Economic evaluation of a community based exercise programme to prevent falls

OBJECTIVE: To assess the incremental costs and cost effectiveness of implementing a home based muscle strengthening and balance retraining programme that reduced falls and injuries in older women. DESIGN: An economic evaluation carried out within a randomised controlled trial with two years of follow up. Participants were individually prescribed an exercise programme (exercise group, n=116) or received usual care and social visits (control group, n=117). SETTING: 17 general practices in Dunedin, New Zealand. PARTICIPANTS: Women aged 80 years and older living in the community and invited by their general practitioner to take part. MAIN OUTCOME MEASURES: Number of falls and injuries related to falls, costs of implementing the intervention, healthcare service costs resulting from falls and total healthcare service costs during the trial. Cost effectiveness was measured as the incremental cost of implementing the exercise programme per fall event prevented. MAIN RESULTS: 27% of total hospital costs during the trial were related to falls. However, there were no significant differences in health service costs between the two groups. Implementing the exercise programme for one and two years respectively cost $314 and$265 (1995 New Zealand dollars) per fall prevented, and $457 and$426 per fall resulting in a moderate or serious injury prevented. CONCLUSIONS: The costs resulting from falls make up a substantial proportion of the hospital costs for older people. Despite a reduction in falls as a result of this home exercise programme there was no significant reduction in healthcare costs. However, the results reported will provide information on the cost effectiveness of the programme for those making decisions on falls prevention strategies

The Proper Motion of PSR J0205+6449 in 3C 58

We report on sensitive phase-referenced and gated 1.4-GHz VLBI radio observations of the pulsar PSR J0205+6449 in the young pulsar-wind nebula 3C 58, made in 2007 and 2010. We employed a novel technique where the ~105-m Green Bank telescope is used simultaneously to obtain single-dish data used to determine the pulsar's period as well as to obtain the VLBI data, allowing the VLBI correlation to be gated synchronously with the pulse to increase the signal-to-noise. The high timing noise of this young pulsar precludes the determination of the proper motion from the pulsar timing. We derive the position of the pulsar accurate at the milliarcsecond level, which is consistent with a re-determined position from the Chandra X-ray observations. We reject the original tentative optical identification of the pulsar by Shearer and Neustroev (2008), but rather identify a different optical counterpart on their images, with R-band magnitude ~24. We also determine an accurate proper motion for PSR J0205+6449 of (2.3 +- 0.3) mas/yr, corresponding to a projected velocity of only (35 +- 6) km/s for a distance of 3.2 kpc, at p.a. -38 deg. This projected velocity is quite low compared to the velocity dispersion of known pulsars of ~200 km/s. Our measured proper motion does not suggest any particular kinematic age for the pulsar.Comment: 10 pages, 7 figures; accepted for publication in MNRA

Dissection of the amyloid formation pathway in AL amyloidosis

In antibody light chain (AL) amyloidosis, overproduced light chain (LC) fragments accumulate as fibrils in organs and tissues of patients. In vitro, AL fibril formation is a slow process, characterized by a pronounced lag phase. The events occurring during this lag phase are largely unknown. We have dissected the lag phase of a patient-derived LC truncation and identified structural transitions that precede fibril formation. The process starts with partial unfolding of the V-L domain and the formation of small amounts of dimers. This is a prerequisite for the formation of an ensemble of oligomers, which are the precursors of fibrils. During oligomerization, the hydrophobic core of the LC domain rearranges which leads to changes in solvent accessibility and rigidity. Structural transitions from an anti-parallel to a parallel beta-sheet secondary structure occur in the oligomers prior to amyloid formation. Together, our results reveal a rate-limiting multi-step mechanism of structural transitions prior to fibril formation in AL amyloidosis, which offers, in the long run, opportunities for therapeutic intervention. AL amyloidosis is caused by the accumulation of overproduced light chain (LC) fragments as fibrils in patient organs and it is the most prevalent systemic amyloidosis. Here, the authors combine biochemical and biophysical experiments to characterise the lag phase of a patient-derived truncated LC and they identify structural transitions that precede fibril formation

Variable Depth Bragg Peak Method for Single Event Effects Testing

Traditionally, accelerator SEE testing is accomplished by removing the tops of packages so that the IC chips are accessible to heavy ions. However, ICs in some advanced packages cannot be de-lidded so a different approach is used that involves grinding and/or chemically etching away part of the package and the chip from the back side. The parts are then tested from the back side with ions having sufficient range to reach the sensitive volume. More recently, the entire silicon substrate in an SOI/SRAM was removed, making it possible to use low-energy ions with shorter ranges. Where removal of part of the package is not possible, facilities at Michigan State, NASA Space Radiation Laboratory, GANIL (France) and GSI (Germany) offer high-energy heavy ions with long ranges so that the ions can reach the devices' sensitive volumes without much change in the LET. Unfortunately, a run will typically involve only one ion species having a single energy and LET due to the long time it takes to tune a new energy. The Variable Depth Bragg Peak (VDBP) method is similar to the above method in that it involves the use of high-energy heavy ions that are able to pass through the packaging material and reach the device, obviating the need to remove the package. However, the method provides a broad range of LETs from a single ion by inserting degraders in the beam that modify the ion energy and, therefore, the LET. The crux of the method involves establishing a fiduciary point for degrader thickness, i.e., where the Bragg peak is located precisely at the sensitive volume in the device, for which the measured SEU cross-section and the ion LET are both also maxima and can be calculated using a Monte-Carlo program, TRIM. Once the fiduciary point has been established, calibrated high density polyethylene (HDPE) degraders are inserted into or removed from the beam to vary the ion LET at the device in a known manner. After each change of degrader thickness, the SEU cross-section is measured and the corresponding LET calculated from the change in degrader thickness. That information is used to generate a plot of cross-section as a function of ion LET. The advantages of this approach are that the part does not have to be de-lidded and a broad range of LETs is available from a single heavy ion without having to go to non-normal angles of incidence to change the "effective" LET. As we will show, it is possible to obtain an entire curve of cross-section versus LET using just two or three ions. Fig. 1 shows curves of cross-section vs LET for a Freescale 4 Mbit SOI/SRAM measured at the 88" Cyclotron at Berkeley and at NSRL. The open symbols are the data obtained from Berkeley for top-side and back-side irradiation. The solid data points are for the data obtained at NSRL using a device for which the package was intact. The data are for Iron and Gold and cover a range of LETs from 4 MeV.cm2/mg to 84 MeV.cm2/mg. The agreement between the data obtained from Berkeley and from NSRL is excellent, demonstrating that the VDBP method is capable of providing accurate values of cross-section versus LET, at least for the 4 Mbit SRAM. Details of the technique will be included in the final presentation

The relative abundance of wheat Rubisco activase isoforms is post‑transcriptionally regulated

Diurnal rhythms and light availability affect transcription–translation feedback loops that regulate the synthesis of photosynthetic proteins. The CO2-fixing enzyme Rubisco is the most abundant protein in the leaves of major crop species and its activity depends on interaction with the molecular chaperone Rubisco activase (Rca). In Triticum aestivum L. (wheat), three Rca isoforms are present that differ in their regulatory properties. Here, we tested the hypothesis that the relative abundance of the redox-sensitive and redox-insensitive Rca isoforms could be differentially regulated throughout light–dark diel cycle in wheat. While TaRca1-β expression was consistently negligible throughout the day, transcript levels of both TaRca2-β and TaRca2-α were higher and increased at the start of the day, with peak levels occurring at the middle of the photoperiod. Abundance of TaRca-β protein was maximal 1.5 h after the peak in TaRca2-β expression, but the abundance of TaRca-α remained constant during the entire photoperiod. The redox-sensitive TaRca-α isoform was less abundant, representing 85% of the redox-insensitive TaRca-β at the transcript level and 12.5% at the protein level. Expression of Rubisco large and small subunit genes did not show a consistent pattern throughout the diel cycle, but the abundance of Rubisco decreased by up to 20% during the dark period in fully expanded wheat leaves. These results, combined with a lack of correlation between transcript and protein abundance for both Rca isoforms and Rubisco throughout the entire diel cycle, suggest that the abundance of these photosynthetic enzymes is post-transcriptionally regulated

Full spin switch effect for the superconducting current in a superconductor/ferromagnet thin film heterostructure

Superconductor/ferromagnet (S/F) proximity effect theory predicts that the superconducting critical temperature of the F1/F2/S or F1/S/F2 trilayers for the parallel orientation of the F1 and F2 magnetizations is smaller than for the antiparallel one. This suggests a possibility of a controlled switching between the superconducting and normal states in the S layer. Here, using the spin switch design F1/F2/S theoretically proposed by Oh et al. [Appl. Phys. Lett. 71, 2376 (1997)], that comprises a ferromagnetic bilayer separated by a non-magnetic metallic spacer layer as a ferromagnetic component, and an ordinary superconductor as the second interface component, we have successfully realized a full spin switch effect for the superconducting current.Comment: 5 pages, 4 figure

The Functional Diversity of the High-Affinity Nitrate Transporter Gene Family in Hexaploid Wheat: Insights from Distinct Expression Profiles

High-affinity nitrate transporters (NRT) are key components for nitrogen (N) acquisition and distribution within plants. However, insights on these transporters in wheat are scarce. This study presents a comprehensive analysis of the NRT2 and NRT3 gene families, where the aim is to shed light on their functionality and to evaluate their responses to N availability. A total of 53 NRT2s and 11 NRT3s were identified in the bread wheat genome, and these were grouped into different clades and homoeologous subgroups. The transcriptional dynamics of the identified NRT2 and NRT3 genes, in response to N starvation and nitrate resupply, were examined by RT-qPCR in the roots and shoots of hydroponically grown wheat plants through a time course experiment. Additionally, the spatial expression patterns of these genes were explored within the plant. The NRT2s of clade 1, TaNRT2.1-2.6, showed a root-specific expression and significant upregulation in response to N starvation, thus emphasizing a role in N acquisition. However, most of the clade 2 NRT2s displayed reduced expression under N-starved conditions. Nitrate resupply after N starvation revealed rapid responsiveness in TaNRT2.1-2.6, while clade 2 genes exhibited gradual induction, primarily in the roots. TaNRT2.18 was highly expressed in above-ground tissues and exhibited distinct nitrate-related response patterns for roots and shoots. The TaNRT3 gene expression closely paralleled the profiles of TaNRT2.1-2.6 in response to nitrate induction. These findings enhance the understanding of NRT2 and NRT3 involvement in nitrogen uptake and utilization, and they could have practical implications for improving nitrogen use efficiency. The study also recommends a standardized nomenclature for wheat NRT2 genes, thereby addressing prior naming inconsistencies

Overexpression of a NAC transcription factor delays leaf senescence and increases grain nitrogen concentration in wheat

Increasing the duration of leaf photosynthesis during grain filling using slow-senescing functional stay-green phenotypes is a possible route for increasing grain yields in wheat (Triticum aestivum L.). However, delayed senescence may negatively affect nutrient remobilisation and hence reduce grain protein concentrations and grain quality. A novel NAC1-type transcription factor (hereafter TaNAC-S) was identified in wheat, with gene expression located primarily in leaf/sheath tissues, which decreased during post-anthesis leaf senescence. Expression of TaNAC-S in the second leaf correlated with delayed senescence in two doubled-haploid lines of an Avalon 3 Cadenza population (lines 112 and 181), which were distinct for leaf senescence. Transgenic wheat plants overexpressing TaNAC-S resulted in delayed leaf senescence (stay-green phenotype). Grain yield, aboveground biomass, harvest index and total grain N content were unaffected, but NAC over-expressing lines had higher grain N concentrations at similar grain yields compared to non-transgenic controls. These results indicate that TaNAC-S is a negative regulator of leaf senescence, and that delayed leaf senescence may lead not only to increased grain yields but also to increased grain protein concentrations.D. Zhao, A. P. Derkx, D.-C. Liu, P. Buchner, M. J. Hawkesfor

The effect of induced forelimb lameness on thoracolumbar kinematics during treadmill locomotion

Reasons for performing study: Lameness has often been suggested to result in altered movement of the back, but there are no detailed studies describing such a relationship in quantitative terms. Objectives: To quantify the effect of induced subtle forelimb lameness on thoracolumbar kinematics in the horse. Methods: Kinematics of 6 riding horses was measured at walk and at trot on a treadmill before and after the induction of reversible forelimb lameness grade 2 (AAEP scale 1-5). Ground reaction forces (GRF) for individual limbs were calculated from kinematics. Results: The horses significantly unloaded the painful limb by 11.5% at trot, while unloading at walk was not significant. The overall flexion-extension range of back motion decreased on average by 0.2° at walk and increased by 3.3° at trot (P<0.05). Changes in angular motion patterns of vertebral joints were noted only at trot, with an increase in flexion of 0.9° at T10 (i.e. angle between T6, T10 and T13) during the stance phase of the sound diagonal and an increase in extension of the thoracolumbar area during stance of the lame diagonal (0.7° at T13, 0.8° at T17, 0.5° at L1, 0.4° at L3 and 0.3° at L5) (P<0.05). Lameness further caused a lateral bending of the cranial thoracic vertebral column towards the lame side (1.3° at T10 and 0.9° at T13) (P<0.05) during stance of the lame diagonal. Conclusions: Both range of motion and vertebral angular motion patterns are affected by subtle forelimb lameness. At walk, the effect is minimal, at trot the horses increased the vertebral range of motion and changed the pattern of thoracolumbar motion in the sagittal and horizontal planes, presumably in an attempt to move the centre of gravity away from the lame side and reduce the force on the affected limb. Potential relevance: Subtle forelimb lameness affects thoracolumbar kinematics. Future studies should aim at elucidating whether the altered movement patterns lead to back and/or neck dysfunction in the case of chronic lameness