Frequency‐Dependent Moment Tensors of Induced Microearthquakes

Analysis of 984 induced microearthquakes from The Geysers geothermal reservoir in California reveals that the retrieved moment tensors depend on the frequency band of the inverted waveforms. The observed dependence is more significant for the percentages of the double‐couple, compensated linear vector dipole, and isotropic (ISO) components than for the focal mechanisms. The average root‐mean‐square of the moment tensors obtained in different frequency bands is correlated with spectra of ambient noise. The percentages of double‐couple and ISO components tend to decrease and increase with the upper cutoff frequency (fu), respectively. This suggests that shear rupture radiates energy preferentially in a lower frequency band and tensile rupture in a higher frequency band. Events displaying a strong increase of the ISO with fu are confined within the same depth interval as the injection points. This might be related to the strong thermoelastic effects in the vicinity of injection points that promote opening of small cracks adjacent to the main fractures

Study of SEM induced current and voltage contrast modes to assess semiconductor reliability

The purpose of the scanning electron microscopy study was to review the failure history of existing integrated circuit technologies to identify predominant failure mechanisms, and to evaluate the feasibility of their detection using SEM application techniques. The study investigated the effects of E-beam irradiation damage and contamination deposition rates; developed the necessary methods for applying the techniques to the detection of latent defects and weaknesses in integrated circuits; and made recommendations for applying the techniques

Photo sensor array technology development

The development of an improved capability photo sensor array imager for use in a Viking '75 type facsimile camera is presented. This imager consists of silicon photodiodes and lead sulfide detectors to cover a spectral range from 0.4 to 2.7 microns. An optical design specifying filter configurations and convergence angles is described. Three electronics design approaches: AC-chopped light, DC-dual detector, and DC-single detector, are investigated. Experimental and calculated results are compared whenever possible using breadboard testing and tolerance analysis techniques. Results show that any design used must be forgiving of the relative instability of lead sulfide detectors. A final design using lead sulfide detectors and associated electronics is implemented by fabrication of a hybrid prototype device. Test results of this device show a good agreement with calculated values

Observations of celestial X-ray sources above 20 keV with the high-energy scintillation spectrometer on board OSO 8

High-energy X-ray spectra of the Crab Nebula, Cyg- XR-1, and Cen A were determined from observations with the scintillation spectrometer on board the OSO-8 satellite, launched in June, 1975. Each of these sources was observed over two periods of 8 days or more, enabling a search for day-to-day and year to year variations in the spectral and temporal characteristics of the X-ray emission. No variation in the light curve of the Crab pulsar was found from observations which span a 15-day period in March 1976, with demonstrable phase stability. Transitions associated with the binary phase of Cyg XR-1 and a large change in the emission from Con A are reported

Detection of high energy X-rays from the galactic center region

Observations of the galactic center region made with the high energy X-ray detector on OSO-8 are discussed. A strong hard X-ray which was detected during these observations from the vicinity of the galactic center are examined. The counting rate spectrum and the photon number spectrum of the flux are determined. Comparisons with the high energy X-ray fluxes observed from sources in the region by others are discussed

Thermogravimetric Evaluation of Fungal Degradation of Wood

Yellow birch (Betula alleghaniensis Brit.) was degraded by a white rot fungus (Polyporus versicolor L. ex Fr.; now Coriolus versicolor (L.) Quél.) and a brown rot fungus (Poria monticola Murr.; now Poria placenta (Fr.) Cke.) under controlled conditions. Samples of known weight loss from fungi were milled to pass a 40-mesh screen, oven-dried, and then measured for rate of mass loss over selected temperature ranges. Rates of mass loss of nominal 4-mg samples were obtained isothermally in flowing oxygen using a thermo-gravimetric (TG) system containing a Cahn electrobalance. Activation energy (E) was found using zero-order kinetics for the initial mass loss. White-rotted birch (to 60% weight loss) had an E of 35 to 43 kcal/mole over the range of approximately 190 to 210 C. On the basis of TG data, the weight loss from fungal attack could be predicted within about 5%. Brown-rotted birch had more variation in E (30 to 44 kcal/mole), over a temperature range of 170 to 195 C. The rate of mass loss of brown-rotted birch (to 52% weight loss) was more sensitive to temperature because of the known nonlinear decrease in cellulose DP during fungal attack. Dynamic thermogravimetry, a much simpler method, indicated a similar degree of instability from fungal attack as did the isothermal tests. TG appears to be a viable research method to evaluate fungal attack of wood

Peer review quality and transparency of the peer-review process in open access and subscription journals

BACKGROUND:Recent controversies highlighting substandard peer review in Open Access (OA) and traditional (subscription) journals have increased the need for authors, funders, publishers, and institutions to assure quality of peer-review in academic journals. I propose that transparency of the peer-review process may be seen as an indicator of the quality of peer-review, and develop and validate a tool enabling different stakeholders to assess transparency of the peer-review process. METHODS AND FINDINGS:Based on editorial guidelines and best practices, I developed a 14-item tool to rate transparency of the peer-review process on the basis of journals' websites. In Study 1, a random sample of 231 authors of papers in 92 subscription journals in different fields rated transparency of the journals that published their work. Authors' ratings of the transparency were positively associated with quality of the peer-review process but unrelated to journal's impact factors. In Study 2, 20 experts on OA publishing assessed the transparency of established (non-OA) journals, OA journals categorized as being published by potential predatory publishers, and journals from the Directory of Open Access Journals (DOAJ). Results show high reliability across items (α = .91) and sufficient reliability across raters. Ratings differentiated the three types of journals well. In Study 3, academic librarians rated a random sample of 140 DOAJ journals and another 54 journals that had received a hoax paper written by Bohannon to test peer-review quality. Journals with higher transparency ratings were less likely to accept the flawed paper and showed higher impact as measured by the h5 index from Google Scholar. CONCLUSIONS:The tool to assess transparency of the peer-review process at academic journals shows promising reliability and validity. The transparency of the peer-review process can be seen as an indicator of peer-review quality allowing the tool to be used to predict academic quality in new journals