1,897 research outputs found
Development of an independent hydrology audit methodology to support flood risk assessment in the planning process in Scotland
The detection and tracking of mine-water pollution from abandoned mines using electrical tomography
Increasing emphasis is being placed on the environmental and societal impact of mining, particularly in the EU, where the environmental impacts of abandoned mine sites (spoil heaps and tailings) are now subject to the legally binding Water Framework and Mine Waste Directives.
Traditional sampling to monitor the impact of mining on surface waters and groundwater is laborious, expensive and often unrepresentative. In particular, sparse and infrequent borehole sampling may fail to capture the dynamic behaviour associated with important events such as flash flooding, mine-water break-out, and subsurface acid mine drainage. Current monitoring practice is therefore failing to provide the information needed to assess the socio-economic and environmental impact of mining on vulnerable eco-systems, or to give adequate early warning to allow preventative maintenance or containment. BGS has developed a tomographic imaging system known as ALERT ( Automated time-Lapse Electrical Resistivity Tomography) which allows the near real-time measurement of geoelectric properties "on demand", thereby giving early warning of potential threats to vulnerable water systems. Permanent in-situ geoelectric measurements are used to provide surrogate indicators of hydrochemical and hydrogeological properties. The ALERT survey concept uses electrode arrays, permanently buried in shallow trenches at the surface but these arrays could equally be deployed in mine entries or shafts or underground workings. This sensor network is then interrogated from the office by wireless telemetry (e.g: GSM, low-power radio, internet, and satellite) to provide volumetric images of the subsurface at regular intervals. Once installed, no manual intervention is required; data is transmitted automatically according to a pre-programmed schedule and for specific survey parameters, both of which may be varied remotely as conditions change (i.e: an adaptive sampling approach). The entire process from data capture to visualisation on the web-portal is seamless, with no manual intervention.
Examples are given where ALERT has been installed and used to remotely monitor (i) seawater intrusion in a coastal aquifer (ii) domestic landfills and contaminated land and (iii) vulnerable earth embankments. The full potential of the ALERT concept for monitoring mine-waste has yet to be demonstrated. However we have used manual electrical tomography surveys to characterise mine-waste pollution at an abandoned metalliferous mine in the Central Wales orefield in the UK. Hydrogeochemical sampling confirms that electrical tomography can provide a reliable surrogate for the mapping and long-term monitoring of mine-water pollution
Fertilizers boost yields of small grains, grasses and legumes
Corn is king in Iowa. But corn should not be grown continuously. It should be rotated with small grains, clover or alfalfa. Such a rotation insures a good nitrogen level in the soil, cuts down on erosion, and helps keep the soil in good tilth. These factors in turn result in higher corn yields. Too often we neglect or omit our small grains and seedings because they don’t give us the high cash return of corn. One way to make them more profitable is to increase their yields. You can give the yields a real boost with fertilizers.
There are two ways to use fertilizers on small grains and forages— the,right and the wrong. Among other things, the right way involves using the correct kind and amount of fertilizer, applying it effectively to the soil and at the best time. You must know how to do these things. They will determine the returns you will get from your fertilizer. To give you the best possible information on these points, the Iowa Agricultural Experiment Station has conducted several hundred experiments on the fields over the state during the past few years. It is the purpose of this bulletin to give you the information gathered from these experiments along with other pointers to help you in your fertilizer program
Predicting the movements of permanently installed electrodes on an active landslide using time-lapse geoelectrical resistivity data only
If electrodes move during geoelectrical resistivity monitoring and their new positions are not incorporated in the inversion, then the resulting tomographic images exhibit artefacts that can obscure genuine time-lapse resistivity changes in the subsurface. The effects of electrode movements on time-lapse resistivity tomography are investigated using a simple analytical model and real data. The correspondence between the model and the data is sufficiently good to be able to predict the effects of electrode movements with reasonable accuracy. For the linear electrode arrays and 2D inversions under consideration, the data are much more sensitive to longitudinal than transverse or vertical movements. Consequently the model can be used to invert the longitudinal offsets of the electrodes from their known baseline positions using only the time-lapse ratios of the apparent resistivity data. The example datasets are taken from a permanently installed electrode array on an active lobe of a landslide. Using two sets with different levels of noise and subsurface resistivity changes, it is found that the electrode positions can be recovered to an accuracy of 4 % of the baseline electrode spacing. This is sufficient to correct the artefacts in the resistivity images, and provides for the possibility of monitoring the movement of the landslide and its internal hydraulic processes simultaneously using electrical resistivity tomography only
Recommended from our members
Measles vaccination and antibody response in autism spectrum disorder
OBJECTIVE: To test the hypothesis that measles vaccination was involved in the pathogenesis of autism spectrum disorders (ASD) as evidenced by signs of a persistent measles infection or abnormally persistent immune response shown by circulating measles virus or raised antibody titres in children with ASD who had been vaccinated against measles, mumps and rubella (MMR) compared with controls. DESIGN: Case-control study, community based. METHODS: A community sample of vaccinated children aged 10-12 years in the UK with ASD (n = 98) and two control groups of similar age, one with special educational needs but no ASD (n = 52) and one typically developing group (n = 90), were tested for measles virus and antibody response to measles in the serum. RESULTS: No difference was found between cases and controls for measles antibody response. There was no dose-response relationship between autism symptoms and antibody concentrations. Measles virus nucleic acid was amplified by reverse transcriptase-PCR in peripheral blood mononuclear cells from one patient with autism and two typically developing children. There was no evidence of a differential response to measles virus or the measles component of the MMR in children with ASD, with or without regression, and controls who had either one or two doses of MMR. Only one child from the control group had clinical symptoms of possible enterocolitis. CONCLUSION: No association between measles vaccination and ASD was shown
Characterising sand and gravel deposits using electrical resistivity tomography (ERT) : case histories from England and Wales
Electrical Resistivity Tomography (ERT) is a rapidly developing geophysical imaging technique that is now widely
used to visualise subsurface geological structure, groundwater and lithological variations. It is being increasingly used
in environmental and engineering site investigations, but despite its suitability and potential benefits, ERT has yet to
be routinely applied by the minerals industry to sand and gravel deposit assessment and quarry planning. The
principal advantages of ERT for this application are that it is a cost-effective non-invasive method, which can provide
2D or 3D spatial models of the subsurface throughout the full region of interest. This complements intrusive sampling
methods, which typically provide information only at discrete locations. Provided that suitable resistivity contrasts are
present, ERT has the potential to reveal mineral and overburden thickness and quality variations within the body of
the deposit.
Here we present a number of case studies from the UK illustrating the use of 2D and 3D ERT for sand and gravel
deposit investigation in a variety of geological settings. We use these case studies to evaluate the performance of ERT,
and to illustrate good practice in the application of ERT to deposit investigation. We propose an integrated approach
to site investigation and quarry planning incorporating both conventional intrusive methods and ERT
Soil Survey of Iowa, Report No. 76—Hancock County Soils
Hancock County is located in north central Iowa in the second tier of counties south of the Minnesota state line and in the middle tier of counties from east to west in the state. It lies entirely in the Wisconsin drift soil area, and hence its soils are all of drift or glacial origin
Jointly reconstructing ground motion and resistivity for ERT-based slope stability monitoring
Electrical resistivity tomography (ERT) is increasingly being used to investigate unstable slopes and monitor the hydrogeological processes within. But movement of electrodes or incorrect placement of electrodes with respect to an assumed model can introduce significant resistivity artefacts into the reconstruction. In this work, we demonstrate a joint resistivity and electrode movement reconstruction algorithm within an iterative Gauss–Newton framework. We apply this to ERT monitoring data from an active slow-moving landslide in the UK. Results show fewer resistivity artefacts and suggest that electrode movement and resistivity can be reconstructed at the same time under certain conditions. A new 2.5-D formulation for the electrode position Jacobian is developed and is shown to give accurate numerical solutions when compared to the adjoint method on 3-D models. On large finite element meshes, the calculation time of the newly developed approach was also proven to be orders of magnitude faster than the 3-D adjoint method and addressed modelling errors in the 2-D perturbation and adjoint electrode position Jacobian
'Spillout' effect in gold nanoclusters embedded in c-Al2O3(0001) matrix
Gold nanoclusters are grown by 1.8 MeV Au^\sup{2+} implantation on
c-Al\sub{2}O\sub{3}(0001)substrate and subsequent air annealing at temperatures
1273K. Post-annealed samples show plasmon resonance in the optical (561-579 nm)
region for average cluster sizes ~1.72-2.4 nm. A redshift of the plasmon peak
with decreasing cluster size in the post-annealed samples is assigned to the
'spillout' effect (reduction of electron density) for clusters with ~157-427
number of Au atoms fully embedded in crystalline dielectric matrix with
increased polarizability in the embedded system.Comment: 14 Pages (figures included); Accepted in Chem. Phys. Lett (In Press
Adaptive time-lapse optimized survey design for electrical resistivity tomography monitoring
Adaptive optimal experimental design methods use previous data and results to guide the choice and design of future experiments. This paper describes the formulation of an adaptive survey design technique to produce optimal resistivity imaging surveys for time-lapse geoelectrical monitoring experiments. These survey designs are time-dependent and, compared to dipole–dipole or static optimized surveys that do not change over time, focus a greater degree of the image resolution on regions of the subsurface that are actively changing. The adaptive optimization method is validated using a controlled laboratory monitoring experiment comprising a well-defined cylindrical target moving along a trajectory that changes its depth and lateral position. The algorithm is implemented on a standard PC in conjunction with a modified automated multichannel resistivity imaging system. Data acquisition using the adaptive survey designs requires no more time or power than with comparable standard surveys, and the algorithm processing takes place while the system batteries recharge. The results show that adaptively designed optimal surveys yield a quantitative increase in image quality over and above that produced by using standard dipole–dipole or static (time–independent) optimized surveys
- …