5,019 research outputs found
Estimated accuracy of ground-based liquid water measurements during FIRE
Since on goal of the First ISCCP Regional Experiment (FIRE) project is to improve our understanding of the relationships between cloud microphysics and cloud reflectivity, it is important that the accuracy of remote liquid measurements by microwave radiometry be thoroughly understood. The question is particularly relevant since the uncertainty in the absolute value of the radiometric liquid measurement is greatest at low liquid water contents (less than 0.1 mm). However it should be stressed that although uncertainty exists in the absolute value of liquid, it is well known that the observed radiometric signal is proportional to the amount of liquid in the antenna beam. As a result, changes in amounts of liquid are known to greater accuracy than the absolute value, which may contain a bias. Here, an assessment of the liquid measurement accuracy attained at San Nicolas Island (SNI) is presented. The vapor and liquid water data shown were computed from the radiometric brightness temperatures using statistical retrieval algorithms. The retrieval coefficients were derived from the 69 soundings made by Colorado State University during the SNI observations. Sources of error in the vapor and liquid measurements include cross-talk in the retrieval algorithms (not a factor at low liquid contents), uncertainties in the brightness temperature measurement, and uncertainties in the vapor and liquid attenuation coefficients. The relative importance of these errors is discussed. For the retrieval of path-integrated liquid water, the greatest uncertainty is caused by the temperature dependence of the absorption at microwave frequencies. As a result, the accuracy of statistical retrieval of liquid depends to large measure upon how representative the a priori radiosonde data are of the conditions prevailing during the measurements. The microwave radiometer measurements at SNI were supplemented by an infrared (IR) radiometer modified for measurement of cloud-base temperature. Thus, the IR system provides the means to incorporate continuous measurements of the liquid temperature into the retrieval process
Intergenerational Narratives: The Personal is Professional
What began as a teacher-student relationship between educators Amy Brook Snider and Jodi Kushins has developed into a friendship and working partnership. At first, they did not consider their continuing long-distance connection as intergenerational. They shared experiences and exchanged ideas oblivious to the great difference in their ages. But as online tools, research, and communication emerged as a central focus of Jodi’s life and teaching, they became aware that this development might lead to an intergenerational digital divide between them. In order to explore their different responses to what has been called screen culture, they brought back their puppet alter egos for a presentation-cum-puppet show at the National Art Education Association conference in Chicago in 2016. This paper traces the history of the shifting relationship of two art educators, along with an extended excerpt from the script for their second puppet show
Inhomogeneities of stratocumulus liquid water
There is a growing body of observational evidence on inhomogeneous cloud structure, most recently from the extensive measurements of the FIRE field program. Knowledge of cloud structure is important because it strongly influences the cloud radiative properties, one of the major factors in determining the global energy balance. Current atmospheric circulation models use plane-parallel radiation, so that the liquid water in each gridbox is assumed to be uniform, which gives an unrealistically large albedo. In reality cloud liquid water occupies only a subset of each gridbox, greatly reducing the mean albedo. If future climate models are to treat the hydrological cycle in a manner consistent with energy balance, a better treatment of cloud liquid is needed. FIRE concentrated upon two cloud types of special interest: cirrus and marine stratocumulus. Cirrus tend to be high and optically thin, thus reducing the effective radiative temperature without increasing the albedo significantly, leading to an enhanced greenhouse heating. In contrast, marine stratocumulus are low and optically thick, thus producing a large increase in reflected radiation with a small change in emitted radiation, giving a net cooling which could potentially mitigate the expected greenhouse warming. The FIRE measurements in California stratocumulus during June and July of 1987 show variations in cloud liquid water on all scales. Such variations are associated with inhomogeneous entrainment, in which entrained dry air, rather than mixing uniformly with cloudy air, remains intact in blobs of all sizes, which decay only slowly by invasion of cloudy air. Two important stratocumulus observations are described, followed by a simple fractal model which reproduces these properties, and finally, the model radiative properties are discussed
Observed cloud reflectivities and liquid water paths: An update
The FIRE microwave radiometer observations of liquid water path from San Nicolas Island and simultaneous NOAA AVHRR observations of cloud reflectivity were used to test a relationship between cloud liquid water path and cloud reflectivity that is often used in general circulation climate models (Stephens, 1978). The results of attempts to improve the data analysis which was described at the previous FIRE Science Team Workshop and elsewhere (Coakley and Snider, 1989) are reported. The improvements included the analysis of additional satellite passes over San Nicolas and sensitivity studies to estimate the effects on the observed reflectivities due to: (1) nonzero surface reflectivities beneath the clouds; (2) the anisotropy of the reflected radiances observed by the AVHRR; (3) small scale spatial structure in the liquid water path; and (4) adjustments to the calibration of AVHRR
Dependence of marine stratocumulus reflectivities on liquid water paths
Simple parameterizations that relate cloud liquid water content to cloud reflectivity are often used in general circulation climate models to calculate the effect of clouds in the earth's energy budget. Such parameterizations have been developed by Stephens (1978) and by Slingo and Schrecker (1982) and others. Here researchers seek to verify the parametric relationship through the use of simultaneous observations of cloud liquid water content and cloud reflectivity. The column amount of cloud liquid was measured using a microwave radiometer on San Nicolas Island following techniques described by Hogg et al., (1983). Cloud reflectivity was obtained through spatial coherence analysis of Advanced Very High Resolution Radiometer (AVHRR) imagery data (Coakley and Beckner, 1988). They present the dependence of the observed reflectivity on the observed liquid water path. They also compare this empirical relationship with that proposed by Stephens (1978). Researchers found that by taking clouds to be isotropic reflectors, the observed reflectivities and observed column amounts of cloud liquid water are related in a manner that is consistent with simple parameterizations often used in general circulation climate models to determine the effect of clouds on the earth's radiation budget. Attempts to use the results of radiative transfer calculations to correct for the anisotropy of the AVHRR derived reflectivities resulted in a greater scatter of the points about the relationship expected between liquid water path and reflectivity. The anisotropy of the observed reflectivities proved to be small, much smaller than indicated by theory. To critically assess parameterizations, more simultaneous observations of cloud liquid water and cloud reflectivities and better calibration of the AVHRR sensors are needed
An eight-month climatology of marine stratocumulus cloud fraction, albedo, and integrated liquid water
As part of the FIRE/Extended Time Observations (ETO) program, extended time observations were made at San Nicolas Island (SNI) from March to October, 1987. Hourly averages of air temperature, relative humidity, wind speed and direction, solar irradiance, and downward longwave irradiance were recorded. The radiation sensors were standard Eppley pyranometers (shortwave) and pyrgeometers (longwave). The SNI data were processed in several ways to deduce properties of the stratocumulus covered marine boundary layer (MBL). For example, from the temperature and humidity the lifting condensation level, which is an estimate of the height of the cloud bottom, can be computed. A combination of longwave irradiance statistics can be used to estimate fractional cloud cover. An analysis technique used to estimate the integrated cloud liquid water content (W) and the cloud albedo from the measured solar irradiance is also described. In this approach, the cloud transmittance is computed by dividing the irradiance measured at some time by a clear sky value obtained at the same hour on a cloudless day. From the transmittance and the zenith angle, values of cloud albedo and W are computed using the radiative transfer parameterizations of Stephens (1978). These analysis algorithms were evaluated with 17 days of simultaneous and colocated mm-wave (20.6 and 31.65 GHz) radiometer measurements of W and lidar ceilometer measurements of cloud fraction and cloudbase height made during the FIRE IFO. The algorithms are then applied to the entire data set to produce a climatology of these cloud properties for the eight month period
Observations of attenuation at 20.6, 31.65 and 90.0 GHz: Preliminary results from Wallops Island, VA
Ground based radiometric observations of atmospheric attenuation at 20.6, 31.65, and 90.0 GHz were made at Wallops Island, Virginia during April and May 1989. Early results from the analysis of the data set are compared with previous observations from California and Colorado. The relative attenuation ratios observed at each frequency during clear, cloudy, and rainy conditions are shown. Plans for complete analysis of the data are described
Multidimensional measurement within adult protective services: design and initial testing of the tool for risk, interventions, and outcomes.
This study describes the development, field utility, reliability, and validity of the multidimensional Tool for Risk, Interventions, and Outcomes (TRIO) for use in Adult Protective Services (APS). The TRIO is designed to facilitate consistent APS practice and collect data related to multiple dimensions of typical interactions with APS clients, including the investigation and assessment of risks, the provision of APS interventions, and associated health and safety outcomes. Initial tests of the TRIO indicated high field utility, social worker "relevance and buy-in," and inter-rater reliability. TRIO concurrent validity was demonstrated via appropriate patterns of TRIO item differentiation based on the type of observed confirmed abuse or neglect; and predictive validity was demonstrated by prediction of the risk of actual APS recurrence. The TRIO is a promising new tool that can help meet the challenges of providing and documenting effective APS practices and identifying those at high risk for future APS recurrence
Application of a Variable Path Length Repetitive Process Control for Direct Energy Deposition of Thin-Walled Structures
Direct Energy Deposition (DED) Additive Manufacturing is Well Suited to Fabricating Large Thin-Walled Metal Structures Such as Rocket Nozzles but Suffers from Layer-To-Layer Defect Propagation. Propagating Defects May Exhibit as Slumping or a Ripple in Bead Geometry. Recent Works Have Used Repetitive Process Control (RPC) Methods for Additive Manufacturing to Stabilize the Layer-Wise Defect Propagation, But These Methods Require Repetition of the Same Path. However, Typical Thin-Wall DED Applications, Sometimes Referred to as Vase Structures, Have Changing Paths with Each Layer Such as Expanding or Contracting Diameters and Changing Profiles. This Paper Presents an Extension to Optimal RPC that Uses a Geometric Mapping Method in the Learning Algorithm to Project Previous Layer Defects onto the Current Layer, Even When Paths Are of Differing Profile and Length. the Novel Method is Implemented on a DED System and Sample Parts with Layer-Changing Geometry Are Printed. the Experimental Results Demonstrate that the Method is Capable of Stabilizing the Layer-To-Layer Ripple Instability and Producing Parts of Good Quality
- …