Long run real exchange rate determinants: evidence from eight new member states, 1993-2003

In this paper, we estimate bilateral equilibrium real exchange rates for a group of eight new eu member states against the euro, using new and sophisticated panel-cointegration techniques. We document a stable significant positive link between productivity levels and the corresponding real exchange rate levels and a stable significant and negative link between openness and the real exchange rate. We find real exchange rate misalignments to be small and weakly mean-reverting. In the context of entry into erm-ii and emu for most of these countries over time, the results stress the importance of allowing countries to adjust to inflation pressure and real exchange rate appreciation, either through nominal appreciation or temporarily higher domestic inflation. Journal of comparative economics35 (1) (2007) 87–107

HST Snapshot Survey of Post-AGB Objects

The results from a Hubble Space Telescope (HST) snapshot survey of post-AGB objects are shown. The aim of the survey is to complement existing HST images of PPN and to connect various types of nebulosities with physical and chemical properties of their central stars. Nebulosities are detected in 15 of 33 sources. Images and photometric and geometric measurements are presented. For sources with nebulosities we see a morphological bifurcation into two groups, DUPLEX and SOLE, as previous studies have found. We find further support to the previous results suggesting that this dichotomy is caused by a difference in optical thickness of the dust shell. The remaining 18 sources are classified as stellar post-AGB objects, because our observations indicate a lack of nebulosity. We show that some stellar sources may in fact be DUPLEX or SOLE based on their infrared colors. The cause of the differences among the groups are investigated. We discuss some evidence suggesting that high progenitor-mass AGB stars tend to become DUPLEX post-AGB objects. Intermediate progenitor-mass AGB stars tend to be SOLE post-AGB objects. Most of the stellar sources probably have low mass progenitors and do not seem to develop nebulosities during the post-AGB phase and therefore do not become planetary nebulae.Comment: 21 pages, 11 figure

Speckle interferometry and radiative transfer modelling of the Wolf-Rayet star WR 118

WR 118 is a highly evolved Wolf-Rayet star of the WC10 subtype surrounded by a permanent dust shell absorbing and re-emitting in the infrared a considerable fraction of the stellar luminosity. We present the first diffraction-limited 2.13micron speckle interferometric observations of WR 118 with 73 mas resolution. The speckle interferograms were obtained with the 6m telescope at the Special Astrophysical Observatory. The two-dimensional visibility function of the object does not show any significant deviation from circular symmetry. The visibility curve declines towards the diffraction cut-off frequency to 0.66 and can be approximated by a linear function. Radiative transfer calculations have been carried out to model the spectral energy distribution, given in the range of 0.5-25micron, and our 2.13micron visibility function, assuming spherical symmetry of the dust shell. Both can be fitted with a model containing double-sized grains (``small'' and ``large'') with the radii of a = 0.05micron and 0.38micron, and a mass fraction of the large grains greater than 65%. Alternatively, a good match can be obtained with the grain size distribution function n(a)~a^-3, with a ranging between 0.005micron and 0.6micron. At the inner boundary of the modelled dust shell (angular diameter (17 +/- 1)mas), the temperature of the smallest grains and the dust shell density are 1750K +/- 100K and (1 +/- 0.2)x10^-19 g/cm^3, respectively. The dust formation rate is found to be (1.3 +/- 0.5)x10^-7 Msol/yr assuming Vwind = 1200 km/s.Comment: 6 pages including 4 PostScript figures, also available from http://www.mpifr-bonn.mpg.de/div/ir-interferometry/publications.html; accepted for publication in Astronomy & Astrophysic

Proton Motive Force-Dependent Hoechst 33342 Transport by the ABC Transporter LmrA of Lactococcus lactis

The fluorescent compound Hoechst 33342 is a substrate for many multidrug resistance (MDR) transporters and is widely used to characterize their transport activity. We have constructed mutants of the adenosine triphosphate (ATP) binding cassette (ABC)-type MDR transporter LmrA of Lactococcus lactis that are defective in ATP hydrolysis. These mutants and wild-type LmrA exhibited an atypical behavior in the Hoechst 33342 transport assay. In membrane vesicles, Hoechst 33342 transport was shown to be independent of the ATPase activity of LmrA, and it was not inhibited by orthovanadate but sensitive to uncouplers that collapse the proton gradient and to N,N'-dicyclohexylcarbodiimide, an inhibitor of the F0F1-ATPase. In contrast, transport of Hoechst 33342 by the homologous, heterodimeric MDR transporter LmrCD showed a normal ATP dependence and was insensitive to uncouplers of the proton gradient. With intact cells, expression of LmrA resulted in an increased rate of Hoechst 33342 influx while LmrCD caused a decrease in the rate of Hoechst 33342 influx. Cellular toxicity assays using a triple knockout strain, i.e., L. lactis ΔlmrA ΔlmrCD, demonstrate that expression of LmrCD protects cells against the growth inhibitory effects of Hoechst 33342, while in the presence of LmrA, cells are more susceptible to Hoechst 33342. Our data demonstrate that the LmrA-mediated Hoechst 33342 transport in membrane vesicles is influenced by the transmembrane pH gradient due to a pH-dependent partitioning of Hoechst 33342 into the membrane.

Visual product architecture modelling for structuring data in a PLM system

Part 8: Formalization for PLMInternational audienceThe goal of this paper is to determine the role of a product architecture model to support communication and to form the basis for developing and maintaining information of product structures in a PLM system. This paper contains descriptions of a modelling tool to represent a product architecture in a company to support the development of a family of products, as well as the reasons leading to the use of the specific model and its terminology. The fundamental idea for using the architecture model is that an improved understanding of the whole product system, will lead to better decision making. Moreover, it is discussed how the sometimes intangible elements and phenomena within an architecture model can be visually modeled in order to form the basis for a data model in a PLM system