basis in the further treatment of fodder. The fodder of pheasants contained the following chemicals: 85 mg/kg Sumithion 50 EC + 510 mg/kg Fusilade S and 425 mg/kg Sumithion 50 EC + 2250 mg/kg Fusilade S. Sporadic deaths observed among the pheasants were of traumatic origin and not due to a toxic effect. The decrease of body weight was significant only at the higher dose levels. Acetylcholinesterase (AChE) activity of the blood decreased significantly in both dose groups. On the basis of the results obtained it can be established that at the dose level used in the practice the pesticides studied do not give rise to a toxic interaction in pheasants
- …